Introduction
Thank you for choosing the Vipbear Smart Toilet. This advanced toilet system combines comfort, hygiene, and smart technology to enhance your bathroom experience. This manual provides essential information for safe installation, operation, and maintenance of your new smart toilet. Please read it thoroughly before installation and use, and keep it for future reference.
Safety Information
- This product requires an electrical outlet for operation. Ensure a properly grounded 120V AC outlet is available near the installation area.
- A 12-inch rough-in is required for proper installation. Verify your bathroom's plumbing configuration meets this requirement.
- All electrical and plumbing connections should be performed by a qualified professional in accordance with local codes and regulations.
- Do not immerse the product in water or spray water directly onto electrical components.
- Keep children and pets away from the toilet during operation of automatic features and bidet functions.
Package Contents
Please ensure all the following items are included in your package:
- Smart Toilet Unit (x1)
- Remote Control (x1)
- Instruction Manual (x1)
- Flange Ring (x1)
- Water Valve (x1)
- Remote Control Battery (x1 set)
- Power Outage Flushing Battery (x1)
- Installation Hardware (screws, gaskets, anchors)
Setup & Installation
1. Pre-Installation Requirements
- Rough-in Distance: A 12-inch rough-in is required. The distance from the wall to the central point of the sewage outlet should be approximately 11.81 inches.
- Angle Valve Height: The angle valve should be installed between 10-16 inches from the ground.
- Electrical Socket Height: The electrical socket should be installed between 16-20 inches from the ground.
2. Unboxing and Preparation
- Carefully cut the transparent tape and braided straps on the outer carton.
- Open the outer carton, then open the inner carton packaging and remove the foam pad. The toilet is securely packed to prevent damage during transportation.
- Move the toilet out of the carton. Tear off the protective film from the cover and around the toilet.
- Open the toilet cover and remove the instruction manual and accessory box from inside the toilet bowl.
3. Floor Flange Installation
- Wipe the area around the sewage outlet clean with a rag.
- Slip the PVC flange ring over the floor drain outlet. Mark the four positions for drilling, then drill holes at the marked spots.
- Drive four expansion anchors into the drilled holes.
- Align the PVC flange ring with the four small holes and tighten the four screws to fix it.
- Insert two large screws into the gaps of the flange ring and put plastic gaskets over them.
4. Toilet Placement and Connection
- Apply installation adhesive along the bottom edge of the toilet.
- Press the flange ring tightly against the toilet drain outlet.
- Carefully place the toilet over the flange ring, aligning the two pre-reserved small holes at the bottom of the toilet with the two screws. Put on the gaskets and tighten the screws.
- Reinstall the cover plate onto the toilet and press it tightly.
- Install the decorative cover, adapter, and sealing ring into the copper pipe reserved on the wall. Then tighten the angle valve.
- Connect the toilet inlet hose to the angle valve, then tighten it with a wrench.
- Connect the power supply and turn on the toilet to test whether the flushing works normally.
- Finally, apply a circle of installation adhesive to fix the toilet to the floor.
Installation Demonstration Video
Video Description: This video demonstrates the complete installation process for the Vipbear Smart Toilet, including unboxing, preparing the floor, installing the flange, connecting the water supply, and securing the toilet. It provides a visual guide for each step.
Operating Instructions
1. Automatic Features
- Auto-Open Lid & Seat: The lid automatically opens as you approach (within 80cm/2.6 ft). For men's urination, the foot sensor flips up the seat ring. The lid and seat automatically close when you leave.
- Auto-Flush: The toilet self-flushes when you leave after use.
- Soft-Close: The lid and seat feature a whisper-quiet soft-close mechanism to prevent slamming.
Image Description: A smart toilet demonstrating its auto-open and close lid and seat features. A diagram illustrates the sequence: auto-open lid, user approaching, using, off-seat flushing, and auto-close after 3 minutes of leaving.
Image Description: A smart toilet with its lid automatically opening as a person approaches, highlighting the hands-free hygiene and convenience. It also mentions a foot sensor for opening/closing.
2. Bidet System & Hygiene
- Dual-Nozzle System: Enjoy personalized posterior and feminine wash with adjustable position, pressure, and temperature.
- Self-Cleaning Nozzles: Nozzles are self-cleaning before and after every use.
- UV-C Hygiene Protection: Integrated UV-C light ensures healthy protection.
Image Description: A detailed view of the bidet's dual-nozzle system, illustrating rear wash, female wash, automatic cleaning, and oscillating massage. The image also highlights the UV-C Hygiene Protection feature.
Image Description: A close-up of the UV-C hygiene self-cleaning nozzle, with indicators for water pressure (weak to strongest) and water temperature (93°F to 104°F), along with demonstrations of rear wash, female wash, oscillating massage, and automatic cleaning after use.
3. Comfort Features
- Heated Seat: The heated seat offers 4 adjustable warmth levels for cozy comfort year-round.
- Warm Air Dryer: Reduces toilet paper use by 80% for comfortable drying.
- Night Light: A soft built-in nightlight guides you in the dark without disturbing others.
Image Description: An illustration of the instant heating seat with temperature settings from normal to 104°F, and a warm air dryer blowing warm air for comfort.
Image Description: A smart toilet in a dark bathroom, illuminated by a gentle night light. Text highlights 'Zero Sleep Disruption' and 'Quiet Soft-Close Lid/Seat', emphasizing its sleep-friendly nighttime mode.
4. Flushing Technology
- Powerful 360° Vortex Flush: Combines siphon jet and vortex for maximum efficiency and zero clogging.
- 4 Smart Flushing Modes: Remote Flush, Side Button Flush, Off-Seat Auto Flush, Foot Sensor Flush.
Image Description: A cutaway diagram illustrating the powerful dual-flush system, combining siphon jet and vortex for efficiency. It highlights 360° rimless cleaning with side jets and direct flush technology targeting waste instantly, all with low-noise flushing.
Image Description: A smart toilet with its lid open, illustrating the four smart flushing modes: Remote Flush, Side Button Flush, Off Seat Auto Flush, and Foot Sensor Flush.
5. Smart Memory & Kid-Friendly Mode
- Dual User Profiles: Save personalized settings (temperature, clean mode, pressure) for two users.
- Kid-Friendly Cleaning Mode: Gentle water spray helps children learn bathroom independence.
Image Description: A smart toilet with a display showing '93°F' and icons for 'Smart Memory & Child Mode', indicating dual user profiles for personalized settings and a kid-friendly mode for independent toilet training.
6. Remote Control Operation
The intelligent wireless remote control allows easy operation of all toilet functions. It can be mounted on the wall or used handheld.
- Seat Cover Open/Close: Press the 'Seat Cover Open' or 'Seat Ring Opening' buttons to control the lid and seat.
- Bidet Functions: Use 'Butt Cleansing' for posterior wash and 'Feminine Cleansing' for female wash. Press again for moving cleaning.
- Nozzle Adjustment: Use 'Nozzle +' and 'Nozzle -' to adjust the nozzle's front-back position.
- Water Pressure: Adjust water pressure with 'Water Pressure +' and 'Water Pressure -'.
- Water Temperature: Adjust water temperature with 'Water Temp'.
- Air Temperature: Adjust air temperature for drying with 'Wind Temp'.
- Seat Temperature: Adjust seat temperature with 'Seat Temp'.
- UV Disinfection: Press 'UV Disinfection' to activate ultraviolet disinfection.
- Self-Cleaning: Press 'Self-Cleaning' to start nozzle self-cleaning.
- Flushing: Press 'Flushing' to activate flushing.
- Drying: Press 'Drying' to activate the drying function.
- Night Light: Press 'Energy Saving/Night Light' to turn on or off the night light.
Operation Demonstration Video
Video Description: This video provides a comprehensive demonstration of the Vipbear Smart Toilet's features and functions, including automatic lid/seat operation, bidet controls, drying, heated seat, night light, and flushing options, all controlled via the remote.
Maintenance
- Nozzle Cleaning: The bidet nozzles are equipped with a self-cleaning function. Activate this feature regularly to maintain hygiene. The UV-C light also contributes to nozzle sanitation.
- Exterior Cleaning: Wipe the exterior surfaces of the toilet with a soft, damp cloth and mild, non-abrasive cleaner. Avoid harsh chemicals that may damage the finish.
- Bowl Cleaning: Clean the toilet bowl regularly using standard toilet bowl cleaners.
Troubleshooting
If you encounter any issues with your Vipbear Smart Toilet, please refer to the following common troubleshooting tips:
- No Power: Ensure the power cord is securely plugged into a functional electrical outlet and the power switch is on. Check your home's circuit breaker.
- Bidet Not Functioning: Verify that the water supply valve is fully open. Check remote control batteries.
- Lid/Seat Not Opening Automatically: Ensure the foot sensor area is clear and clean. Check for any obstructions.
- Weak Flush: Confirm the water supply valve is fully open. Ensure there are no obstructions in the bowl or drain.
For persistent issues or problems not listed here, please contact Vipbear customer support.
Specifications
| Feature | Specification |
|---|---|
| Brand | Vipbear |
| Model Number | TOILET |
| Style | UV-C light/Dual User Memory |
| Color | OPT04 |
| Product Dimensions | 26.77"D x 17.72"W x 17.52"H |
| Material | High-density ceramic body |
| Item Weight | 90 Pounds |
| Installation Type | Floor Mounted |
| Shape | Oval |
| Seat Material Type | Plastic |
| UPC | 199581014749 |
| Batteries Required? | Yes |
| Battery Cell Type | Alkaline |
Warranty & Support
Your Vipbear Smart Toilet comes with a 1-year warranty. Our dedicated support team is always ready to help with any questions or concerns you may have.
For customer support, please refer to the contact information provided with your purchase or visit the official Vipbear website.
