Berkeley BLUESLEUTH Bluetooth Skimmer Locator
Quick Start User Guide
 |
UNPACKING BlueSleuth ships with a charging dock, AC adapter, omni-directional and direction finding SMA antenna and receiver all in a hard carrying case. |
 |
POWERING UP/DOWN BlueSleuth only has one physical button on the front of unit. Press this white button to power up and hold it down for 3 seconds to power down. |
 |
CHARGING BlueSleuth ships with an AC powered charging dock. Place unit in charging dock and be sure the red LED on top of unit in ON. If red LED is not ON, BlueSleuth is not being charged. Try adjusting BlueSleuth in dock until red LED is ON. Charging takes approximately 4-5 hours. BlueSleuth runs approximately 16 hours on a full charge. BlueSleuth may also be operated while it is charging. BlueSleuth has smart trickle charging circuity that is always calibrating the battery but if your battery runtime is noticeably short after a full charge, you may need to manually calibrate the battery. Go to BATTERY under MAIN MENU for more details and consult BVS support. |
 |
OPERATION BlueSleuth contains 2 independent modules constantly scanning for all nearby bluetooth and bluetooth low energy devices. When BlueSleuth pairs to a BT device, the unit may begin to perform true direction finding of that device. For BLE devices that do not allow for full connection or pairing, BlueSleuth allows for basic signal strength measurement. When first scanning an area for all nearby bluetooth devices, the included omni-directional antenna is recommended. Once all nearby bluetooth devices have been detected, direction finding can be performed by replacing the omni-directional antenna with the directional antenna. For more information on typical detection ranges and environments, see included BlueSleuth data sheet or consult your BVS sales engineer. |
Documents / Resources
 |
Berkeley BLUESLEUTH Bluetooth Skimmer Locator [pdf] User Guide BLUESLEUTH Bluetooth Skimmer Locator, BLUESLEUTH, Bluetooth Skimmer Locator, Skimmer Locator, Locator |
