NACKEO N20 7000A Portable Car Jump Starter User Manual

Introduction

Thank you for choosing the NACKEO N20 Portable Car Jump Starter. This device is designed to provide a powerful and reliable solution for starting vehicles with dead batteries, offering a peak current of 7000A. It is suitable for all gasoline engines and diesel engines up to 10.0L. Beyond its primary function, the N20 also serves as a portable power bank and features a multi-mode LED flashlight for emergencies. This manual provides essential information for safe and effective operation, maintenance, and troubleshooting.

The NACKEO N20 Jump Starter connected to a vehicle battery, demonstrating its primary function of starting a discharged vehicle in seconds.

Safety Information

Always observe the following safety precautions to prevent injury or damage to the device and vehicle:

• Read all instructions carefully before use.
• Do not immerse the device in water or expose it to rain.
• Do not operate the device if it is damaged.
• Keep out of reach of children.
• Ensure proper polarity connection (red clamp to positive, black clamp to negative) to avoid short circuits.
• Do not jump start a frozen battery.
• Do not use the jump starter as a vehicle battery.
• Disconnect the clamps from the vehicle battery within 30 seconds after the vehicle starts.
• Store the device in a cool, dry place when not in use.

The NACKEO N20 features 10 layers of automatic protection, including safeguards against short circuits, overheating, overvoltage, overload, deep discharge, overcurrent, and reverse polarity, ensuring safe operation.

Package Contents

Verify that all items are present in your package:

• 1 × NACKEO N20 Car Jump Starter
• 1 × USB-C Charging Cable
• 1 × Smart Clamp Cable
• 1 × Storage Case
• 1 × User Manual

All components included in the NACKEO N20 Jump Starter package, neatly stored in the provided case.

Setup: Charging the Jump Starter

Before first use, fully charge the NACKEO N20. It is recommended to recharge the device every 3-6 months to maintain battery health, even if not in use.

1. Connect the provided USB-C charging cable to the USB-C input port on the jump starter.
2. Connect the other end of the USB-C cable to a USB wall adapter (not included) or a powered USB port.
3. The indicator lights on the jump starter will illuminate to show the charging progress. All lights will be solid when fully charged.

The NACKEO N20 supports fast charging via its USB-C input and can also function as a portable power bank to charge various devices.

Operating Instructions: Jump Starting a Vehicle

Follow these steps carefully to jump start your vehicle:

1. Prepare the Jump Starter: Ensure the jump starter is sufficiently charged. Turn off your vehicle's ignition and all accessories (lights, radio, etc.).
2. Connect Smart Clamp: Insert the smart clamp cable into the jump start port on the NACKEO N20. The red and green lights on the smart clamp will flash alternately.
3. Connect to Vehicle Battery:
   • Connect the RED clamp to the vehicle's positive (+) battery terminal.
   • Connect the BLACK clamp to the vehicle's negative (-) battery terminal.
   Once connected correctly, the smart clamp will make a "click" sound, and the green light will remain solid. If the red light is solid or flashing, check connections for reverse polarity or other issues.
4. Start the Vehicle: Within 90 seconds of a successful connection (solid green light), start your vehicle's engine. If it doesn't start immediately, wait 5 seconds before trying again. Do not attempt more than 3 consecutive starts.
5. Disconnect Clamps: Once the vehicle starts, immediately disconnect the smart clamp from the jump starter, then remove the black clamp from the vehicle battery, followed by the red clamp.

The NACKEO N20 is designed to operate reliably in extreme temperatures, from -20°C (-4°F) to 60°C (140°F).

The NACKEO N20 is compatible with a wide range of 12V vehicles, including motorcycles (up to 2.5L), cars (up to 3.5L), SUVs (up to 6.5L), and trucks (up to 9.0L), supporting all gasoline and up to 10.0L diesel engines.

Additional Functions

LED Flashlight

The NACKEO N20 features a powerful 500-lumen LED flashlight with three modes:

• Continuous Light: For general illumination.
• Strobe Light: For signaling or attracting attention.
• SOS Signal: For emergency situations.

To activate, press and hold the power button for 3 seconds. Press again to cycle through modes. Press and hold to turn off.

The integrated 500-lumen LED flashlight provides illumination for various situations, including inspecting engine components in the dark.

Portable Power Bank

The NACKEO N20 can also charge your electronic devices:

• Connect your device's USB charging cable to the USB-A output port on the jump starter.
• The jump starter will automatically begin charging your device.

The NACKEO N20 can charge multiple devices simultaneously, making it a versatile portable power bank for phones, tablets, and other USB-powered gadgets.

Maintenance

Proper maintenance ensures the longevity and reliability of your NACKEO N20 Jump Starter:

• Storage: Store the device in a cool, dry place away from direct sunlight and extreme temperatures.
• Recharging: Recharge the jump starter every 3-6 months, even if not used, to prevent deep discharge and prolong battery life.
• Cleaning: Wipe the device with a soft, dry cloth. Do not use harsh chemicals or abrasive cleaners.
• Clamp Care: Keep the smart clamps clean and free of corrosion.

Weighing only 320g and with compact dimensions (16.9 x 8.6 x 3.5 cm), the NACKEO N20 is lightweight and portable, making it easy to store and carry.

Troubleshooting

If you encounter issues, refer to the following common problems and solutions:

• Device not turning on: Ensure the device is charged. Press and hold the power button for a few seconds.
• Vehicle not starting:
  • Check that the smart clamp is securely connected to the jump starter port.
  • Verify that the clamps are connected to the correct battery terminals (red to positive, black to negative). The green light on the smart clamp should be solid.
  • Ensure the vehicle battery terminals are clean and free of corrosion.
  • The vehicle battery might be severely discharged or damaged. Consult a professional.
• Smart clamp indicator lights flashing red: This usually indicates a reverse polarity connection or a short circuit. Disconnect immediately and re-check connections.
• Jump starter not charging: Ensure the USB-C cable and wall adapter are working correctly. Try a different cable or adapter.

Specifications

Note: Specifications are subject to change without notice.

The NACKEO N20 features a high-capacity internal battery, providing ample power for multiple jump starts and device charging.

Warranty and Support

NACKEO provides professional technical support for the lifetime of this product. If you encounter any issues or have questions regarding your NACKEO N20 Jump Starter, please contact our customer service team. We aim to respond within 24 hours.

Please refer to your purchase documentation for specific warranty terms and conditions.