FEELNEEDY FN-W17 Smart Wireless Water Dispenser Head

1. Introduction

This manual provides instructions for the FEELNEEDY FN-W17 Smart Wireless Water Dispenser Head. This accessory is designed to be compatible with the FEELNEEDY FN-W17 wireless cat fountain with motion sensor. Please read these instructions carefully before use to ensure proper operation and longevity of the product.

2. Setup and Installation

Before initial use, it is recommended to fully charge the device's battery. The dispenser head is designed for easy integration with your existing FEELNEEDY FN-W17 cat fountain.

1. Charge the Battery: Ensure the integrated 4,000 mAh rechargeable battery is fully charged. The battery can be charged separately while the fountain continues to operate.
2. Position the Dispenser Head: Carefully place the smart wireless dispenser head onto the designated area of your FEELNEEDY FN-W17 cat fountain. Ensure it is securely seated to prevent water leakage and ensure proper function.

Figure 1: Illustration of the dispenser head being attached to the fountain unit.

Figure 2: View of the 4000mAh rechargeable battery inside the fountain unit.

3. Operating Modes

The FEELNEEDY FN-W17 Smart Wireless Water Dispenser Head offers three distinct operating modes to suit your pet's needs and conserve energy.

• Sensor Mode: In this mode, water flows only when your pet approaches the fountain. This intelligent detection helps save up to 30% energy by activating the water flow only when needed.
• Timer Mode: This mode provides a water flow for 20 seconds every 15 minutes. It mimics natural springs, encouraging pets, especially picky drinkers, to stay hydrated throughout the day. This mode allows for wireless operation for up to 6 weeks on a full charge.
• Continuous Operation Mode: When the fountain is plugged into a power source, it can operate continuously 24/7, providing an uninterrupted water supply.

4. Maintenance

Regular maintenance ensures the optimal performance and hygiene of your water dispenser head and fountain system.

• Cleaning: Periodically clean the dispenser head and all fountain components with mild soap and water. Rinse thoroughly to remove any residue.
• Filter Replacement: Refer to your main fountain manual for instructions on filter replacement. While this accessory is the dispenser head, maintaining the fountain's filter system is crucial for water quality.
• Battery Care: Recharge the 4,000 mAh battery as needed. For prolonged periods of non-use, store the battery in a cool, dry place and recharge it every few months to maintain its health.

5. Troubleshooting

If you encounter issues with your FEELNEEDY FN-W17 Smart Wireless Water Dispenser Head, consider the following:

• No Water Flow:
  • Check if the battery is charged.
  • Ensure the dispenser head is correctly installed and seated.
  • Verify that the water level in the fountain is sufficient.
  • Clean the pump and dispenser head for any blockages.
• Intermittent Flow (not in Timer Mode):
  • If in Sensor Mode, ensure there are no obstructions blocking the sensor.
  • Check for low battery.
• Unusual Noise:
  • Ensure the dispenser head is properly seated and not vibrating against other components.
  • Check for debris in the pump or water reservoir.

For further assistance, please contact customer support.

6. Specifications

7. Warranty and Support

For warranty information or technical support, please refer to the documentation provided with your complete FEELNEEDY FN-W17 cat fountain or visit the official FEELNEEDY website. You may also contact the seller directly for assistance.

Seller: FeelNeedy Direct

Amazon Store: Visit FEELNEEDY Store