Introduction
Thank you for choosing the Anmutig Patio Swivel Dining Chairs. This manual provides essential information for the safe assembly, operation, and maintenance of your new chairs. Please read these instructions carefully before beginning assembly and retain them for future reference.
Image: Anmutig Patio Swivel Dining Chairs set in an outdoor patio environment next to a swimming pool.
Safety Information
- Ensure all bolts and nuts are securely tightened before use. Periodically check and re-tighten as necessary.
- Do not exceed the maximum weight capacity of 300 lbs (136 kg) per chair.
- Keep children and pets away from the assembly area. Small parts may pose a choking hazard.
- Use on a flat, stable surface to prevent tipping.
- Avoid placing chairs near open flames or extreme heat sources.
Package Contents
Verify that all components are present before assembly. If any parts are missing or damaged, please contact customer support.
- Chair Body (4 units)
- Swivel Base Components (4 sets)
- Hardware Pack (bolts, washers, nuts, Allen wrench)
- Instruction Manual (this document)
Assembly Instructions
Assembly is designed to be straightforward. All parts are labeled. It is recommended to keep all bolts loose until the chair is fully assembled, then tighten them securely.
Image: A complete set of Anmutig Patio Dining Chairs and a table on an outdoor patio, illustrating the assembled product.
- Unpack Components: Carefully remove all parts from the packaging. Lay them out on a soft, clean surface to prevent scratches.
- Attach Swivel Mechanism: Secure the swivel mechanism to the bottom of the chair seat using the provided bolts and washers. Ensure the mechanism is oriented correctly.
- Assemble Base: Connect the base legs to the swivel mechanism. Do not fully tighten bolts at this stage.
- Attach Chair Back: Align the chair back with the seat and armrests. Insert bolts, but do not fully tighten.
- Final Tightening: Once all components are loosely assembled, place the chair upright on a flat surface. Systematically tighten all bolts and nuts using the Allen wrench. Ensure all connections are firm and secure.
- Repeat for Remaining Chairs: Follow these steps for each chair in the set.
Operating Instructions
Your Anmutig Patio Swivel Dining Chairs are designed for comfort and versatility.
Image: A diagram illustrating the 360-degree swivel movement and the 15-degree smooth rocking motion of the chair.
- 360° Swivel: The chair seat can rotate a full 360 degrees, allowing for easy movement and conversation without repositioning the entire chair.
- 15° Rocking Motion: A gentle 15-degree rocking motion is integrated for added relaxation. Lean back slightly to engage the rocking feature.
Maintenance
Proper care will extend the life and appearance of your chairs.
Image: A close-up view of the Textilene mesh fabric, highlighting its breathable and quick-drying properties with arrows indicating airflow.
- Cleaning: Wipe clean with a damp cloth. For stubborn dirt, use a mild soap solution and rinse thoroughly with water. The Textilene fabric is quick-drying.
- Frame Care: The powder-coated steel frame is rust-resistant. Avoid harsh abrasive cleaners that could damage the finish.
- Seasonal Storage: During prolonged periods of non-use or harsh weather, consider covering the chairs or storing them indoors to protect them from elements.
- Hardware Check: Periodically inspect all bolts and connections to ensure they remain tight. Re-tighten as needed.
Image: A cross-section diagram illustrating the multi-layer rust prevention of the chair frame, including powder coating, protective zinc coating, inert layer, and alloy steel.
Troubleshooting
If you encounter any issues, refer to the following common solutions:
- Chair Wobbles: Ensure all bolts are evenly tightened. If the issue persists, loosen all bolts slightly, sit in the chair to settle the frame, then re-tighten all bolts.
- Difficulty Swiveling/Rocking: Check for any obstructions around the swivel mechanism or rocking components. Ensure the chair is on a level surface.
- Missing Parts: If any parts were missing upon delivery, please contact customer support immediately for assistance.
Specifications
Image: A diagram showing the key dimensions of the Anmutig Patio Swivel Dining Chair, including height (40"), seat depth (17.7"), and width (22.8").
| Feature | Detail |
|---|---|
| Brand | Anmutig |
| Model Name | Swivel chair |
| Model Number | 001 |
| Color | Tan Grey |
| Material | Powder-Coated Steel Frame, Textilene Fabric |
| Product Dimensions (D x W x H) | 22.8" x 22.8" x 40" |
| Seat Depth | 17.7 inches |
| Item Weight (per chair) | Approx. 24.2 lbs (96.8 lbs for set of 4) |
| Maximum Weight Recommendation | 300 pounds |
| Swivel Feature | 360° Swivel |
| Rocking Feature | 15° Rocking Design |
| Additional Features | Breathable Fabric, Easy Assembly, Rust-Resistant Frame, Curved Ergonomic Armrests |
| Room Type | Balcony, Garden, Patio Garden |
Warranty and Support
Anmutig is committed to providing quality products and customer satisfaction.
- Return Policy: This product is eligible for a 30-day return policy from the date of purchase. Please refer to your retailer's return guidelines for specific details.
- Customer Support: If you encounter any problems, such as missing parts, damaged products, or require assistance with assembly or operation, please contact our customer support team. You can typically find contact information on the retailer's website or your purchase invoice.