Birtley-LOGO

Birtley TF70 Timber Frame Lintels

Birtley-TF70-Timber-Frame-Lintels-PRODUCT

Product Usage Instructions

To ensure proper installation and use of the TF70 Standard Cavity Wall Lintel, please follow these steps:

  • Step 1: Preparation
    • Check that the cavity size matches the lintel requirements. Ensure the fair-faced masonry is ready for installation.
  • Step 2: Installation
    • Use a pinch batten during installation. Follow the specific installation requirements provided by the manufacturer.
  • Step 3: Final Checks
    • After installation, verify that the lintel is securely in place and properly aligned with the outer leaf of the cavity wall.

FAQs

  • Q: Can this lintel be used for cavity walls with different sizes?
    • A: Yes, other cavity sizes are available. Please ensure to select the appropriate lintel size for your specific cavity wall dimensions.
  • Q: What is the material used for the TF70 lintel?
    • A: The TF70 lintel is made of Mild Steel S275JR according to BS EN10025-2:2004 standards.

PRODUCT SPECIFICATION

Brand Birtley
Generic Ref TF70
Product Range Timber Frame Lintels
Product Sub-range 70-85mm Cavity
Product Type Standard Duty Timber Frame Lintel – 100mm Outer Leaf
European Standard/ETA BS EN845-2:2013+A1:2016
Test Standard EN846-9:2000/2016
Notified Body Lucideon Ltd (NB 1289)
Material Mild Steel S275JR to BS EN10025-2:2004
Coating/Finish/Colour 65µm Hot Dip Galvanized to BS EN ISO 1461:2009
Thermal Performance Contact us for information
Insulation Expanded Polystyrene – BREEAM rating A+
Fire Rating 60 mins (with 2 coat plaster finish)
1. Installation requirement Bed fully on bricklaying mortar
2. Installation requirement Must be used with a cavity tray – External walls only
3. Installation requirement Use lintel clips at <600mm intervals, not more than 225mm from each end
4. Installation requirement Lintels over 1200mm must be propped until masonry is fully loaded and cured.
5. Installation requirement 150mm Minimum end Bearing
Sales Qty 1
Packaging weight 0
1. Features Supergalv coating offers superior life expectancy
2. Features Post-fabrication galvanizing leaves no surface with inferior paint protection
3. Features Structural grade steel to EN10025
Option 1 Alternative material options: Ultragalv coating (150µm), Stainless Steel 1.4301 (304)
 
Option 2 Outer Leaf Options: No rainwater drip (ND), Render mesh (MF)

PRODUCT INFORMATION

TF70

Standard Cavity Wall Lintel

100mm – Fair-faced masonry. Pinch batten must be used. Other cavity sizes available.

Features

  • We are the only lintel manufacturer to hot-dip galvanize after fabrication providing up to 50% more zinc protection than other approved coatings
  • Supergalv coating offers a superior life expectancy
  • Post-fabrication galvanizing leaves no surface with inferior paint protection

MORE INFORMATION

TF70

Documents / Resources

Birtley TF70 Timber Frame Lintels [pdf] Instructions
TF70, TF70 Timber Frame Lintels, Timber Frame Lintels, Frame Lintels, Lintels

References

Leave a comment

Your email address will not be published. Required fields are marked *