Introduction
The Carisma GT24 2.0 Subaru Impreza WRC 1999 is a 1/24 scale micro 4WD brushless ready-to-run (RTR) remote control car, representing the latest evolution in Carisma's officially licensed rally car series. Designed for enthusiasts, this model builds upon the success of its predecessor with significant enhancements for an improved driving experience. This manual will guide you through the necessary steps to get your GT24 2.0 operational and maintain its performance.

This image displays the Carisma GT24 2.0 Subaru Impreza WRC 1999, a 1/24 scale micro 4WD brushless ready-to-run (RTR) remote control car. The car features a vibrant blue body with yellow Subaru World Rally Team livery, including the number '5' on the side. It has gold-colored multi-spoke wheels and black rally-style tires. The front of the car shows detailed headlights and a grille, while the rear features a spoiler.
Setup
Package Contents Verification
Before beginning, ensure all components are present:
- Carisma GT24 2.0 Subaru Impreza WRC 1999 RC Car
- KD PROPO CTX-2000 2.4GHz Transmitter
- 7.2V NiMH Micro Stick Pack Battery
- 5V USB Charger
- 4 x AA Batteries for Transmitter
Battery Charging
The included 7.2V NiMH Micro Stick Pack battery must be fully charged before first use. Connect the battery to the 5V USB Charger. The charger's indicator light will show charging status (refer to charger instructions for specific light patterns). Charging typically takes 1-2 hours. Do not overcharge the battery.
Transmitter Battery Installation
Open the battery compartment on the back of the KD PROPO CTX-2000 2.4GHz Transmitter. Insert the 4 x AA batteries, ensuring correct polarity (+/-). Close the battery compartment securely.
Binding (If Necessary)
Your GT24 2.0 is typically pre-bound from the factory. If the car does not respond to the transmitter, follow these general binding steps:
- Ensure both the car's battery and transmitter batteries are installed and charged.
- Turn on the transmitter.
- Turn on the car. The ARC-24 2-in-One ESC/RX unit will attempt to connect.
- If binding is required, a small bind button may be present on the receiver (integrated into the ESC/RX). Consult the full product manual for specific binding procedures if the car does not connect automatically.
Operating
Basic Controls
The KD PROPO CTX-2000 2.4GHz Transmitter provides precise control over your GT24 2.0:
- Throttle Trigger: Pull the trigger to move forward. Push the trigger forward to brake, then push again for reverse.
- Steering Wheel: Turn the wheel left or right to steer the vehicle.
- Trim Dials: Adjust the steering trim and throttle trim dials to ensure the car drives straight and stops when the throttle is neutral.
Driving Tips
- Start in an open area free of obstacles and people.
- Familiarize yourself with the controls at low speeds before attempting high-speed maneuvers.
- The 8000kv brushless motor provides significant power; apply throttle smoothly to maintain control.
- The 4WD system and High Traction Rally Mini Pin Tires offer excellent grip on various surfaces.
- Avoid driving in wet conditions or through deep puddles, as electronics are not fully waterproof.
Maintenance
General Cleaning
After each use, especially when driving off-road, clean your GT24 2.0 to remove dirt, dust, and debris. Use a soft brush or compressed air. Avoid using water directly on electronic components.
Battery Care
- Always disconnect the battery from the car when not in use.
- Store batteries in a cool, dry place.
- Do not leave batteries charging unattended.
- If storing for extended periods, charge the NiMH battery to approximately 50% capacity.
Chassis and Drivetrain
- Inspect the Low-Maintenance Friction Dampers for any damage or leaks.
- Check the Full Ball Bearings for smooth operation. Clean and re-lubricate if necessary (consult advanced maintenance guides for detailed steps).
- Ensure all screws and fasteners are tight.
- Inspect tires for wear and tear.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Car does not turn on. | Battery not charged or connected; power switch off. | Charge car battery; ensure battery is securely connected; turn on power switch. |
| Car does not respond to transmitter. | Transmitter batteries low or incorrectly installed; car and transmitter not bound. | Replace transmitter batteries; check polarity; re-bind car and transmitter. |
| Poor steering or erratic movement. | Steering trim incorrect; damaged servo; debris in steering mechanism. | Adjust steering trim on transmitter; inspect 3-wire servo for damage; clean steering components. |
| Reduced power or short run time. | Battery not fully charged; battery degradation. | Ensure battery is fully charged; consider replacing old batteries. |
Specifications
| Feature | Detail |
|---|---|
| Model | Carisma GT24 2.0 Subaru Impreza WRC 1999 |
| Scale | 1/24 |
| Drive Type | 4WD |
| Motor | 8000kv Brushless Motor |
| ESC/RX | ARC-24 2-in-One ESC/RX |
| Transmitter | KD PROPO CTX-2000 2.4GHz |
| Battery (Car) | 7.2V NiMH Micro Stick Pack (Included) |
| Battery (Transmitter) | 4 x AA (Included) |
| Charger | 5V USB Charger (Included) |
| Dampers | Low-Maintenance Friction Dampers |
| Tires | High Traction Rally Mini Pin Tires |
| Bearings | Full Ball Bearings |
| Servo | 3-wire system |
| Product Dimensions | 1 x 1 x 1 inches (approximate) |
| Item Weight | 1 pound (approximate) |
| Recommended Age | 14 months - 9 years (Manufacturer Recommended) |
Warranty and Support
For warranty information and technical support, please refer to the official Carisma website or contact their customer service directly. Keep your proof of purchase for any warranty claims. Specific warranty terms and conditions may vary by region and retailer.





