1. Introduction
Thank you for choosing the Faber Maple 75cm BLDC Autoclean Slant Chimney. This manual provides essential information for the safe installation, operation, and maintenance of your new kitchen appliance. Please read these instructions carefully before use and retain them for future reference.
2. Safety Information
To ensure safe operation and prevent damage, observe the following safety precautions:
- Ensure the chimney is installed by a qualified technician according to local regulations and the instructions provided.
- Always disconnect the power supply before cleaning or performing any maintenance.
- Do not operate the chimney without the oil collector properly installed.
- Maintain adequate ventilation in the room when the chimney is operating simultaneously with gas or other fuel-burning appliances.
- Never flambé under the chimney.
- Do not leave frying food unattended, as overheated oil can ignite.
- The chimney is designed for domestic use only to extract cooking fumes. Do not use it for other purposes.
- Keep children away from the appliance during operation and cleaning.
3. Product Overview
The Faber Maple 75cm BLDC Autoclean Slant Chimney is designed for efficient and quiet kitchen ventilation. Key features include:
- Type: Slant Shaped, Wall Mounted
- Size: 75 cm (suitable for 3-5 burner stoves)
- Suction Power: 1500 m³/hr
- Motor: 130W BLDC Motor for high efficiency and low noise
- Control Type: Touch Control, Gesture Control, and Motion Sensor
- Speed Settings: 9 speeds
- Noise Level: 56dB
- Filter Type: Filterless design
- Special Features: Autoclean function, Built-In Oil Collector, 2 LED Lamps
Figure 3.1: Front view of the Faber Maple 75cm BLDC Autoclean Slant Chimney.
Figure 3.2: Illustration of the efficient BLDC motor technology.
4. Setup & Installation
The Faber Maple Chimney is designed for wall-mounted installation. It supports both ducted and ductless configurations.
4.1 Installation Type
- Ducted Installation: Smoke and odors are expelled outside through a duct pipe. This method offers optimal performance.
- Ductless Installation: Requires the addition of a charcoal filter (to be purchased separately). Air is filtered and recirculated into the kitchen. Contact customer support for more information on charcoal filters.
Figure 4.1: Comparison of ducted and ductless installation methods.
4.2 Professional Installation
It is highly recommended to have the chimney installed by a certified Faber service technician to ensure proper functioning and warranty validity. For installation services, please contact Faber customer support at 1800-209-3484.
5. Operating Instructions
Your Faber Maple Chimney features intuitive touch and gesture controls for ease of use.
5.1 Control Panel
The control panel is located on the front of the chimney. It includes touch-sensitive buttons for power, speed adjustment, light control, and autoclean activation.
5.2 Touch Control
- Power On/Off: Press the power button to turn the chimney on or off.
- Speed Adjustment: Use the speed control buttons to cycle through the 9 available suction speeds.
- Light Control: Press the light button to turn the LED lamps on or off.
- Autoclean Activation: Press the autoclean button to initiate the self-cleaning cycle.
5.3 Gesture Control & Motion Sensor
The chimney can be operated by simple hand gestures, allowing for hands-free control:
- Wave Left/Right: Wave your hand across the sensor to turn the chimney on/off or adjust suction speed.
- Motion Sensor: The chimney may automatically detect motion and activate or adjust settings based on pre-programmed preferences. Refer to the full user manual for detailed gesture commands.
Figure 5.1: Demonstrating touch and gesture controls for the chimney.
6. Maintenance & Cleaning
Regular maintenance ensures optimal performance and longevity of your chimney.
6.1 Autoclean Function
The Autoclean feature simplifies maintenance by heating the internal components to melt and collect oil residues. Activate this function regularly, especially after heavy cooking.
- Ensure the oil collector is empty before starting the autoclean cycle.
- Press the dedicated autoclean button on the control panel.
- Allow the cycle to complete. The chimney will automatically turn off once finished.
Figure 6.1: Auto-clean technology for hassle-free maintenance.
6.2 Built-In Oil Collector
The chimney is equipped with a built-in oil collector to gather the oil and grease extracted from cooking fumes. This collector needs to be emptied and cleaned periodically.
- Carefully remove the oil collector from its housing.
- Empty the collected oil and wash the collector with warm, soapy water.
- Ensure the collector is completely dry before reinserting it.
Figure 6.2: Location of the built-in oil collector.
Figure 6.3: Removing the oil collector for cleaning.
6.3 Exterior Cleaning
Wipe the exterior surfaces of the chimney with a soft cloth dampened with mild detergent. Avoid abrasive cleaners or scouring pads that can damage the finish.
7. Troubleshooting
Before contacting customer service, please refer to the following common issues and solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Chimney does not turn on | No power supply | Check if the power cord is properly plugged in and the circuit breaker is not tripped. |
| Low suction power | Oil collector full or dirty | Empty and clean the oil collector. Run the autoclean cycle. |
| Excessive noise during operation | Loose components or obstruction | Ensure all parts are securely fastened. Check for any foreign objects in the fan area (after disconnecting power). |
| Lights not working | LED lamp failure | Contact customer service for lamp replacement. |
| Gesture control unresponsive | Sensor obstructed or dirty | Clean the sensor area. Ensure no objects are blocking the sensor. |
If the problem persists after attempting these solutions, please contact Faber customer support.
8. Specifications
Detailed technical specifications for the Faber Maple 75cm BLDC Autoclean Slant Chimney:
| Feature | Specification |
|---|---|
| Brand | Faber |
| Model Number | 330.0732.322 |
| Type | Slant Shaped, Wall Mounted Canopy Hood |
| Size | 75 cm |
| Product Dimensions (L x D x H) | 75 x 34 x 82 Centimeters (approximate, refer to installation guide for precise measurements) |
| Air Flow Capacity | 1500 m³/hr |
| Motor Type | BLDC Motor (130W) |
| Noise Level | 56 Decibels |
| Control Method | Touch, Gesture, Motion Sensor |
| Number of Speeds | 9 |
| Filter Type | Filterless |
| Special Features | Auto Clean, Built-In Oil Collector, LED Lighting, Noise Reduction |
| Voltage | 240 Volts |
| Material Type | Stainless Steel |
| Finish Type | Powder Coated (Black) |
| Item Weight | 17 Kilograms |
| Included Components | 1 Chimney, User Manual, Warranty Card |
Figure 8.1: Approximate dimensions of the Faber Maple 75cm Chimney (75cm width, 34cm depth, 82cm height).
9. Warranty & Support
Faber provides comprehensive warranty coverage and dedicated customer support for your product.
9.1 Warranty Details
- Motor Warranty: 12 Years
- Comprehensive Product Warranty: 2 Years
Please retain your purchase receipt and warranty card for any warranty claims. The warranty covers manufacturing defects under normal domestic use.
9.2 Customer Support
For installation, service requests, or any product-related queries, please contact Faber customer support:
- Toll-Free Number: 1800-209-3484
- Manufacturer/Importer: Franke Faber India Pvt Ltd
- Address: 1086/1/2, SANASWADI, TAL - SHIRUR, PUNE - 412208, MAHARASHTRA, INDIA