Homy Casa CHARLTON Set of 4 Modern Upholstered Dining Chairs Instruction Manual

Introduction

Thank you for choosing the Homy Casa CHARLTON Set of 4 Modern Upholstered Dining Chairs. This manual provides essential information for the safe assembly, proper use, and effective maintenance of your new chairs. Please read these instructions carefully before assembly and retain them for future reference.

Important Safety Information

• Always assemble the chairs on a soft, clean surface to prevent damage.
• Ensure all bolts and screws are securely tightened before use. Periodically check and re-tighten as necessary.
• Do not stand on the chairs.
• Do not exceed the maximum weight capacity of 250 pounds per chair.
• Keep small parts away from children during assembly.

Package Contents

Before beginning assembly, verify that all parts are present and undamaged. If any parts are missing or damaged, please contact customer support.

• Chair Seat with Backrest (4 units)
• Metal Legs (16 units)
• Hardware Pack (Bolts, Washers, Allen Wrench)

Figure 1: Illustration of chair components including the upholstered seat, metal legs, and protective rubber mats.

Assembly Instructions

Follow these steps to assemble each dining chair:

1. Carefully unbox all components and lay them out on a soft, flat surface to prevent scratches.
2. Identify the four metal legs for one chair. Note that the legs may have slightly different angles or lengths for front and back placement.
3. Locate the pre-drilled holes on the underside of the chair seat.
4. Attach each metal leg to the corresponding mounting point on the chair seat using the provided bolts and washers. Do not fully tighten the bolts at this stage.
5. Once all four legs are loosely attached, gently place the chair upright on a level surface.
6. Apply even pressure to the seat to ensure all legs are touching the ground. Then, using the Allen wrench, fully tighten all bolts. Ensure they are snug but do not overtighten.
7. Verify the chair is stable and does not wobble. If it wobbles, loosen the bolts slightly, adjust the chair on a flat surface, and re-tighten.
8. Repeat these steps for the remaining three chairs.

Operating and Usage

These chairs are designed for indoor use in dining rooms, kitchens, and similar settings. The contoured backrest provides ergonomic support for comfortable seating.

• Weight Capacity: Each chair has a maximum weight capacity of 250 pounds (approximately 113 kg). Do not exceed this limit.
• Floor Protection: The metal legs are equipped with anti-slip rubber mats to protect your floors from scratches and reduce noise when moving the chairs.
• Ergonomic Design: The backrest is shaped to support natural posture, enhancing comfort during extended periods of sitting.

Figure 2: Chair dimensions and maximum weight capacity.

Figure 3: Detail of the ergonomic back design for enhanced comfort.

Maintenance and Care

Proper care will extend the life and appearance of your Homy Casa dining chairs.

• General Cleaning: For routine cleaning, wipe the metal legs with a soft, damp cloth. For the upholstered fabric, use a soft brush or vacuum cleaner to remove dust and debris.
• Spot Cleaning: For spills, blot immediately with a clean, dry cloth. For stubborn stains, use a mild fabric cleaner according to the product instructions, testing on an inconspicuous area first. Avoid harsh chemicals or abrasive cleaners.
• Sunlight Exposure: Avoid prolonged exposure to direct sunlight to prevent fading of the fabric.
• Inspection: Periodically check all bolts and connections to ensure they remain tight. Re-tighten as needed.

Figure 4: Features like rub-resistant fabric and upgraded cushioning contribute to durability and comfort.

Troubleshooting

• Chair wobbles after assembly: Ensure all bolts are tightened evenly. Loosen all bolts slightly, press down on the seat to level the chair, then re-tighten all bolts firmly.
• Difficulty aligning screw holes: Ensure you are using the correct legs for the designated positions. Sometimes rotating a leg slightly can help align the holes. Do not force screws.
• Fabric appears creased: Minor creases from packaging are normal. They should relax over time with use. Gentle steaming from a distance may help, but test on an inconspicuous area first.

Specifications

Warranty Information

Homy Casa products are manufactured with quality and care. For specific warranty details regarding your CHARLTON dining chairs, please refer to the purchase documentation or contact Homy Casa customer support. This warranty typically covers manufacturing defects under normal use.

Customer Support

If you have any questions, require assistance with assembly, or need to report missing/damaged parts, please contact Homy Casa customer support through the retailer where the product was purchased or visit the official Homy Casa website for contact information.

Thank you for choosing Homy Casa.