1. Product Overview
This replacement remote control is designed to precisely match the functionality of the original LG AC remote model AKB75215406. It is compatible with both split and window air conditioners ranging from 1 to 2-ton capacity. The remote features an intuitive interface with an identical button layout and functions as your original LG remote, ensuring seamless operation without any compromise.
Key Features:
- Compatibility: Perfect replacement for LG Air Conditioner Remote Control Model AKB75215406, specifically designed for 36S series.
- Capacity Range: Suitable for LG AC units ranging from 1 ton to 2 ton capacity, including both split and window air conditioners.
- Exact Match: Features identical button layout and functionality as the original remote for seamless operation.
- Functionality: Replicates all essential functions of the genuine remote control, ensuring complete control over your AC unit.
- Easy Setup: Ready to use with compatible LG air conditioners, no programming or configuration required.
2. Setup
2.1 Battery Installation
The remote control requires two AAA batteries for operation. Follow these steps to install them:
- Locate the battery compartment cover on the back of the remote control.
- Slide the cover downwards or press the latch and lift to open the compartment.
- Insert two new AAA batteries, ensuring the positive (+) and negative (-) terminals align correctly with the markings inside the compartment.
- Replace the battery compartment cover by sliding it back into place until it clicks securely.
Image: Back of the remote control showing the battery compartment. Ensure correct battery polarity when inserting.
Note: Always use fresh, new batteries for optimal performance. Do not mix old and new batteries or different types of batteries.
2.2 Initial Use
This remote control is pre-programmed and ready to use with compatible LG AC units (models AKB75215406 and 36S series). No additional programming or setup is required. Simply point the remote towards your air conditioner and begin operation.
3. Operating Instructions
The remote control provides full functionality for your LG air conditioner. Below are the general functions of the buttons:
Image: Front view of the remote control. Button layout is identical to the original LG remote.
- Power Button: Turns the AC unit ON or OFF.
- Mode Button: Cycles through operating modes (e.g., Cool, Heat, Fan, Dry, Auto).
- Temperature Up/Down Buttons: Adjusts the desired temperature setting.
- Fan Speed Button: Changes the fan speed (e.g., Low, Medium, High, Auto).
- Swing Button: Controls the louver swing function.
- Timer Button: Sets the ON/OFF timer for the AC unit.
- Sleep Button: Activates or deactivates sleep mode.
- Other Function Buttons: Depending on your specific AC model, other buttons may control functions like Light, Plasma, or Energy Saver. Refer to your AC unit's manual for specific button functionalities.
Point the remote control directly towards the infrared receiver on your air conditioner unit for effective communication. The maximum effective range is approximately 8 meters.
4. Maintenance
4.1 Battery Replacement
When the remote control's range decreases or it becomes unresponsive, it's time to replace the batteries. Follow the battery installation steps outlined in Section 2.1. Always replace both batteries simultaneously with new AAA batteries.
4.2 Cleaning
To clean the remote control, gently wipe its surface with a soft, dry cloth. Do not use liquid cleaners, abrasive pads, or chemical solvents, as these can damage the remote's finish or internal components. Avoid dropping the remote or exposing it to excessive moisture.
5. Troubleshooting
If you experience issues with your remote control, please refer to the following common solutions:
- Remote Not Responding:
- Ensure the batteries are inserted correctly with the correct polarity.
- Replace old batteries with new AAA batteries.
- Check if there are any obstructions between the remote and the AC unit's infrared receiver.
- Ensure you are within the effective operating range (approximately 8 meters).
- Specific Functions Not Working:
- Verify that your AC unit supports the specific function you are trying to use.
- Confirm that the remote control's button layout and functions exactly match your original LG remote. If the layout is different, this replacement remote may not be fully compatible.
Image: Important compatibility and battery usage information. Ensure your original remote's keys match exactly.
If the issue persists after following these steps, please contact customer support.
6. Specifications
| Brand | Generic |
| Model Name | 36S |
| Compatible Devices | LG Air Conditioner (AKB75215406, 36S series) |
| Capacity Range | 1 Ton, 1.5 Ton, 2 Ton (Split & Window AC) |
| Connectivity Technology | Infrared |
| Maximum Range | 8 meters |
| Power Source | 2 x AAA Batteries (not included) |
| Color | White |
| Item Weight | 50 Grams |
| Item Dimensions (L x W x H) | 15L x 5W x 15H Centimeters |
| Manufacturer | ANI- ENTERPRISES |
| Country of Origin | India |
7. Warranty Information
This product comes with a 10-day replacement policy from the date of purchase. If you encounter any manufacturing defects or issues within this period, please contact customer support for a replacement.
Additionally, a 1-Year Extended Warranty by Onsitego may be available for purchase separately. Please refer to the terms and conditions of the extended warranty provider for details.
8. Customer Support
For any queries, technical assistance, or warranty claims, please contact the manufacturer:
ANI-EnterprisesA-38/2 Jaitpur Extension, Near Gurudwara
Badarpur, New Delhi 110044, India
Contact: +91 9911442161
