Introduction
The VECYS LYCZ628-B is an advanced 3-in-1 bottom-loading water dispenser designed for convenience and efficiency. It provides instant access to hot, cold, and room temperature water, along with integrated ice making capabilities. This manual provides comprehensive instructions for setup, operation, and maintenance to ensure optimal performance and longevity of your appliance.
Figure 1: Front view of the VECYS Bottom Loading Ice Maker Water Dispenser.
Safety Information
Your safety is paramount. Please read and understand all safety precautions before operating the appliance.
- Child Safety Lock: The hot water dispenser is equipped with a two-step child safety lock to prevent accidental dispensing of hot water. Always engage this lock when not in use.
- ETL Approved: This unit is ETL Approved, ensuring it meets recognized safety standards.
- Grounding: For your safety, the machine must be reliably grounded. Insert the plug into a unique socket that is reliably installed in the wall and grounded. Under any circumstances, do not cut off or remove the ground wire from the plug head. The wrong use of grounding wire may be the risk of electric shock. If the power wire is damaged, please contact the after-sales service department.
- Placement: Place the machine in a location where it cannot shine directly and stay away from heat and radiation. Ensure at least 16cm gap between both sides and rear for proper ventilation.
Figure 2: Child safety lock feature on the dispenser.
Setup
- Unpacking: Remove all internal and outer packaging. Open the lower door to check for accessories.
- Placement: Place the machine in a suitable socket to energize.
- Water Bottle Installation:
- Open the door of the machine.
- Prepare a pure water bottle (3 to 5-gallon compatible).
- Remove the water suction pipe from the machine.
- Insert the suction pipe into the bottom of the water bottle. The water dispensing pipe material has been upgraded from silicone to 304 stainless steel.
- Place the water bottle into the bottom of the machine.
- Close the door, ensuring it is securely closed, otherwise the machine cannot pump water normally.
- Initial Water Pumping: Insert the machine power cord into a reliable and safe socket. The power indicator light will always be on. The pump starts pumping water and fills the water tank inside the machine, taking about 5 minutes.
- Self-Clean Mode: For first-time use, it is recommended to clean the internal pipeline. Touch the ice-making button indicator light for 3 seconds, and the machine enters the self-cleaning mode for about 10 minutes.
Figure 3: Recommended placement and dimensions.
Video 1: Official VECYS setup and feature overview for the Bottom Loading 3-in-1 Ice Maker Water Cooler.
Operating Instructions
Dispensing Water
- Hot Water: First, touch the child lock button until the child lock button light is on. Then, touch the hot water button indicator light. The hot water starts to drain into the cup. Watch out for hot water burns.
- Room Temperature Water: Touch the fresh water button to dispense room temperature water.
- Cold Water: Touch the cold water button until the water stops flowing.
Ice Making
- Activate the ice making function by pressing the "Making Ice" button. The machine features a high-performance compressor for efficient ice production.
- The machine makes bullet-shaped ice cubes. It produces approximately 9 pieces per cycle and has a daily ice making capacity of 22 LBS.
- Place a cup under the ice outlet and press the cup against the panel to dispense ice.
- The machine can be switched to energy-saving mode (ECO) to optimize power consumption.
Figure 4: Overview of the 3-in-1 dispensing capabilities.
Figure 5: Details on ice production capacity and type.
Maintenance
- Self-Clean Function: The built-in self-clean function helps clean the water cooler easily and quickly. Refer to the "Setup" section for initial self-cleaning instructions.
- Draining Water: When the machine is not in use for a long time, the water in the machine should be drained. Prepare a bucket and open the drain cover on the back of the machine to remove the remaining water from the tank. After the discharge, replace the discharge cover. The machine can be used normally.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Water dispenser button stuck/unresponsive. | Mechanical issue with the button. | Unplug the unit to stop water flow. Contact customer support for assistance. |
| Water tastes like plastic. | New unit residue or internal material. | Perform multiple self-clean cycles and flush with fresh water. If issue persists, contact customer support. |
| Machine stops making ice and cold water. | Internal malfunction, possibly compressor related. | Ensure proper ventilation. If issue persists, contact customer support. Avoid attempting repairs yourself. |
| Insufficient ice production. | Machine not powered on for long enough (first use). | When the machine is used for the first time, it needs to be powered on for about 1 hour to make ice. If the time is less, there may be insufficient ice. |
Specifications
| Feature | Detail |
|---|---|
| Color | Black |
| Material | Plastic |
| Capacity | 5 Gallons (compatible with 3 to 5-gallon bottles) |
| Product Dimensions | 17.7"D x 14.4"W x 44.1"H |
| Wattage | 100 watts |
| Installation Type | Freestanding |
| Access Location | Bottom |
| Power Source | Corded Electric |
| Ice Making Capacity | 22 LBS/Daily |
| Ice Making Time | 6-8 minutes per cycle (9 pieces/cycle) |
| Water Refrigeration Capacity | 2L (0.53 Gallon)/Hr |
| Water Tank Capacity | 1.5L (0.4 Gallon) |
| Water Temperature Range | 42°F - 212°F |
Figure 6: High-quality compressor for efficient and quiet operation.
Warranty & Support
VECYS is committed to providing excellent service and customer satisfaction. If you encounter any dissatisfaction upon product receipt or experience any issues with the machine's functions, please contact our customer service department immediately for assistance.
For information regarding protection plans, please refer to your purchase documentation or contact your retailer.
For safety, the machine must be reliably grounded. If the power wire is damaged, please contact the after-sales service department.
