Goosky E2 UH-1Y RC Helicopter User Manual

1. Introduction

This manual provides essential information for the safe and efficient operation of your Goosky E2 UH-1Y RC Helicopter. Please read this manual thoroughly before operating the helicopter to ensure proper setup, flight, and maintenance. Retain this manual for future reference.

The Goosky E2 UH-1Y is a 1/35 scale 2.4G 6CH dual brushless direct drive RC rescue helicopter featuring GPS positioning, Lidar, hands-free hovering, and switchable flight modes.

2. Safety Guidelines

Operating an RC helicopter requires caution. Failure to operate safely can result in injury or property damage. Always follow these guidelines:

• Operate in open areas, away from people, animals, and obstacles.
• Maintain a safe distance from the helicopter during flight.
• Do not operate near power lines, roads, or water bodies.
• Ensure all batteries are fully charged before each flight.
• Inspect the helicopter for any damage before and after each flight.
• Keep hands and face clear of rotating blades.
• Do not operate in strong winds or adverse weather conditions.
• Adult supervision is recommended for users under 16 years of age.

3. Package Contents

Verify that all items are present in the package:

• 1x Carrying Case
• 1x Goosky E2 UH-1Y RC Helicopter
• 1x User Manual
• 1x Dedicated Charger
• 1x Smart Battery (3S 11.1V 1600mAh 30C LiPo)
• 1x 2.4G A8 Rechargeable Remote Control
• 1x Extra Main Shaft
• Various Tools
• Spare Screws

Figure 3.1: Front-side view of the Goosky E2 UH-1Y RC Helicopter.

Figure 3.2: Rear-side view of the Goosky E2 UH-1Y RC Helicopter, showing the tail rotor.

4. Setup

4.1 Battery Charging

The helicopter is powered by a 3S 11.1V 1600mAh 30C Smart LIPO battery. The remote control uses a 2800mAh battery. Use the dedicated charger provided to charge both batteries.

1. Connect the dedicated charger to a power source.
2. Connect the helicopter's smart battery to the charger.
3. Connect the remote control's battery to its charging port (Type-C for the T8 transmitter).
4. Allow approximately 90 minutes for a full charge of the helicopter battery. The charger's indicator will show charging status.
5. Always supervise charging and disconnect batteries once fully charged.

4.2 Transmitter Preparation

The 2.4G A8 remote control is included. Ensure it is fully charged before use.

1. Power on the remote control.
2. Select the desired flight mode (Mode 1 or Mode 2) if applicable. Refer to the transmitter's specific manual for detailed mode switching instructions.
3. Perform a range check before the first flight in a new environment.

4.3 Helicopter Pre-Flight Check

1. Ensure the main and tail rotor blades are securely attached and free from damage.
2. Check all linkages and servos for free movement and secure connections.
3. Insert the fully charged smart battery into the helicopter's compartment. The quick-release canopy allows easy access.
4. Power on the helicopter. Wait for GPS signal acquisition if flying outdoors.

5. Operating Instructions

The Goosky E2 UH-1Y features advanced flight stabilization and positioning systems for ease of use.

5.1 Basic Flight Controls

Familiarize yourself with the remote control's stick functions. The helicopter supports switchable Mode 1/2. Common controls include:

• Throttle: Controls rotor speed and altitude.
• Rudder (Yaw): Controls the helicopter's rotation around its vertical axis.
• Aileron (Roll): Tilts the helicopter left or right for sideways movement.
• Elevator (Pitch): Tilts the helicopter forward or backward for forward/backward movement.

5.2 GPS Smart Satellite Positioning

The built-in GPS module provides real-time positioning and navigation, enhancing flight safety and control accuracy. In GPS mode, the E2 GPS automatically stabilizes itself when control sticks are released. It can hover at a fixed point and altitude automatically, simplifying operation for beginners.

Figure 5.1: GPS Smart Satellite Positioning in action, showing fixed-point hovering.

5.3 Vision + TOF Lidar System

The vision system provides horizontal displacement data, while the TOF (Time-of-Flight) Lidar sensor supplies vertical altitude data. Together, they form a three-dimensional spatial coordinate system in GPS-denied environments, enabling precise position and altitude hold, as well as intelligent return-to-home. This system assists in stable flight even for novice users.

Figure 5.2: Vision and TOF Lidar system for enhanced stability and positioning.

5.4 Intelligent Return-to-Home

The flight controller combines altitude and distance data to automatically plan a return route. When switched to Return-to-Home mode in GPS mode, the E2 GPS will return to the takeoff point, land, and shut off the motors. If the battery voltage drops too low during flight, automatic return will also be triggered, ensuring a safe flight experience.

Figure 5.3: Intelligent Return-to-Home feature guiding the helicopter back to its starting point.

5.5 Flight Time

With a fully charged 11.1V 1600mAh LiPo battery, the helicopter can achieve up to 15 minutes of flight time. Always monitor battery levels during flight and land safely when low voltage warnings are issued.

6. Maintenance

Regular maintenance ensures the longevity and safe operation of your Goosky E2 UH-1Y helicopter.

6.1 Post-Flight Inspection

• Inspect main and tail rotor blades for cracks, chips, or deformation. Replace damaged blades immediately.
• Check the landing gear for any damage or looseness.
• Examine the fuselage for cracks or structural damage.
• Ensure all screws and fasteners are tight.

6.2 Battery Care and Storage

• Store LiPo batteries in a cool, dry place, away from direct sunlight and flammable materials.
• Do not overcharge or over-discharge batteries.
• If storing for extended periods, charge batteries to approximately 50% capacity.
• Never puncture or damage LiPo batteries.

6.3 Cleaning

Use a soft, dry cloth to clean the helicopter. Avoid using solvents or harsh chemicals that could damage plastic or electronic components.

7. Troubleshooting

This section addresses common issues you might encounter with your Goosky E2 UH-1Y helicopter.

8. Specifications

9. Warranty and Support

For warranty information, technical support, or service inquiries, please refer to the official Goosky website or contact your authorized dealer. Keep your purchase receipt as proof of purchase.

The product is designed for ease of use with features like quick-release canopy for battery access and app-based configuration support. For advanced settings or troubleshooting not covered in this manual, consult the manufacturer's online resources or customer service.