Acouto Nordic Digital Alarm Clock User Manual

1. Introduction

This manual provides comprehensive instructions for the setup, operation, and maintenance of your Acouto Nordic Digital Alarm Clock. Please read this manual thoroughly before using the product to ensure proper function and longevity.

2. Package Contents

Verify that all items listed below are included in your package:

• 1 x Acouto Digital Clock
• 1 x English User Manual (This Document)
• 1 x USB Cable

Note: AAA Batteries are not included and must be purchased separately for backup power.

3. Safety Information

• Do not expose the device to extreme temperatures, direct sunlight, or high humidity.
• Avoid dropping or subjecting the device to strong impacts.
• Do not attempt to disassemble or repair the device yourself. Contact qualified service personnel.
• Use only the provided USB cable or a certified equivalent for power.
• Keep out of reach of children.

4. Setup

4.1 Power Connection

To power the alarm clock, connect the provided USB cable to the DC 5V port on the back of the clock and plug the other end into a USB power adapter (not included) or a powered USB port.

Image 1: Rear view of the clock, highlighting the DC 5V power input and control buttons.

4.2 Battery Installation (Backup Power)

The clock requires 3 x AAA batteries (not included) for backup power. These batteries maintain time and alarm settings during a power outage. The clock will not display time or function without external USB power, even with batteries installed.

1. Locate the battery compartment on the back of the clock.
2. Open the battery compartment cover.
3. Insert 3 AAA batteries, ensuring correct polarity (+/-).
4. Close the battery compartment cover securely.

5. Operating Instructions

Image 2: Front view of the clock, showing the large digital display and top buttons.

5.1 Setting the Time

1. Press and hold the SET button (located on the back) until the hour digits begin to flash.
2. Use the UP and DOWN buttons (on the back) to adjust the hour.
3. Press SET again to move to the minute digits.
4. Use the UP and DOWN buttons to adjust the minutes.
5. Press SET to confirm and exit time setting mode.

5.2 Setting Alarms (Alarm 1 & Alarm 2)

This clock supports two independent alarm settings.

1. Press the ALARM 1 button (on the back) once to display Alarm 1 time.
2. Press and hold the ALARM 1 button until the hour digits flash.
3. Use the UP and DOWN buttons to adjust the hour.
4. Press ALARM 1 again to move to the minute digits.
5. Use the UP and DOWN buttons to adjust the minutes.
6. Press ALARM 1 to confirm and exit Alarm 1 setting mode.
7. Repeat the process using the ALARM 2 button for the second alarm.
8. To activate/deactivate an alarm, press the corresponding ALARM 1 or ALARM 2 button briefly. An indicator icon will appear/disappear on the display.

5.3 Snooze Function

When the alarm sounds, press the SNOOZE button (on top of the clock) to temporarily silence the alarm. The alarm will sound again after approximately 9 minutes.

To turn off the alarm completely, press any other button on the back of the clock.

5.4 Brightness Adjustment

The display brightness can be adjusted to suit your preference. Press the LIGHT button (on top of the clock) to cycle through different brightness levels (e.g., High, Medium, Low, Off).

6. Maintenance

• Cleaning: Wipe the clock surface with a soft, dry cloth. Do not use abrasive cleaners or solvents.
• Battery Replacement: If using backup batteries, replace them annually or when the clock fails to retain settings during a power interruption.
• Storage: If storing the clock for an extended period, remove the AAA batteries to prevent leakage.

7. Troubleshooting

8. Specifications

9. Warranty and Support

For warranty information or technical support, please refer to the documentation provided at the time of purchase or contact Acouto customer service through their official website or the retailer where the product was purchased.