Fabater Portable LED Work Solar Light Instruction Manual

Introduction

This manual provides essential information for the safe and effective use of your Fabater Portable LED Work Solar Light. This 100W, 20000 lumen worklight features a 10000mAh rechargeable battery and an IP67 waterproof rating, making it suitable for various indoor and outdoor applications. Please read these instructions carefully before operating the device.

Image: The Fabater Portable LED Work Solar Light in use, illuminating an area under a vehicle.

Setup

1. Unpacking: Carefully remove the LED work light and all accessories from the packaging. Inspect for any damage.
2. Initial Charge: Before first use, fully charge the internal 10000mAh battery using the provided adapter. Connect the adapter to the charging port on the light and plug it into a suitable power outlet.
3. Positioning: The light features an alloy steel adjustable bracket that supports 180° rotation. Adjust the bracket to achieve the desired angle and position for illumination. The foldable design allows for easy storage and transport.

Image: The work light shown with its charging adapter, ready for initial charging.

Operation

1. Power On/Off: Locate the power switch on the device. Press the switch to turn the LED work light on. Press it again to turn the light off.
2. Brightness: This model provides a single brightness level of 20,000 lumens. The brightness is not adjustable.
3. Battery Life: A fully charged 10000mAh battery provides approximately 6 to 8 hours of operation at its full 20,000 lumen output.
4. Adjusting Angle: Utilize the 180° rotatable bracket to direct the light beam as needed. The bracket can be locked into position for stable illumination.

Image: The work light positioned to illuminate an engine bay during auto repair.

Image: A detailed view of the adjustable joint mechanism, allowing for 180-degree rotation of the light panel.

Maintenance

• Cleaning: To clean the light, wipe the surface with a soft, damp cloth. Do not use abrasive cleaners or solvents, as these may damage the finish or internal components.
• Storage: When not in use for extended periods, store the work light in a cool, dry place. Ensure the battery is partially charged (around 50%) before storage to prolong its lifespan. Recharge every 3-6 months if stored for a long time.
• Water Resistance: The device is rated IP67 for water and dust resistance. While it can withstand splashes and temporary immersion, avoid prolonged submersion or high-pressure water jets. Ensure the charging port cover is securely closed when not charging to maintain water resistance.

Troubleshooting

• Light Does Not Turn On:
  • Ensure the battery is charged. Connect the light to the adapter and allow it to charge for several hours.
  • Verify the power switch is fully engaged.
• Short Battery Life:
  • Ensure the battery is fully charged before use.
  • Battery performance can degrade over time with repeated charge cycles.
  • Extreme temperatures can affect battery performance. Operate and charge within recommended temperature ranges.
• Light Flickers or Dims:
  • This may indicate a low battery. Recharge the device.
  • If the issue persists after charging, contact customer support.

Important Note:

• The brightness of this work light is not adjustable.
• The lamp panel is not designed to be adjusted independently of the bracket.
• Avoid staring directly into the LED light when it is on, as it can cause eye strain or temporary vision impairment.

Specifications

Warranty Information

Specific warranty details are not provided in the product information. Please refer to the product packaging or contact the manufacturer directly for warranty terms and conditions.

Customer Support

For technical assistance, replacement parts, or further inquiries, please contact Fabater customer support. Contact information may be available on the product packaging or the official Fabater website.

You can visit the Fabater Store on Amazon for more information.