BEMIS HH115 Single Hinge Installation Guide

BEMIS HH115 Single Hinge Installation Guide

Product Specifications

• Tools Needed: 5/8 (16 mm) wrench
• Cleaning Instructions: Clean only with mild cleaners using a soft, damp cloth, & towel dry.
• Contact for Support: 888.722.6488 | ToiletSeats.com

Product Usage Instructions

Installation

1. Finger tighten component (B) to the underside of the bowl.
2. Adjust the seat front to back for proper fit.
3. Hold the seat centered on the bowl and tighten component (B) until lower portions snap off to prevent over-tightening.

Care & Cleaning

Use mild cleaners with a soft, damp cloth to clean the product.
Towel dry after cleaning. Avoid harsh chemicals like bleach.

Removal

To remove, use any 5/8 wrench to loosen the nut.

Tools Needed

5/8″ (16 mm)

Hardware Kit Includes

Installation

1. Remove hinge cap (C).
2. Insert (A) with arrows as shown.
3. Place seat on bowl.
4. Finger tighten (B) to the underside of the bowl.
5. Adjust the seat front to back for proper fit.
6. Holding the seat centered on the bowl, tighten (B) until lower portions SNAP OFF to prevent over-tightening and will NEVER LOOSEN.
7. Firmly push (C) onto the hinge.

Care & Cleaning

NO HARSH CHEMICALS

Clean only with mild cleaners using a soft, damp cloth, & towel dry.

REMOVAL

Remove the nut with any 5/8″ wrench

FAQs

Q: Can I use bleach or harsh chemicals to clean the product?

A: No, it is recommended to clean only with mild cleaners using a soft, damp cloth and towel dry.