BUBLUE B10P Cordless Robotic Pool Cleaner Instruction Manual

1. Introduction

The BUBLUE B10P is an advanced cordless robotic pool cleaner designed for efficient and effortless cleaning of above-ground and flat-bottom pools up to 1,076 sq. ft. Featuring upgraded Bluehole suction technology, DirtLock 2.0, and dual motors, it ensures a spotless clean with a 140-minute runtime and smart self-parking capabilities.

Figure 1: The BUBLUE B10P features advanced Bluehole Suction Technology for efficient debris removal, offering 140 minutes of runtime and a 5200 mAh battery.

2. Setup

1. Unboxing and Initial Inspection: Carefully remove all components from the packaging. Ensure all parts listed in the user manual are present.
2. Attach Brushes: Locate the two brush strips and snap them into the designated slots on the underside of the cleaner. These brushes aid in scrubbing the pool surface.
3. Attach Floating Handle/Leash: Securely tie the floating handle/leash to the designated attachment point on the top of the cleaner. This is used for safe deployment and retrieval.
4. Initial Charging: Before first use, fully charge the cleaner. Connect the charging adapter to the cleaner's charging port (located under a waterproof cap) and plug it into a power outlet. The indicator light on the charger will show red during charging and turn green when fully charged (approximately 2.5 hours).

Figure 2: The ergonomic handle allows for easy placement and retrieval of the robotic pool cleaner from the water.

Figure 3: The cleaner recharges in 2.5 hours, providing up to 140 minutes of cleaning time for pools up to 1,076 sq. ft.

3. Operating Instructions

1. Power On: Twist the power knob on top of the cleaner to the 'ON' position.
2. Submerge in Pool: Gently lower the cleaner into the pool using the floating handle/leash. Hold it submerged until all air bubbles escape and it settles on the pool floor. Ensure it lands upright.
3. Cleaning Cycle: The cleaner will automatically begin its cleaning cycle, navigating the pool floor. Its smart navigation system adjusts its path upon wall contact.
4. Auto-Parking: When the battery is low, the cleaner will automatically move to the nearest pool wall for easy retrieval. A four-color LED indicator will signal its status.
5. Retrieval: Use the floating handle/leash or the provided retrieval hook (attached to a standard pool pole) to lift the cleaner from the water. Allow excess water to drain out before removing it completely.

Figure 4: Equipped with smart navigation, the cleaner automatically parks near the pool wall when its battery is low, indicated by a four-color LED.

4. Maintenance

1. Power Off: Before cleaning, twist the power knob to the 'OFF' position.
2. Access Filter: Locate the clips on the sides of the cleaner. Unclip them to open the top cover and access the filter basket.
3. Empty Debris: Remove the filter basket and empty all collected debris.
4. Rinse Filter and Chassis: Use a garden hose to thoroughly rinse the filter and the cleaner's chassis. The DirtLock 2.0 technology ensures minimal leakage of debris during removal.
5. Reassemble: Once clean, reinsert the filter basket, close the top cover, and secure the side clips.

Figure 5: Maintenance is simple: rinse the filter and chassis with a hose after each use to remove collected debris.

Figure 6: DirtLock 2.0 technology ensures rapid water drainage in under 5 seconds with almost zero leakage, preventing debris from escaping.

5. Troubleshooting

• Cleaner Not Moving: Ensure the battery is fully charged. Check for any obstructions in the wheels or suction ports.
• Poor Suction: Clean the filter basket thoroughly. Ensure there are no blockages in the suction path.
• Short Runtime: Fully charge the battery. Battery performance may decrease over time; contact support if issues persist.
• Cleaner Stuck: Manually reposition the cleaner. Check for any large debris or uneven surfaces that might impede movement.

6. Specifications

7. Warranty and Support

The BUBLUE B10P Cordless Robotic Pool Cleaner comes with a 1-year warranty. For any questions, assistance, or support, please contact our dedicated customer service team. We are committed to ensuring your satisfaction and are here to help anytime.