1. Introduction
This manual provides detailed instructions for the installation, programming, operation, and maintenance of your Avisontek GK-R G1T-BX Genie Garage Door Opener Keypad Remote. Please read these instructions carefully before use to ensure proper functionality and safety.
2. Compatibility
The Avisontek GK-R G1T-BX keypad remote is universally compatible with all Genie and Overhead Door garage door openers manufactured since 1995. It serves as a replacement for models such as GK-R, GK-BX, GWKPD-BL, OKP-BX, GWK-IC, GWKP, ACSDA1, ACSDG, ACSD1G, B8QACSDA1, and B8QACSDA.
Important Note: This device does not support Dip Switch Garage Door Openers.
Image: Compatibility chart for Avisontek GK-R G1T-BX keypad remote.
3. Installation
The Avisontek GK-R G1T-BX keypad remote is designed for effortless wireless installation, requiring no complex wiring or professional assistance. It can be set up in minutes using basic tools.
Mounting the Keypad
- Choose a convenient location outside your garage, within range of your garage door opener.
- Open the keypad cover to expose the mounting holes.
- Mark the positions for the two mounting screws.
- Drill pilot holes if necessary.
- Secure the keypad to the surface using the provided screws.
- Ensure the keypad is firmly attached and the cover can open and close freely.
Image: Wireless keypad installation example.
4. Programming Instructions
Follow these steps to set your Personal Identification Number (PIN) and synchronize the keypad with your garage door opener.
Image: Programming Instruction Guide.
4.1. Setting PIN on Keypad
- Confirm that the keypad backlight is off (do not press any buttons).
- Press 3, 5, 7 on the keypad, then press the PROGRAM button.
- The LED will blink, indicating it is ready to accept a new PIN. Now, enter a unique 3-8 digit PIN number.
- Press the PROGRAM button again.
- The keypad LED will blink twice and then shut off, confirming successful PIN programming.
4.2. Syncing Keypad with Garage Door Opener
There are typically two options to enter programming mode on your garage door opener:
- Option 1: Press and hold the program button on your opener until the LED indicator illuminates, then release. The round LED will turn off and the long LED will begin flashing.
- Option 2: Press and release the 'Learn Code' button. The LED will flash, indicating programming mode (usually for 30 seconds).
Once your opener is in programming mode, proceed with these steps:
- Confirm that the keypad backlight is off (do not press any buttons).
- Enter your previously set PIN on the keypad.
- Press the UP or DOWN arrow key on the keypad 3-4 times until the garage door operates, confirming successful synchronization.
5. Operating Instructions
The Avisontek GK-R G1T-BX keypad remote offers convenient and secure access to your garage.
5.1. Opening/Closing the Garage Door
- To open or close your garage door, simply enter your personalized 3-8 digit PIN on the keypad.
- After entering the PIN, press the UP or DOWN arrow key. The door will activate.
5.2. Enhanced Security Features
- Rolling Code Encryption: The keypad utilizes rolling code technology to prevent unauthorized access, enhancing the security of your property.
- Temporary Password Function: For guests or temporary access, a temporary password function can be set up (refer to your garage door opener's manual for specific instructions on setting temporary codes if supported).
Image: Industrial-grade chip and rolling code encryption.
5.3. User-Friendly Design
- Night Light Function: The keypad features a built-in night light, illuminating the buttons for easy use in low-light conditions.
- Ultra-Long Remote Range: The effective range extends up to 164 feet, providing reliable operation from a distance.
- Multi-Channel Operation: The keypad supports up to 3 channels, allowing control of up to three different garage door motors.
Image: Ultra-long remote range capability.
Image: Weatherproof housing and luminous design.
6. Maintenance
6.1. Battery Replacement
The keypad is powered by a high-capacity AAA Alkaline battery, designed for extended usage and reliability. When the battery power is low, the keypad's performance may degrade, or the backlight may dim. To replace the battery:
- Open the keypad cover.
- Locate the battery compartment, typically at the bottom of the keypad.
- Remove the old AAA Alkaline battery.
- Insert a new AAA Alkaline battery, ensuring correct polarity (+/-).
- Close the battery compartment and the keypad cover.
Image: High-capacity AAA Alkaline battery for extended performance.
6.2. Cleaning
Wipe the keypad surface with a soft, damp cloth. Avoid using abrasive cleaners or solvents, as these may damage the finish or electronic components.
7. Troubleshooting
If you encounter issues with your Avisontek GK-R G1T-BX keypad remote, refer to the following common problems and solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Keypad does not respond | Dead battery | Replace the AAA Alkaline battery (see Section 6.1). |
| Garage door does not open/close after entering PIN | Keypad not programmed or out of sync | Re-program the keypad with your garage door opener (see Section 4.2). Ensure the opener is in programming mode. |
| Limited range | Obstructions or interference | Ensure there are no large metal objects or other sources of radio interference between the keypad and the opener. Check battery level. |
| Keypad backlight not working | Low battery or fault | Replace the battery. If the issue persists, contact customer support. |
| Keypad is not compatible | Opener is a Dip Switch model | This keypad is not compatible with Dip Switch garage door openers. Verify your opener type (see Section 2). |
If these solutions do not resolve the issue, please contact Avisontek customer support for further assistance.
8. Specifications
Below are the technical specifications for the Avisontek GK-R G1T-BX keypad remote:
| Feature | Detail |
|---|---|
| Model | GK-R |
| Working Range | 164 Feet |
| Frequency | 390/315MHz (Auto-Seek Intellicode/CodeDodger Code) |
| Working Voltage | 3V |
| Battery Model | AAA Alkaline (included) |
| Channels | 3 |
| Shell Material | ABS Alloy |
| Color | White |
| Item Weight | 6.7 ounces |
| Package Dimensions | 8.11 x 3.27 x 1.54 inches |
| Special Feature | 10 Year Warranty |
| Compatible Devices | Universal for Genie & Overhead Door Garage Door Opener Since 1995 |
Image: Product Parameter details.
9. Warranty and Support
9.1. Warranty Information
Avisontek provides a 10-year warranty for this product, ensuring long-lasting performance and peace of mind.
9.2. Customer Support
For any queries or assistance, please contact Avisontek customer support. We offer 24-hour Amazon Online Tech Support. You can reach us through our store homepage by clicking "Ask a question" or via our support email. We aim to respond within 24 hours.
Image: After-sales service and support information.
10. Product Videos
No official seller videos are available for this product. The provided videos are from customer reviews and are not embedded as per instructions.