FAQ
Q: What is the maximum speed supported by the R50C Motor Driven Roller Controller?
A: The controller supports a maximum speed of 164 feet per minute (ft/m).
Q: Can I use the R50C with other non-integrated rollers?
A: The R50C is designed for use with compatible integrated control rollers. For other rollers, additional adapters or configurations may be required.
Product Information
The R50C Motor Driven Roller Controller is a compact plug-and-play control unit designed for motor-driven roller systems. It offers precise control with 2 discrete outputs and 1 analog 0-18 V output. The controller is Modbus compatible and features a variety of connectors for easy installation and setup.
Compact Plug-and-Play Motor Driven Roller Control
- Easily control motor driven rollers from a PLC using Modbus® communication
- Simplify installation of multiple R50C’s on a conveyor using standard A-coded M12 connectors for signals and L-coded M12 connectors for daisy chaining up to 16 amps of motor power
- Can be used in refrigerated, wet, and other challenging environments with IP67-rated fully sealed housing and -40° to 70° C operating range without an additional protective enclosure
- Monitor status and troubleshoot with ease via LED indicators
Function Control Connectors Model
|
2 discrete outputs and 1 analog 0-18 V output |
Modbus |
1 Pair: 5-pin M12 A-Code male quick-disconnect connector (power/comms) 5-pin M12 A-Code female quick-disconnect connector (MDR control)
and 1 Pair: 5-pin M12 L-Code male quick-disconnect connector (motor power) 5-pin M12 L-Code female quick-disconnect connector (motor power) |
R50C-L-B22AOU-MQ |
Specifications
- Supply Voltage
- A-Code: 12 to 30 V DC at 400 mA maximum
- L-Code: 24 V DC +/- 10% at 16 A maximum
- Construction
- Coupling Material: Nickel-plated brass
- Connector Body: PVC translucent black
- Operating Conditions –40 to +70 °C
- Environmental Rating
IP65, IP67, IP68 - Certifications
Compatible Integrated Control Rollers
- Itoh Denki PM – XC
- Itoh Denki PM – XE, XP
- Interroll EC310
- Interroll EC5000
- Lenze MDR o450
- PulseRoller Senergy IDC
- Rulmeca BL3
Accessories
Installation
- Ensure power is disconnected before installation.
- Connect the appropriate connectors based on the system requirements using the provided quick-disconnect connectors.
- Mount the controller in a suitable location near the motor-driven rollers.
Configuration
- Refer to the user manual for detailed configuration instructions.
- Set the desired speed and direction using the control interface on the controller.
- Test the system to ensure proper functionality.
Maintenance
- Regularly inspect the controller for any signs of damage or wear.
- Clean the connectors and surrounding area to prevent dust accumulation.
- Follow recommended maintenance schedules provided in the user manual.
Banner Engineering Corp.
1-888-373-6767 • www.bannerengineering.com
© 2024 Banner Engineering Corp. Minneapolis, MN USA
Documents / Resources
 |
BANNER R50C Motor Driven Roller Controller [pdf] Instruction Manual R50C Motor Driven Roller Controller, R50C, Motor Driven Roller Controller, Driven Roller Controller, Roller Controller, Controller |
