Introduction
This manual provides essential information for the safe and effective use of your STASRC 350mAh 7.4V Lipo Battery. Designed for RC ERA C186, BO-105, and E120 RC Helicopters, these batteries offer reliable power for your remote-controlled aircraft. Please read this manual thoroughly before initial use to ensure proper handling, charging, and maintenance.

Image: Front and back view of two STASRC 350mAh 7.4V Lipo Batteries, showing the label with capacity and voltage on one side and a perforated surface on the other.
Product Features
- High Quality Construction: Manufactured from durable materials for extended product lifespan.
- Optimized Performance: Provides 350mAh capacity and 7.4V output for consistent power delivery.
- Ease of Use: Designed for straightforward installation and replacement in compatible RC helicopters.
- Compatibility: Specifically engineered for RC ERA C186, BO-105, and E120 RC Helicopters.
Setup
Before using your new Lipo batteries, it is crucial to perform an initial charge. Always use a compatible Lipo battery charger. Refer to your charger's manual for specific instructions.
- Unpack: Carefully remove the batteries from their packaging.
- Inspect: Check each battery for any visible damage, swelling, or leaks. Do not use damaged batteries.
- Initial Charge: Connect the battery to a compatible 7.4V Lipo charger. Ensure correct polarity. Charge until the charger indicates a full charge.
- Installation: Once charged, carefully insert the battery into the designated battery compartment of your RC ERA C186, BO-105, or E120 RC Helicopter. Ensure a secure fit and proper connection to the helicopter's power system.

Image: Side view of two STASRC 350mAh 7.4V Lipo Batteries. One battery shows the micro-USB charging port, and the other shows the power button and connection pins.
Operating Instructions
These batteries are designed for use with specific RC helicopter models. Always ensure the battery is fully charged before each flight for optimal performance and safety.
- Charging:
Connect the battery to a dedicated Lipo charger. Monitor the charging process and never leave charging batteries unattended. Disconnect once fully charged.
- Installation:
Align the battery with the helicopter's battery slot and gently push until it clicks into place. Ensure the connector is firmly seated.
- Usage:
Operate your RC helicopter according to its own instruction manual. Avoid over-discharging the battery, as this can significantly reduce its lifespan. Most RC helicopters have low-voltage cutoffs to prevent this.
- Removal:
After use, allow the battery to cool down before handling. Disconnect it from the helicopter and remove it from the compartment.
Maintenance
Proper maintenance extends the life and performance of your Lipo batteries.
- Storage:
Store Lipo batteries in a cool, dry place, away from direct sunlight and extreme temperatures. For long-term storage, charge them to a "storage voltage" (typically around 3.8V per cell, consult your charger's manual). Do not store fully charged or fully discharged batteries for extended periods.
- Cleaning:
Wipe the battery exterior with a clean, dry cloth if necessary. Do not use liquids or solvents.
- Inspection:
Regularly inspect batteries for any signs of damage, swelling, or punctures. Discontinue use immediately if any damage is observed.

Image: Top view of two STASRC 350mAh 7.4V Lipo Batteries, highlighting the perforated surface designed for heat dissipation.
Troubleshooting
Refer to the table below for common issues and their potential solutions.
| Problem | Possible Cause | Solution |
|---|---|---|
| Battery not charging. | Incorrect charger, loose connection, damaged battery. | Ensure charger is compatible and connected securely. Inspect battery for damage. Replace if damaged. |
| Short flight time. | Battery not fully charged, aging battery, cold temperature. | Ensure full charge. Consider battery replacement if old. Operate in suitable temperatures. |
| Battery swelling. | Immediately discontinue use. Safely dispose of the battery according to local regulations. |
Specifications
| Attribute | Value |
|---|---|
| Brand | STASRC |
| Model Number | c186 |
| Battery Cell Composition | Lithium Metal |
| Battery Capacity | 350 Milliamp Hours (mAh) |
| Voltage | 7.4V |
| Product Dimensions | 1 x 3 x 1 inches |
| Recommended Uses | RC Helicopter (C186, BO-105, E120) |
| Manufacturer | RC ERA |

Image: Front view of two STASRC 350mAh 7.4V Lipo Batteries, clearly displaying the "RECHARGEABLE LITHIUM ION BATTERY" label with capacity, energy, and voltage details, along with CE and recycling symbols.
Warranty Information
Specific warranty details for this product are not provided in the available information. Please refer to the product packaging or contact the manufacturer, RC ERA, or the seller, STASRC, for warranty terms and conditions.
Support Information
For technical support or further assistance, please contact the product manufacturer, RC ERA, or the brand, STASRC, through their official channels. Contact information may be available on the product packaging or their respective websites.