NEBO OMNI 2K Rechargeable Work Light Instruction Manual

Introduction

The NEBO OMNI 2K is a versatile, omnidirectional LED work light designed for various tasks. It features 2000 lumens, 6 light modes, rotating magnetic handles, and a built-in power bank. It is impact and water resistant, making it suitable for tough environments. This manual provides essential information for the safe and efficient operation of your OMNI 2K work light.

What's in the Box

• NEBO OMNI 2K Work Light
• USB-C Charging Cable

Setup

1. Initial Charge: Before first use, fully charge your OMNI 2K work light using the included USB-C charging cable. Connect the USB-C end to the light's charging port (located under the protective flap) and the USB-A end to a compatible power adapter (not included). The blue LED indicators will show the charging status and battery level.
2. Familiarize Yourself: Explore the rotating magnetic handles and adjustable COB panels to understand the various positioning options for optimal illumination.

Image: The NEBO OMNI 2K Work Light with its handles extended, demonstrating its versatile design.

Operating Instructions

Powering On/Off and Mode Selection

The OMNI 2K features 6 light modes. Press the power button to cycle through the modes:

• Dual COB High: Press 1x from OFF.
• Dual COB Low: Press 2x from OFF.
• Single COB High: Press 3x from OFF.
• Single COB Low: Press 4x from OFF.
• Red COB: From OFF, press and hold the power button for 2 seconds.
• Red COB Flashing: From OFF, press and hold the power button for 2 seconds, then press the power button once more.

To turn off the light, press the power button after 8 seconds in any mode, or cycle through all modes until it turns off.

Dimming Instructions

While the light is ON (in dual, primary, or secondary COB mode):

• Press and hold the "-" button to dim. The light will blink 1x when it reaches minimum brightness.
• Press and hold the "+" button to increase brightness. The light will blink 1x when it reaches maximum brightness.
• Release the "-" or "+" button at any time to set desired brightness. If the button is still pressed, the light will continue to adjust between minimum or maximum brightness.

Memory Power Setting

After adjusting a light mode, leaving that mode on for 8 seconds and pressing the power button will set that mode to memory. From the OFF position, pressing the power button will activate your saved memory power setting.

Power Bank Functionality

The OMNI 2K features a built-in 4000mAh power bank. To use it, lift the protective flap on the back of the unit to reveal the USB-A output port. Connect your device's charging cable to this port to charge your mobile devices.

Image: The NEBO OMNI 2K Work Light being used as a power bank to charge a smartphone via its USB port.

Maintenance

• Cleaning: Wipe the light with a soft, damp cloth. Do not use abrasive cleaners or solvents.
• Storage: Store the light in a cool, dry place away from direct sunlight when not in use.
• Battery Care: For optimal battery life, recharge the unit regularly, even if not in frequent use. Avoid fully depleting the battery for extended periods.

Troubleshooting

• Light Not Turning On: Ensure the battery is charged. If the battery is low, connect the USB-C charging cable and allow it to charge.
• Charging Issues: Verify that the USB-C cable is securely connected to both the light and the power source. Try a different USB-C cable or power adapter.
• Dimming/Brightness Not Responding: Ensure the light is in a COB mode (dual, primary, or secondary). Press and hold the '+' or '-' buttons firmly.

Specifications

Warranty and Support

The NEBO OMNI 2K Work Light comes with a Lifetime Warranty, ensuring quality and durability. For product support, warranty claims, or further assistance, please visit the official NEBO website or contact their customer service.

Official NEBO Website: www.nebotools.com