Artisan Power Replacement Battery for Welch Allyn/Hill-ROM 719 Series 71900 Handle - User Manual

1. Introduction

This manual provides essential instructions for the safe and effective use of your Artisan Power Replacement Battery, model MB-71960-L. This battery is designed for 100% compatibility with the Welch Allyn and Hill-Rom 719 Series 71900 Handle and USB Charging Accessory, fully replacing OEM battery numbers 71960 and 90100. Please read this manual thoroughly before installation and operation.

2. Important Safety Information

Always observe the following safety precautions to prevent injury or damage to the battery and device:

• Do not disassemble, short-circuit, or dispose of the battery in fire.
• Keep the battery away from water and excessive heat.
• Use only the specified charging accessory (Welch Allyn/Hill-Rom USB Charging Accessory) for this battery.
• Do not expose the battery to temperatures exceeding 104°F (40°C).
• If the battery shows signs of damage, swelling, or leakage, discontinue use immediately and dispose of it properly.
• Keep out of reach of children.

3. Product Overview

The Artisan Power Replacement Battery is a high-quality Li-ion battery designed to provide reliable power for your medical devices. It features cells made in Japan for maximum run time and cycle life, and is manufactured by Artisan Power, an ISO 13485 Certified company.

Figure 1: Artisan Power Replacement Battery, model 71960. This image shows the cylindrical Li-ion rechargeable battery pack with "Replacement Battery 71960" and "3450 mAh" clearly visible on its label.

Figure 2: The Artisan Power Replacement Battery shown alongside the Welch Allyn/Hill-ROM 71900 Handle, its USB charging accessory, and a USB cable. This illustrates the battery's intended use with the compatible handle and charging setup.

4. Installation

Follow these steps to install the Artisan Power Replacement Battery into your Welch Allyn/Hill-ROM 719 Series 71900 Handle:

1. Ensure the Welch Allyn/Hill-ROM 71900 Handle is powered off and disconnected from any charging source.
2. Locate the battery compartment on the handle. Refer to your Welch Allyn/Hill-ROM 71900 Handle's original manual for specific instructions on opening the compartment.
3. Carefully remove the old battery, if present.
4. Insert the Artisan Power Replacement Battery (MB-71960-L) into the compartment, ensuring correct polarity. The battery should fit snugly.
5. Close the battery compartment securely.
6. It is recommended to fully charge the new battery before its first use.

5. Operating Instructions

5.1 Initial Charge

For optimal performance, fully charge the battery before its initial use. Connect the Welch Allyn/Hill-ROM 71900 Handle with the installed Artisan Power battery to its USB Charging Accessory and a power source.

5.2 Charging the Battery

• Connect the USB Charging Accessory to a compatible USB power adapter or port.
• Place the Welch Allyn/Hill-ROM 71900 Handle (with the Artisan Power battery installed) into the charging accessory.
• Monitor the charging indicator on your Welch Allyn/Hill-ROM 71900 Handle. Refer to your device's manual for details on charging status indicators.
• Once fully charged, disconnect the handle from the charging accessory.

5.3 Battery Usage

The Artisan Power battery is designed for continuous use in the Welch Allyn/Hill-ROM 71900 Handle. The device's power management system will regulate battery discharge. Recharge the battery when the device indicates a low power level.

6. Maintenance and Storage

6.1 General Maintenance

• Keep battery contacts clean and free from debris.
• Avoid extreme temperatures. Operating and charging temperatures should be within the recommended range for your Welch Allyn/Hill-ROM device.
• Do not allow the battery to fully discharge for extended periods, as this can reduce its lifespan.

6.2 Storage

• If storing the battery for an extended period, ensure it is charged to approximately 50-70% capacity.
• Store the battery in a cool, dry place, away from direct sunlight and extreme temperatures.
• Periodically check the battery during long-term storage and recharge it to 50-70% if its charge level drops significantly.

7. Troubleshooting

8. Specifications

9. Warranty and Support

Artisan Power products are manufactured to high standards. For warranty information and technical support, please refer to the official Artisan Power website or contact their customer service directly. Details regarding specific warranty periods may be available on the product packaging or purchase documentation.

Manufacturer: Artisan Power

Website: Visit the Artisan Power Store on Amazon

10. Battery Disposal

Do not dispose of the battery in household waste. Lithium-ion batteries must be recycled or disposed of according to local regulations. Contact your local waste management authority for information on battery recycling programs.