Autonomous Levitate2 Smart Desk

CAUTION
READ AND FOLLOW ASSEMBLY INSTRUCTIONS CAREFULLY BEFORE USE.

INCLUDED PARTS

ASSEMBLY GUIDE

COLUMN ASSEMBLY

UPRIGHT DESK FRAME

DESK LEG WIRING

1. Secure all connections with 32 screws A, then tighten with wrench G
2. Connect the connectors on Columns A & B through the Short Crossbeam

Note: After connecting, place the cable and cable head into the Crossbeam

DESK LEG WIRING

Connect the connectors on Columns C & D through the Short Crossbeam
Connect 2 Motor Cords & Keypad Cord to Column B, then connect 2 Motor Cords to Column C through Long Crossbeam 2

Note: After connecting, place the cable and cable head into the Crossbeam

SPLITTER ATTACHMENT

CABLE TRAY ASSEMBLY

1. Insert 2 screws B. but tighten them halfway
2. Attach the Cable Tray with 2 screws B (Step 1)
3. Tighten 2 screws B (Step 1)

CABLE MANAGEMENT

1. Connect the Keypad & Power Cord End to the Control Box, then plug the Power Cord Head into the extension socket
2. Connect the 4 Motor Connectors to the Control Box

DESK POSITIONING

1. Unbox the desk top and place it on the frame, aligning the surface with the screw holes
2. Insert 16 screws C with screwdriver

DESK & SPLITTER CONNECTION

1. Insert the Hand screw E to secure the Cable Tray
2. Use a screwdriver to attach the Splitter to the surface with 2 screws D. then connect the Sensor Connector to the Splitter
3. Use Zip Ties to organize the cables

ACCESSORY INSTALLATION

1. Put the Main Power Cord into the Upper Tube, attach the Upper Tube to the Column B
2. Attach the Cable Organizer to the Long Crossbeam 2

USER GUIDE

How to use the two buttons under your desk
Reset

• Press and hold the+ and – buttons together for 3 seconds.
• The desk will lower to its lowest position. Keep holding both buttons until you hear l beep, indicating the desk has reset (3 beeps indicate an error).
• Release the buttons after the beep to complete the reset.

Adjusting Desk Height

• To Raise the Desk
  Press and hold the + button. Release it when the desk reaches your desired height.
• To Lower the Desk
  Press and hold the – button. Release it when the desk reaches your desired height.

Memory Function
Save Memory Position 1:

• Adjust the desk to your preferred height.
• Double-click the+ button. The desk will beep to confirm.
• Double-clicking the+ button again will overwrite the previous setting.

Save Memory Position 2:

• Adjust the desk to your preferred height.
• Double-click the – button. The desk will beep to confirm.
• Double-clicking the – button again will overwrite the previous setting.

Recall Memory Positions:

• Press the + button once to move to Memory Position 1.
• Press the – button once to move to Memory Position 2.

Note: The sensor and keypad cannot be used at the same time. The control box responds to only one at a time.

Any questions?
Chat with our Customer Support team at www.autonomous.ai/help-center
We’re here to help!

Documents / Resources

Autonomous Levitate2 Smart Desk [pdf] User Guide 25mb, Levitate2 Smart Desk, Levitate2, Smart Desk, Desk

References

• User Manual