Tenbaba 7-Inch Motorcycle CarPlay Display with TPMS

1. Safety Information

Please read all instructions carefully before installing and operating this device. Failure to follow safety guidelines may result in injury or damage to the device or motorcycle.

• Professional Installation Recommended: If you are unsure about any installation steps, seek assistance from a qualified technician.
• Power Source: Connect the device only to a 12V DC power supply. Ensure correct polarity.
• Wiring: Avoid pinching or damaging wires during installation. Secure all cables to prevent interference with motorcycle operation.
• Operation While Riding: Do not operate the device in a way that distracts you from riding. Use voice commands and pre-set functions whenever possible.
• Waterproof Rating: The device is IP69K waterproof. Ensure all ports are securely covered when not in use to maintain water resistance.

2. Package Contents

Verify that all items listed below are included in your package:

• 7-inch Motorcycle CarPlay Screen
• Magnetic Mount
• TPMS Sensors (2 units)
• User Manual
• USB Power Cable
• ACC Power Cable
• Binding Straps (x10)
• Hex Wrench
• Electrical Tape

Image 2.1: Contents of the Tenbaba Motorcycle CarPlay Display package, including the screen, mount, cables, TPMS sensors, and accessories.

3. Product Overview

The Tenbaba 7-inch Motorcycle CarPlay Display is an advanced navigation and entertainment system designed for motorcycles. It features a high-definition touchscreen, wireless CarPlay and Android Auto connectivity, real-time Tire Pressure Monitoring System (TPMS), Bluetooth 5.2, and an IP69K waterproof rating for all-weather durability.

Image 3.1: The Tenbaba 7-inch Motorcycle CarPlay Display shown mounted on a motorcycle, displaying the CarPlay interface.

4. Setup

4.1. Mounting Installation

1. Attach the bracket to your motorcycle handlebar using the provided hex wrench. Ensure it is securely fastened and does not obstruct controls.
2. Insert the connecting rod into the mount and tighten.
3. Attach the display unit to the magnetic mount. Adjust the viewing angle as desired and tighten the adjustment ring to secure its position.

Image 4.1: Visual guide showing the steps to install the Tenbaba CarPlay display mount onto a motorcycle handlebar.

4.2. Power Connection

The device supports two power connection methods:

• USB Cable: Connect the USB power cable to the device and a motorcycle USB port (if available).
• ACC Power Cable: Connect the red wire (ACC) to a switched 12V power source on your motorcycle (e.g., ignition-switched power) and the black wire (GND) to a ground point. Ensure connections are secure and insulated with electrical tape.

Image 4.2: Diagram illustrating the two power connection options: USB cable to a motorcycle USB port, and ACC power cable to the motorcycle battery (ACC and GND).

5. Operating Instructions

5.1. Powering On/Off

• Power On: The device will automatically power on when the motorcycle ignition is turned on (if connected via ACC) or when USB power is supplied.
• Power Off: The device will power off automatically when the motorcycle ignition is turned off or USB power is disconnected.

5.2. Initial Setup & Phone Pairing

1. Upon first power-on, the device will display the main interface.
2. Go to your phone's Bluetooth settings and search for available devices. Select the device name (e.g.,