Electactic 4-Burner Gas Grill with Side Burner Instruction Manual

1. Introduction

Thank you for purchasing the Electactic 4-Burner Gas Grill with Side Burner. This manual provides essential information for the safe assembly, operation, and maintenance of your new grill. Please read all instructions thoroughly before use and retain this manual for future reference.

2. Safety Information

WARNING

• For outdoor use only. Do not store or use gasoline or other flammable liquids or vapors in the vicinity of this or any other appliance.
• An LP cylinder not connected for use shall not be stored close to this or any other appliance.
• The grill is for use with propane gas only (propane cylinder not included).
• Never attempt to attach this grill to the self-contained propane system of a boat, camper trailer, motor home or house.
• Do not attempt to move the grill while it is hot. The casters should be locked and loosened by turning the brake.
• Keep all combustible items and surfaces at least 40 inches (101.6 cm) away from the grill at all times.
• Do not touch metal parts of grill until it has completely cooled (about 45 minutes) to avoid burns. Unless you are wearing protective gear (pot holders, gloves, BBQ mittens, etc.).
• Do not use the grill in strong winds.

CAUTION

• This unit is heavy. Two people are required for safe assembly.
• Do not store a spare LP-gas cylinder under or near this appliance.
• Never fill the cylinder beyond 90% percent full.
• Do not leave a lit grill unattended. Keep children and pets away from the grill at all times.
• Do not place this grill on any type of tabletop surface. The grill should be placed on a flat and level surface.

3. Parts List

Before starting assembly, make sure all parts are present. Compare parts and hardware with the list on the package contents page. If any part is missing or damaged, do not attempt to assemble the product. Contact customer service for replacement parts.

Estimated Assembly Time: 50 minutes with 2 people.

Tools Required for Assembly and Leak Testing: Phillips screwdriver, Spray bottle, Pliers, Adjustable Wrench.

NOTE: Common tools used for assembly and leak testing are not included in the accessories.

Detailed diagram of all grill components and their corresponding part numbers.

4. Setup and Assembly

Follow the step-by-step instructions provided in the included manual. Ensure all screws are tightened securely. Two people are recommended for assembly.

Assembly Overview Video

This video provides a detailed guide on how to install the barbecue grill.

Key Assembly Steps:

1. Install the Baseboard and Frames: Align the holes on the side of the two frames and the holes on the side of the baseboard. Assemble the frames and the baseboard together with 4 AA screws. Ensure the adsorption surface of the magnet base faces forward to adsorb and fix the two doors which will be installed later.
2. Install the Backboard: Install the back panel between the left and right frames with 4 AA screws.
3. Install Casters: Install the casters with brake (2 pcs) and casters without brake (2 pcs) under the bottom of the bottom panel and adjust the height of the casters with the HH wrench. For easy movement, be sure to install the same type of casters on the same side of the bottom panel. It's suggested to install the casters with brake near the front side.
4. Install the Grill Body: Install the grill body on the two frames with 4 AA screws. Before installing the grill body, it is necessary to pass the igniter and the gas hose through the right frame.
5. Install Side Tables and Front Panels: Pre-attach 2 AA screws to the left side table (do not tighten), then assemble the left side table and left front panel together and tighten the screws. Align the right burner table with the 4 pre-attached AA screws on the right side of the grill body and then tighten them. Fix the right front panel to the right side of the grill body with 2 AA screws.
6. Install Lid Handle and Temperature Dial: Remove the 2 AA screws and 2 adiabatic spacers pre-installed on the lid handle. Install the lid handle and adiabatic spacers on the grill body with the 2 AA screws from the inside of the grill body. Install the temperature dial on the top of the grill body with the spacer and the butterfly screw.
7. Install Fire Spreaders and Cooking Grills: Install the fire spreaders in place, noting that each fire spreader must be placed in the specified slot. Install the cooking grill on the specified steps.
8. Install Burner Rack: Insert the burner rack into the specified holes on the right burner table.
9. Install Gas Tank: Open the two doors and place the gas tank into the nesting hole of the baseboard. Connect and tighten the regulator valve of the hose to the threaded valve of the tank to ensure that there is no methane leakage. Clockwise tighten the butterfly screw on the back of the baseboard to secure the gas tank in place.
10. Install Ignition Battery: Screw the ignition button on the front of the grill body out, then insert the battery into the round hole and screw the ignition button in. Note: The "+" pole faces outward and the "-" pole faces inward.

5. Operating Instructions

Lighting Instructions:

1. Read instructions before lighting.
2. Open lid during lighting.
3. If ignition does not occur in 5 seconds, turn the burner control(s) off, wait 5 minutes, and repeat the lighting procedure.
4. To ignite the burners, hold down and turn the gas control knob anticlockwise first to ensure that the gas in the tank is released, then press the ignition button for 3 to 4 seconds.

NOTE: The flame can be observed through the round hole on the side of the grill body.

The side burner provides 10,000 BTU of heat, ideal for cooking side dishes or warming sauces.

The main cooking area offers 395 sq. in. for grilling, suitable for various food items.

6. Maintenance

Cleaning:

• The removable residue tray's grooved design allows for efficient oil and debris collection, making cleanup simple.
• Porcelain-enameled cooking grates are easy to clean and offer superior performance.

Storage:

• The large storage cabinet at the bottom can easily store your gas tank and provide enough space for grilling accessories.
• The propane grill features four directional casters with brakes for secure placement and easy movement.

7. Troubleshooting

If ignition does not occur in 5 seconds, turn the burner control(s) off, wait 5 minutes, and repeat the lighting procedure. If issues persist, consult the full manual or contact customer support.

8. Specifications

9. Warranty and Support

For warranty information or customer support, please refer to the documentation included with your product or visit the Electactic website. Protection plans are available for purchase separately.