aultop ATMS6004WM WiFi Smart Meter Instruction Manual
WiFi Smart Meter
Operating Instructions
Download and Install Mobile App
Connect your phone to local Wi-Fi first.
Use your phone to scan the QR code below to
Download and install the App.
Register Account
Add New Device
Connect the device with the mains supply (100-250VAC), for connection diagrams see section 4.
Press and hold the button for about 10 seconds until the Red Led blinks fast.
Set Scheduled programs
Meter Function
The App can display:
Power (W),
Current (mA),
Voltage (V),
Daily Consumption:(KWh)
Monthly Consumption:(KWh)
Total Consumption:(KWh),
When the measured power is less than 3 W, the App displays Power(W) and Current (mA) as both “0”, but as the consumption accumulates the meter will account and measure.
Modify Device Icon
Add to Home Screen
Display item
Usage
LED Light
Relay LED indication: The LED light off means relay switch is on, the LED on means relay switch is off.
Impulse LED indication: It will flash with different speed according to the load of the meter.
Wi-Fi LED indication: Push & Hold the button for 5s The WIFI LED will flash quickly to indicate the device is in pairing mode. When Wi-Fi is connected the LED will steady on. (See point 3 in set up guide).
You can push this button to switch between different registers on the display. To reset the Wi-Fi connection Push & Hold the button for 5s. The device will enter pairing mode.
Features
- Under normal conditions of use, the life of the LCD screen is more than 10 years.
- Active energy pulse output for calibration, passive photo-electric type OC gate output port with a pulse width of 80ms±20ms.
- Single phase type multi-function smart meter designed to measure single phase 2 wire AC active energy and other parameters. APP can be used to remotely monitor readings and control ON/OFF.
- The meter has RS485 serial communication port and Wi-Fi.
- The meter is manufactured complying with international standard IEC62052-11
- Carefully open packaging and handle with care before installation.
- The meter can be installed on a 35 mm DIN rail.
- The meter should be installed in a dry area away from moisture and liquids.
- The meter’s box should be installed on a flame-resistant surface at a recommended height of about 1.8 m, where there is no corrosive gas around.
- The meter should be installed fully in accordance with the connection diagram, copper is recommended as the wire for connection. All screws should be properly tightened.
Specification
- Rated Voltage: 100-240VAC 50-60HZ
- Rated Current: 5(60)A 250VAC (Cosφ= 1)
- Contact Configuration: 1NO(SPST-NO)
- Wi-Fi Frequency: 2.4GHz
- Pulse frequency: 1200imp / kwh
- Ambient temperature range: -10°C. +60° C
- Can set 30 ON/OFF programs per day or per week.
- Can be shared with 20 users by Mobile App.
- kWh Accuracy: Class 1
- R.M.S accuracy: Class 0.5
- Pulse constant: See meter.
Connection Diagrams
Dimensions
Documents / Resources
 |
aultop ATMS6004WM WiFi Smart Meter [pdf] Instruction Manual ATMS6004WM WiFi Smart Meter, ATMS6004WM, WiFi Smart Meter, Smart Meter |
