CAT Construction Workforce Jumbo Tower Crane Set

1. Introduction

This instruction manual provides comprehensive guidance for the assembly, operation, and maintenance of your CAT Construction Workforce Jumbo Tower Crane Set. Please read this manual thoroughly before use to ensure safe and correct operation. This product is designed for ages 5 and up.

2. Safety Information

• Choking Hazard: Contains small parts. Not suitable for children under 3 years.
• Always supervise children during play.
• Keep the product away from water and excessive moisture.
• Do not attempt to lift objects heavier than recommended by the manufacturer.
• Ensure all parts are securely assembled before operation.

3. Package Contents

Verify that all components listed below are present in your package:

• Tower Crane components
• Remote Control
• Articulated Figure (4 inches)
• Freewheeling Skid Steer Vehicle
• Wrecking Ball attachment
• Hook attachment
• Magnet attachment
• USB Charging Cable

The set includes various parts for the crane structure, a remote control, a construction figure, a skid steer, and multiple attachments for diverse play scenarios.

4. Assembly Instructions

The CAT Construction Workforce Jumbo Tower Crane Set is designed for quick and easy assembly. Follow these steps to set up your crane:

1. Attach the base supports to the main base unit.
2. Connect the tower sections, ensuring they lock securely into place.
3. Mount the crane cabin and boom assembly to the top of the tower.
4. Secure the counterweight section to the rear of the boom.
5. Thread the hoist cable through the designated pulleys and attach the desired lifting accessory (hook, wrecking ball, or magnet).

For a visual guide on assembly and initial setup, please refer to the video below:

5. Battery Installation

The crane unit is USB rechargeable. Use the provided USB cable to charge the crane's internal battery. The remote control requires 2 AA batteries (included).

1. For the Remote Control: Locate the battery compartment on the back of the remote. Open the compartment and insert 2 AA batteries, ensuring correct polarity (+/-). Close the compartment securely.
2. For the Crane Unit: Connect the USB charging cable to the designated port on the crane unit. Plug the other end into a compatible USB power source. The crane's light may indicate charging status.

6. Operating Instructions

Once assembled and powered, use the wireless remote control to operate the crane's functions:

• Rotation: Use the directional controls on the remote to rotate the crane's boom 360 degrees.
• Lifting/Lowering: Use the dedicated buttons to raise or lower the hook and its attached load.
• Trolley Movement: Controls allow the trolley to move along the boom, extending or retracting the hook's reach.
• Working Light: The crane features a built-in light on top that illuminates during operation, enhancing realism.

The set also includes a 4-inch articulated figure and a freewheeling skid steer vehicle for expanded play scenarios.

Observe the crane in action with its various functions:

7. Maintenance

• Clean the crane and accessories with a soft, dry cloth. Do not use harsh chemicals or abrasive materials.
• Store the product in a cool, dry place away from direct sunlight when not in use.
• Remove batteries from the remote control if the toy will not be used for an extended period.

8. Troubleshooting

• Crane not responding: Check if the crane unit is charged and the remote control batteries are correctly installed and have sufficient power. Ensure the crane and remote are within operating range.
• Weak lifting power: Ensure the crane's battery is fully charged. Avoid attempting to lift objects exceeding the crane's capacity.
• Intermittent operation: Check for any obstructions to the remote control's signal or interference from other electronic devices.

9. Specifications

10. Warranty and Support

For warranty information and customer support, please refer to the contact details provided on the product packaging or visit the official Funrise, Inc. website. Keep your purchase receipt as proof of purchase.