Introduction
This manual provides essential information for the proper setup, operation, maintenance, and troubleshooting of your Coleman Mach 3 Plus 13,500 BTU RV Air Conditioner. Please read this manual thoroughly before installation and use to ensure safe and efficient operation of your unit.
Safety Information
Always observe basic safety precautions when installing, operating, or performing maintenance on this appliance. Failure to do so may result in property damage, personal injury, or death.
- Ensure the power supply is disconnected before any installation or maintenance procedures.
- Installation should be performed by a qualified service technician to prevent electrical hazards or damage to the unit.
- Do not operate the unit with damaged wiring or components.
- Keep all flammable materials away from the unit.
- This unit contains R-32 refrigerant. Servicing should only be performed by certified personnel.
Setup and Installation
The Coleman Mach 3 Plus RV Air Conditioner is designed for rooftop installation and fits standard 14" x 14" vent openings. Proper installation is crucial for optimal performance and safety.
Installation Overview
- The unit mounts directly to the bulkhead to prevent distortion of the blower wheel angle, ensuring free-turning action.
- Electrical connections must comply with local and national electrical codes.
- Ensure the roof structure can support the weight of the unit (approximately 85 lbs).

This image shows the exterior of the Coleman Mach 3 Plus 13,500 BTU RV Air Conditioner. The unit is black and features a slatted grille on one side for air intake/exhaust, indicating its rooftop installation design.
For detailed installation instructions, refer to the separate installation guide provided with your unit or consult a professional RV service technician.
Operating Instructions
The Coleman Mach 3 Plus provides efficient cooling for your RV. The unit operates on 115VAC 60Hz power and features button controls for operation.
Basic Operation
- Ensure the RV is connected to a suitable power source (115VAC, 60Hz).
- Locate the control panel, typically located on the ceiling assembly inside the RV.
- Use the buttons to turn the unit ON/OFF, select fan speed, and adjust the desired temperature.
- The unit delivers a solid 13,500 nominal BTU cooling capacity and 320 CFM airflow.
For specific control panel functions and advanced settings, refer to the detailed operating instructions in your unit's accompanying documentation.
Maintenance
Regular maintenance ensures the longevity and efficient performance of your Coleman Mach 3 Plus RV Air Conditioner.
Recommended Maintenance
- Filter Cleaning: Periodically clean or replace the air filters located in the ceiling assembly to maintain optimal airflow and cooling efficiency.
- Exterior Inspection: Regularly inspect the exterior shroud for any damage. The corrosion-resistant, stainless steel truss head screws secure the shroud, but ensure they remain tight.
- Drain Pan: The unit features a plastic drain pan designed to eliminate corrosion. Ensure it remains clear of debris to allow proper condensate drainage.
- Component Integrity: The unit utilizes all-copper tubing and gas-flux brazed joints for durability and long life. A sealed shaft protects against damage from the elements. While these components are designed for longevity, periodic professional inspection is recommended.
- Refrigerant Check: The system is charged with eco-friendly R-32 refrigerant. Any refrigerant-related issues or recharges must be handled by a certified HVAC technician.
Always disconnect power to the unit before performing any maintenance.
Troubleshooting
If your Coleman Mach 3 Plus RV Air Conditioner is not operating as expected, consider the following basic troubleshooting steps:
- No Power: Check the RV's circuit breakers and fuses. Ensure the unit is properly plugged in or wired to the power source.
- Poor Cooling: Verify that air filters are clean and not obstructed. Ensure all windows and doors are closed to prevent warm air from entering the RV. Check for any obstructions around the outdoor unit.
- Unusual Noise: Inspect for loose components or debris in the fan area. If the noise persists, contact a qualified technician.
- Water Leaks: Ensure the RV is level. Check the drain pan and condensate drain lines for blockages.
For complex issues or repairs, contact a qualified RV service technician. Do not attempt to repair electrical or refrigerant components yourself.
Specifications
| Feature | Specification |
|---|---|
| Model Name | 38203-0690 |
| Cooling Capacity | 13,500 BTU |
| Electrical Rating | 115VAC, 60Hz |
| Full-Load Cooling Amps | 9.4 Amps |
| Standard Running Watts | 1075 Watts |
| Air Flow Rate | 320 CFM |
| Refrigerant | R-32 |
| Profile | Medium |
| Dimensions (D x W x H) | 40.75" x 29.63" x 15.25" |
| Weight | 85 lbs |
| Noise Level | 70 dB |
| Installation Type | Rooftop (fits 14" x 14" vent openings) |
| Controller Type | Button Control |
| Operating Mode | Cooling |
| Included Components | AC Unit |
Warranty Information
The Coleman Mach 3 Plus RV Air Conditioner comes with a Limited Manufacturer's Warranty. For specific details regarding coverage, duration, and terms, please refer to the warranty card included with your product or contact Coleman Mach customer support.
Customer Support
For technical assistance, parts, or warranty inquiries, please contact Coleman Mach customer support. When contacting support, please have your model number (38203-0690) and purchase date available.
Manufacturer: Coleman Mach
Please visit the official Coleman Mach website for the most current contact information and support resources.







