GiveBest Cyber 800W Plug-in Heater MH-20 User Manual

Important Safety Instructions

Please read all safety warnings and instructions before using this product. Failure to follow the warnings and instructions may result in electric shock, fire, or serious injury.

• This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces.
• Use extreme caution when any heater is used by or near children or invalids and whenever the heater is left operating and unattended.
• Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner.
• Do not use outdoors.
• This heater is not intended for use in bathrooms, laundry areas, and similar indoor locations. Never locate heater where it may fall into a bathtub or other water container.
• Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Arrange cord away from traffic area and where it will not be tripped over.
• To disconnect heater, turn controls to off, then remove plug from outlet.
• Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater.
• To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked.
• This heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable vapors or liquids are used or stored.
• Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.
• This heater is for use on 120 Volt outlets.
• Features 158°F overheat protection.

Product Overview

The GiveBest Cyber 800W Plug-in Heater is a compact, portable electric wall heater designed for indoor use in small spaces. It features PTC ceramic heating technology for fast and efficient warmth, an adjustable thermostat, a 12-hour timer, and a remote control. Its unique 180° rotating plug allows for flexible placement without obstructing other outlets.

Video: Overview of the GiveBest Plug-in Heater. This video provides a general introduction to the product's features and design.

Key Features

• 800W PTC Fast Heat: Provides quick and comfortable warmth.
• Ultra-Quiet Operation: Upgraded brushless motor and aerodynamic fan operate under 40dB for minimal disturbance.
• Energy-Saving ECO Mode: Automatically adjusts power (400W-800W) to maintain desired temperature, optimizing energy consumption.
• Adjustable Thermostat: Temperature settings from 60°F to 90°F.
• 12-Hour Timer: Allows for scheduled operation.
• Remote Control: Conveniently adjust settings from up to 15 feet away.
• 180° Rotating Plug: Fits most standard wall outlets without blocking the second receptacle.
• Safety Features: UL & CSA certified, 158°F overheat protection, V0 flame-retardant materials.

Setup

Unboxing and Initial Inspection

Carefully remove the heater from its packaging. Inspect the unit for any signs of damage.

Plugging in the Heater

The heater is designed to plug directly into a standard 120V wall outlet.

Image: The GiveBest Cyber 800W Plug-in Heater showing its 180° rotatable wall plug design. This feature allows the heater to be oriented vertically or horizontally to fit various outlets without blocking the second receptacle.

The 3-prong plug on the back of the heater can be rotated 180 degrees to accommodate different outlet orientations. To rotate the plug, press and hold the button located on the side of the plug, then gently turn the plug to the desired position. Release the button to lock it in place.

Ensure the heater is securely plugged into a functional 120V outlet.

Operating Instructions

Powering On/Off

Locate the power switch on the side of the heater. Flip the switch to the "ON" position to power on the unit. The digital display will illuminate. To turn off, flip the switch to the "OFF" position.

Adjusting Temperature

Use the + and - buttons on the digital display or the remote control to set your desired temperature between 60°F and 90°F.

Image: Close-up of the GiveBest Cyber 800W Plug-in Heater's digital display, showing temperature controls and mode indicators.

Power Modes (P1, P2, ECO)

The heater offers different power modes to suit your heating needs:

• P1 (Low Power): Operates at 400W for gentle, continuous heat.
• P2 (Full Power): Operates at 800W for faster room heating.
• ECO Mode: Automatically switches between P1 and P2 to maintain the set temperature, optimizing energy consumption.

You can cycle through these modes using the 'M' button on the unit or the corresponding buttons on the remote control.

Setting the Timer

The heater features a 12-hour timer. Press the timer button (clock icon) on the unit or remote to set the desired operating duration. Each press will increase the timer by one hour, up to 12 hours.

Image: The GiveBest Cyber 800W Plug-in Heater with its remote control, highlighting the convenience of adjusting settings from a distance.

Remote Control

The included remote control allows you to power on/off, adjust temperature, set the timer, and change power modes from a distance of up to 15 feet. The remote requires two AAA batteries (not included).

Maintenance

Cleaning

Always unplug the heater and allow it to cool completely before cleaning. Use a soft, damp cloth to wipe the exterior surfaces. Do not use abrasive cleaners or solvents. Do not immerse the heater in water.

Storage

When not in use, store the heater in a cool, dry place.

Troubleshooting

Heater Not Turning On

• Ensure the heater is securely plugged into a working 120V outlet.
• Check if the power switch on the side of the unit is in the "ON" position.
• Verify that the outlet is receiving power by plugging in another appliance.

Heater Not Producing Heat

• Check the set temperature. Ensure it is higher than the current room temperature.
• If the heater has been running for a long time, the overheat protection may have activated. Unplug the unit, let it cool down for 30 minutes, and then plug it back in.
• Ensure the air intake and exhaust vents are not blocked.

Remote Control Not Working

• Check and replace the AAA batteries in the remote control.
• Ensure there are no obstructions between the remote and the heater's sensor.

Specifications

Warranty and Support

For any problems or inquiries, please contact GiveBest customer support.

• Email: support@Givebest.com
• Phone: US+1 (888) 550 1319

The product is backed by 24/7 customer support for a worry-free experience.