Mounting guide
SECURITY FLEX 2MP Camera
User Guide
Important warnings and safety instructions
Χ Avoid exposing the camera to shocks, high pressure or temperatures above 40° C.
Χ Avoid placing the camera near fans, ventilation or other noise sources. This will degrade audio performance.
Χ Avoid placing the camera near fans, ventilation, or other heat sources. This will degrade sensor performance.
Χ Avoid scratching or leaving fingerprints on the lens, this degrades image quality. If possible, keep the protective plastic on the lens cover during installation.
Χ Do not clean the camera with harsh detergents, gasoline or chemicals such as Acetone.
Χ Do not try to repair the unit yourself. Refer all servicing of the camera to Ava or contact a reseller.
! Prolonged use of the white LEDs may affect sensor readings.
! This product should be supplied by a Power over Ethernet (PoE) Power Sourcing Equipment (PSE) compliant with IEEE 802.3af or USB-C power source rated 5V 1.5A. The power supply should be UL-listed and marked “Limited Power Source”or “LPS”.
! The camera and the PoE PSE must be installed within the same building, as described by Environment A of the IEEE 802.3af standard. The PoE PSE must be properly grounded.
Box content
| Screw dimensions dh = 9.4 mm l = 32 mm d = 4 mm |
Anchor dimensions l = 25 mm d= Ø6mm / ¼ ” |
Required:
PH2 screw driver Drill with 6mm (1/4”) drill bit”
Cable routing alternatives
Installing the bracket
Attaching the camera and connecting the ethernet cable
Adjusting the ball joint and video stream
Documents / Resources
 |
AVA SECURITY FLEX 2MP Camera [pdf] User Guide FLEX 2MP Camera, FLEX, 2MP Camera, Camera |