1. Safety Information
WARNING: Read the ENTIRE instruction manual to become familiar with the features of the product before operating. Failure to operate the product correctly can result in damage to the product, personal property and cause serious injury. This is a sophisticated hobby product. It must be operated with caution and common sense and requires some basic mechanical ability. Failure to operate this Product in a safe and responsible manner could result in injury or damage to the product or other property. This product is not intended for use by children without direct adult supervision. Do not use with incompatible components or alter this product in any way outside of the instructions provided by Horizon Hobby, LLC. The product manual contains instructions for safety, operation and maintenance. It is essential to read and follow all the instructions and warnings in the manual, prior to assembly, setup or use, in order to operate correctly and avoid damage or serious injury.
2. Setup
The ARRMA 1/10 Quake 223S is a Ready-to-Run (RTR) vehicle, meaning most assembly is complete. However, a battery and charger are not included and must be acquired separately.
2.1 Required Items (Not Included)
- IC5® compatible 2S (7.4V) or 3S (11.1V) LiPo battery.
- Compatible LiPo battery charger.
This diagram illustrates the required 2S or 3S LiPo battery and a compatible charger, which are not included with the truck. It also shows the maximum battery tray dimensions.
2.2 Battery Tray Dimensions
Ensure your chosen battery fits within the maximum dimensions of the battery tray:
- Length: 140mm (5.51 inches)
- Width: 50mm (1.97 inches)
- Height: 35mm (1.38 inches)
The bottom-loading battery tray allows for quick and clipless battery swaps.
2.3 Included Components
The following items are included with your ARRMA 1/10 Quake 223S:
- QUAKE 223S BLX 2WD Monster Truck RTR
- Spektrum SLT 45A 2-in-1 Waterproof ESC & Receiver 2S/3S with DSC and Spektrum 3660 4000Kv Brushless Motor
- Spektrum SLT2 2.4GHz Transmitter
- Spektrum S681 Metal-Geared Waterproof Digital Servo
- 4- AA Transmitter Batteries
- 2mm Hex Driver and 2.5mm Hex Driver
- Wheel Wrench/Shock Tool
- Product Manual
Key electronic components included with the truck.
3. Operating Instructions
Follow these steps to operate your ARRMA Quake 223S:
- Charge the included battery using the provided charger. (Note: Battery and charger are not included with the truck and must be purchased separately.)
- Install the charged battery in the truck's bottom-loading battery tray.
- Turn on the transmitter (remote control) first, then turn on the truck.
- Use the transmitter to control the truck. The truck is 2S or 3S ready, allowing for various speed and power levels.
- Utilize the throttle limiting and Dynamic Stability Control (DSC) features on the transmitter to manage speed and maintain control, especially for new users or in challenging conditions.
- After use, turn off the truck, then the transmitter. Remove the battery from the truck and store it properly according to battery safety guidelines.
The ARRMA Quake 223S in action on a sandy surface.
The truck is designed for robust performance, including jumps.
4. Maintenance
Regular maintenance ensures the longevity and optimal performance of your ARRMA Quake 223S.
- After Each Use: Clean the truck thoroughly to remove dirt, dust, and debris. Pay attention to moving parts like suspension components, drivetrain, and steering linkages.
- Inspect for Damage: Regularly check for any loose screws, cracked plastic parts, or damaged components. Replace any broken parts immediately to prevent further damage.
- Drivetrain: The heavy-duty transmission is built for durability, but periodic inspection of gears and bearings for wear is recommended.
- Shocks: Check shock oil levels and ensure smooth operation of the suspension.
The robust transmission system requires occasional inspection.
Inspect suspension components for wear and proper function.
5. Troubleshooting
If you encounter issues with your ARRMA Quake 223S, consider the following general troubleshooting steps:
- No Power: Ensure the battery is fully charged and correctly connected. Check that both the transmitter and truck are powered on.
- Loss of Control/Interference: Verify that the transmitter batteries are fresh. Ensure no other 2.4GHz devices are causing interference. Re-bind the transmitter and receiver if necessary (refer to the full product manual for binding instructions).
- Reduced Performance: Check for debris in the drivetrain, worn gears, or a partially discharged battery. Inspect motor and ESC for signs of overheating.
- Steering Issues: Check servo connections, ensure the servo horn is securely attached, and inspect steering linkages for obstructions or damage.
For detailed troubleshooting guides and specific error codes, please refer to the comprehensive product manual included with your truck or visit the official ARRMA support website.
6. Specifications
| Feature | Detail |
|---|---|
| Brand Name | ARRMA |
| Model Name | 1/10 QUAKE 223S 2WD RTR Brushless Monster Truck, Green |
| Model Number | ARA3537T2 |
| Scale | 1/10 Scale |
| Item Dimensions (L x W x H) | 21.2 x 15.2 x 10.2 inches |
| Material Type | Plastic |
| Power Source | Battery Powered (2S or 3S LiPo, not included) |
| Maximum Speed | Up to 36 miles per hour |
| Age Range Description | Ages 14+ |
| Operation Mode | Remote Control |
| Additional Features | Weather Resistant, Dynamic Stability Control (DSC) |
The ARRMA Quake 223S is available in multiple color options.
7. Warranty and Support
Manufacturer's Warranty: This product is covered by a manufacturer's warranty. Please refer to the warranty card included in the product packaging or visit the official ARRMA website for detailed warranty terms and conditions.
Customer Support: For technical assistance, spare parts, or any other inquiries, please contact ARRMA customer support. Contact information can typically be found on the ARRMA website or in the full product manual.
You can visit the official ARRMA store for more information and products: ARRMA Store
