1. Introduction
Thank you for purchasing the Bonnlo Mirrored Makeup Vanity Desk and Stool. This manual provides essential information for the safe assembly, operation, maintenance, and care of your new vanity set. Please read these instructions thoroughly before assembly and retain them for future reference.
2. Safety Information
Observe the following safety precautions to prevent injury or damage to the product:
- Pinching Hazard: Exercise caution when operating the flip mirror mechanism to avoid pinching fingers.
- Weight Limit: The accompanying stool has a maximum weight recommendation of 200 pounds (90.7 kg). Do not exceed this limit.
- Fragile Components: The vanity desk features mirrored and glass components. Handle with care during assembly and use to prevent breakage.
- Stable Surface: Always place the vanity desk and stool on a flat, stable, and level surface to prevent tipping.
- Children and Pets: Keep children and pets away from the assembly area. Do not allow children to climb on or play with the vanity set.
- Cleaning: Refer to the "Maintenance and Care" section for proper cleaning instructions. Avoid abrasive cleaners that may damage mirrored surfaces.
3. Package Contents
Before beginning assembly, ensure all parts are present and undamaged. If any parts are missing or damaged, do not proceed with assembly and contact customer support.
- Mirrored Vanity Desk (1)
- Leather Vanity Stool (1)
- Assembly Hardware (Screws, knobs, etc.) (1 set)

Image showing the complete Bonnlo Mirrored Makeup Vanity Desk with its accompanying leather stool.
4. Assembly and Setup Instructions
Assembly of the Bonnlo Mirrored Makeup Vanity Desk and Stool is straightforward and requires minimal effort.
Required Tools:
- No additional tools are typically required as legs and knobs screw in by hand.
Assembly Steps:
- Unpack Components: Carefully remove all components from the packaging. Place them on a soft, clean surface to prevent scratches.
- Attach Desk Legs: Locate the four desk legs. Align each leg with the pre-drilled holes on the underside of the vanity desk. Screw the legs firmly into place by hand until secure.
- Attach Stool Legs: Locate the four stool legs. Align each leg with the pre-drilled holes on the underside of the stool. Screw the legs firmly into place by hand until secure.
- Install Drawer Knobs: Attach the drawer knobs to the front of the drawers by screwing them in from the inside.
- Final Placement: Carefully lift the assembled vanity desk and stool and place them in the desired location on a stable, level surface.
5. Operating Instructions
Flip Top Mirror Operation:
The vanity desk features a flip-top mirror for convenient use and discreet storage. The mirror is supported by a heavy-duty lid support hinge.
- To open the mirror, gently lift the front edge of the mirrored top. The hinge will support the mirror in an open position.
- The lid can be adjusted up to approximately 110° to provide an optimal viewing angle while seated.
- To close the mirror, gently lower the mirrored top until it rests flush with the desk surface. Ensure fingers are clear of the closing mechanism.
Drawer Usage:
The vanity desk includes two drawers for storage. Pull the knobs to open and push to close. Avoid forcing drawers if they feel stiff; ensure they are properly aligned.
6. Maintenance and Care
Proper care will extend the life and maintain the appearance of your Bonnlo vanity set.
- Cleaning Mirrored Surfaces: Wipe mirrored surfaces with a dry, soft, lint-free cloth. For smudges, use a glass cleaner specifically designed for mirrors and apply it to the cloth, not directly to the mirror.
- Cleaning Frame and Stool: Wipe the wood frame and stool with a dry cloth. Avoid harsh chemicals or abrasive cleaning materials.
- Spills: Immediately wipe up any spills to prevent damage to the finish.
- Avoid Direct Sunlight: Prolonged exposure to direct sunlight may cause fading or damage to the finish.
- Regular Checks: Periodically check all screws and connections to ensure they remain tight. Tighten if necessary.
7. Troubleshooting
This section addresses common issues you might encounter.
| Problem | Possible Cause | Solution |
|---|---|---|
| Vanity or stool wobbles. | Uneven floor or loose legs. | Ensure the vanity and stool are on a level surface. Check and tighten all leg screws. |
| Flip mirror does not stay open. | Hinge mechanism issue or obstruction. | Ensure no objects are obstructing the hinge. If the issue persists, contact customer support. |
| Drawers are stiff or difficult to open/close. | Misalignment or obstruction. | Check for any items blocking the drawer slides. Ensure the drawer is properly seated in its tracks. |
If you encounter problems not listed here or if solutions do not resolve the issue, please contact Bonnlo customer support.
8. Specifications
| Feature | Detail |
|---|---|
| Model Number | VT0MLSR |
| Product Dimensions (Desk) | 39.4" (L) x 16.5" (W) x 31.1" (H) |
| Item Weight (Desk) | Approximately 33 Pounds (15 kg) |
| Frame Material | Wood |
| Material Type | Mirror |
| Number of Drawers | 2 |
| Stool Seat Material | Velvet |
| Stool Maximum Weight Recommendation | 200 Pounds (90.7 kg) |
| Required Assembly | No (Minimal assembly required, screwing in legs/knobs) |
9. Warranty and Support
Bonnlo provides the following support for this product:
- Return Policy: 30-Day Free Return.
- Quality Warranty: Worry-Free 24-Month Quality Warranty for the entire VINGLI Mirrored furniture line.
- Customer Support: For assistance with assembly, missing parts, or any other inquiries, please contact Bonnlo customer support through the retailer's platform or the official Bonnlo website.