Merax Queen Size Boucle Bed Frame with Wingback Headboard User Manual

1. Introduction

Thank you for choosing the Merax Queen Size Boucle Bed Frame with Wingback Headboard. This manual provides essential information for the safe assembly, proper use, and maintenance of your new bed frame. Please read all instructions carefully before beginning assembly and retain this manual for future reference.

2. Safety Information

Important Safety Instructions:

• Always follow the assembly instructions carefully to prevent instability.
• Do not exceed the maximum weight recommendation of 500 pounds to avoid damage or injury.
• Be cautious when handling heavy components during assembly. It is recommended to assemble with two people.
• Ensure all bolts and screws are securely tightened before use. Periodically check and re-tighten as necessary.
• Keep small parts out of reach of children during assembly.
• Do not use power tools for assembly unless specifically instructed, as this may overtighten and damage components.

3. Components List

Before assembly, verify that all parts are present and undamaged. Refer to the included diagram in your package for a complete visual list of components and hardware.

• Headboard (Wingback Upholstered)
• Side Rails (Left and Right)
• Footboard
• Wooden Slats
• Center Support Leg(s)
• Walnut Wooden Legs
• Hardware Pack (bolts, washers, nuts, Allen wrench)
• Installation Manual (this document)

4. Assembly Instructions

Assembly requires two adults. Please follow the detailed, step-by-step instructions and diagrams provided in the separate installation manual included with your product packaging. The general steps are outlined below:

1. Unpack and Identify Parts: Lay out all components on a soft, clean surface to prevent scratches. Compare with the components list and hardware pack.
2. Attach Legs to Headboard and Footboard: Secure the walnut wooden legs to the headboard and footboard using the provided hardware.
3. Connect Side Rails: Attach the side rails to the headboard and footboard. Ensure all connections are firm but do not overtighten initially.
4. Install Center Support: Assemble and install any center support beams and legs as per the diagrams.
5. Place Wooden Slats: Distribute the wooden slats evenly across the frame and secure them using the designated fasteners. Ensure all slats are properly seated and secured.
6. Final Tightening: Once all components are in place, go back and securely tighten all bolts and screws.

5. Usage Guidelines

• Mattress Compatibility: This bed frame is designed for a Queen size mattress. A box spring is not required due to the sturdy wooden slat support system.
• Weight Capacity: The maximum weight capacity for this bed frame is 500 pounds, including the mattress and occupants. Do not exceed this limit.
• Placement: Position the bed frame on a level surface to ensure stability and prevent undue stress on the frame.
• Movement: When moving the bed, lift it rather than dragging it to prevent damage to the legs and frame structure.

6. Maintenance

• Cleaning the Upholstery: For routine cleaning, gently vacuum the boucle fabric headboard and frame to remove dust and debris. For spills, blot immediately with a clean, dry cloth. For stubborn stains, use a mild fabric cleaner following the product's instructions, testing on an inconspicuous area first.
• Cleaning Wooden Legs: Wipe the walnut wooden legs with a soft, damp cloth. Avoid harsh chemicals or abrasive cleaners.
• Hardware Check: Periodically (every 3-6 months) check all bolts and screws to ensure they remain tight. Re-tighten if necessary to maintain stability and safety.
• Avoid Direct Sunlight: Prolonged exposure to direct sunlight may cause the fabric to fade.

7. Troubleshooting

8. Specifications

9. Customer Support

For any questions, missing parts, or assistance with assembly, please contact Merax customer support. Refer to your purchase documentation or the Merax official website for contact information.

Online Support: Visit the Merax Store on Amazon