1. Introduction
The APLOS AP150 Dive Light is a powerful and durable flashlight designed for underwater and outdoor use. With its high lumen output and robust waterproof construction, it provides reliable illumination for various activities such as scuba diving, snorkeling, camping, and hiking. This manual provides essential information for the safe and effective use, setup, operation, and maintenance of your AP150 Dive Light.
2. Key Features
- 15000 Lumens Super Bright: Delivers an impressive 15,000 lumens of cold white light for clear visibility, with an effective beam distance up to 356 meters.
- Durable Construction: Made from AL-6061-T6 aircraft-grade aluminum with military-grade Type III hard anodizing, ensuring resistance to wear, impact, and seawater corrosion. Features a tempered glass lens for durability and water resistance.
- 4 Lighting Modes & Rotary Switch: Easily switch between High, Medium, Low, and SOS modes using a smooth rotary switch located behind the light head.
- IPX8 Waterproof Rating: Professional sealing design allows for use up to 150 meters (492 feet) underwater.
- Versatile Use: Suitable for scuba diving, snorkeling, camping, swimming, hiking, hunting, fishing, and other outdoor adventures.
Image 1: The APLOS AP150 Dive Light's powerful 15000 lumen beam.
Image 2: Demonstrating the AP150's waterproof capability and beam distance.
3. Setup Guide
3.1. Battery Installation
- Unscrew the tail cap or the head of the flashlight by twisting it counter-clockwise.
- Insert the included rechargeable Lithium-Ion battery (CR5 type) into the battery compartment, ensuring correct polarity (positive end towards the light head).
- Carefully screw the tail cap or head back on clockwise until it is securely tightened. Ensure the O-rings are properly seated to maintain the waterproof seal.
3.2. Charging the Battery
- Remove the battery from the flashlight as described in section 3.1.
- Place the battery into the provided external battery charger.
- Connect the charger to a power source using the included cable.
- Monitor the charger's indicator light for charging status. A full charge typically takes approximately 4 hours.
- Once fully charged, remove the battery from the charger and reinstall it into the flashlight.
4. Operating Instructions
4.1. Power On/Off and Mode Selection
The APLOS AP150 features a rotary switch for easy control:
- To turn the light ON, rotate the switch clockwise from the OFF position.
- Continue rotating the switch clockwise to cycle through the four lighting modes: High (15000 lumens) > Medium (7000 lumens) > Low (2000 lumens) > SOS (7000 lumens).
- To turn the light OFF, rotate the switch counter-clockwise back to the OFF position.
Image 3: The four lighting modes and rotary switch operation.
4.2. Battery Level Indicator
The flashlight is equipped with a battery level indicator light on the switch:
- Green Light: Battery level is between 50% and 100%.
- Yellow Light: Battery level is between 20% and 50%.
- Red Light: Battery level is below 20%. Recharge the battery promptly.
5. Maintenance
- Rinsing: After each use in saltwater, thoroughly rinse the dive light with fresh water to prevent corrosion and salt buildup.
- O-Ring Care: Regularly inspect the O-rings for any signs of wear, cracks, or damage. Keep them clean and lightly lubricated with silicone grease to maintain a watertight seal. Replace damaged O-rings immediately using the provided spares.
- Battery Care: Store the battery in a cool, dry place when not in use. Avoid fully discharging the battery for extended periods.
- Cleaning: Clean the exterior of the flashlight with a soft, damp cloth. Do not use abrasive cleaners or solvents.
6. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Light does not turn on. | Battery is depleted or incorrectly installed. | Recharge the battery. Ensure the battery is inserted with correct polarity. Check for proper contact between the battery and terminals. |
| Light flickers or is dim. | Low battery charge or loose connections. | Recharge the battery. Ensure all parts are tightly screwed together. |
| Water leakage. | Damaged or improperly seated O-rings. | Inspect O-rings for damage. Clean and lubricate O-rings. Ensure O-rings are correctly seated and the flashlight is tightly sealed before use. |
| Battery not charging. | Faulty charger or battery. | Ensure the charger is properly connected to power and the battery. Try a different charging cable or power adapter if available. If issues persist, the battery or charger may need replacement. |
7. Product Specifications
- Model Number: AP150
- Brand: APLOS
- Light Source Type: LED
- White Brightness: 15000 Lumens
- Power Source: Battery Powered (Lithium Ion)
- Number of Batteries: 1 CR5 battery (included)
- Material: AL-6061-T6 Aircraft-grade Aluminum
- Water Resistance Level: IPX8 (Waterproof up to 150 meters / 492 feet)
- Item Dimensions (L x W x H): 7"L x 1.5"W x 1.28"H
- Mounting Type: Handheld
- Included Components: APLOS AP150 Dive Light Set
8. Warranty & Support
The APLOS AP150 Dive Light comes with a 2-year manufacturer's warranty. For warranty claims, technical support, or any inquiries regarding your product, please contact APLOS customer service through the retailer where the product was purchased or visit the official APLOS website for contact information.
For additional information and product updates, you may visit the APLOS Store on Amazon.