Introduction
This manual provides instructions for the safe and effective use, maintenance, and troubleshooting of your Bissell Pet Hair Eraser Allergen Lift-Off Vacuum, Model 39883. This vacuum is designed for powerful cleaning, featuring a detachable pod for versatile use, a HEPA sealed allergen system, and a tangle-free brush roll for efficient pet hair removal.
Product Overview
The Bissell Pet Hair Eraser Allergen Lift-Off Vacuum combines powerful suction with specialized features for pet owners and allergy sufferers.
- Powerful Suction: Engineered to effectively pick up dirt, fur, and dust from various surfaces.
- Lift-Off Detachable Pod: Allows for lightweight, portable cleaning of stairs, upholstery, and hard-to-reach areas by detaching the canister from the main unit.
- HEPA Sealed Allergen System: Traps 99.97% of dust allergens inside the vacuum, preventing them from re-entering the air.
- Tangle-Free Brush Roll: Designed to prevent hair wrap, ensuring consistent cleaning performance.
- Scatter-Free Technology: Optimizes cleaning on hard floors by minimizing scatter of debris.
- XL Tank Capacity: Features a 1-liter Easy Empty dirt tank for convenient disposal of collected debris.
- Included Tools: Comes with a 2-in-1 Dusting Brush/Crevice Tool and a TURBOERASER Pet Tool for specialized cleaning tasks.
Figure 1: Bissell Pet Hair Eraser Allergen Lift-Off Vacuum 39883.
Setup and Assembly
Your vacuum requires minimal assembly. Ensure all components are present before beginning.
- Insert the handle assembly into the main vacuum body until it clicks securely into place.
- Attach the hose to the back of the vacuum by aligning the tabs and twisting clockwise until it locks.
- Store the included tools (2-in-1 Dusting Brush/Crevice Tool, TURBOERASER Pet Tool) on the designated storage clips on the vacuum.
Figure 2: Fully assembled vacuum cleaner.
Operating Instructions
Using the Vacuum in Upright Mode
- Plug the power cord into a suitable electrical outlet.
- Step on the foot pedal to recline the vacuum handle.
- Turn on the vacuum using the power switch located on the handle. Select the appropriate brush roll setting for your floor type (e.g., "Low Carpet/Bare Floor" or "High Carpet").
- Guide the vacuum across the floor in slow, overlapping passes for optimal cleaning.
Figure 3: Vacuum in upright mode on carpet.
Using the Lift-Off Detachable Pod
- Ensure the vacuum is in the upright position and turned off.
- Press the "Lift-Off" release button to detach the canister from the foot.
- Attach the desired cleaning tool (e.g., crevice tool, TURBOERASER Pet Tool) to the end of the hose or extension wand.
- Turn on the vacuum and use the detached pod for cleaning stairs, upholstery, or other elevated surfaces.
- To reattach, align the pod with the foot and push down until it clicks into place.
Figure 4: Detachable pod used for cleaning stairs.
Figure 5: Using the 2-in-1 Dusting Brush/Crevice Tool.
Figure 6: The TURBOERASER Pet Tool in use on upholstery.
Maintenance
Regular maintenance ensures optimal performance and extends the life of your vacuum.
Emptying the Dirt Tank
- Ensure the vacuum is unplugged.
- Press the tank release button and pull the dirt tank away from the vacuum.
- Hold the tank over a trash bin and press the bottom release button to empty contents.
- Close the bottom flap and reattach the tank to the vacuum until it clicks.
Cleaning Filters
The vacuum features a HEPA sealed allergen system. Filters should be cleaned regularly to maintain suction power.
- Unplug the vacuum.
- Remove the dirt tank. Locate the pre-motor filters (usually foam and pleated filters) inside the top of the dirt tank.
- Remove the filters and tap them against a trash bin to remove loose dirt. Rinse with warm water if heavily soiled, ensuring they are completely dry before reinserting.
- The post-motor HEPA filter is typically located on the side or back of the vacuum. Refer to the diagram for exact location. Remove and clean as per instructions, ensuring it is completely dry before reinstallation.
Figure 7: Removing the HEPA filter for cleaning.
Cleaning the Tangle-Free Brush Roll
- Unplug the vacuum.
- Lay the vacuum flat on its back.
- Inspect the brush roll for any tangled hair or debris. Use scissors to carefully cut away any wrapped hair.
- Ensure the brush roll spins freely.
Figure 8: Inspecting the Tangle-Free Brush Roll.
Troubleshooting
If your vacuum is not performing as expected, refer to the following common issues and solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Vacuum will not turn on | Power cord not securely plugged in; Blown fuse/tripped breaker | Check power cord connection; Check/replace fuse or reset breaker. |
| Loss of suction | Dirt tank full; Filters clogged; Hose or foot clogged | Empty dirt tank; Clean/replace filters; Check hose and foot for blockages. |
| Brush roll not spinning | Brush roll jammed; Belt broken or stretched | Clear debris from brush roll; Inspect and replace belt if necessary (refer to service manual or contact support). |
| Debris scattering on hard floors | Incorrect brush roll setting; Brush roll too high | Ensure "Bare Floor" setting is selected; Adjust brush height if applicable (this model might not have adjustable height, rely on scatter-free tech). |
Specifications
- Brand: Bissell
- Model Name: CleanView Turbo Pet Hair Eraser Allergen Lift-Off
- Model Number: 39883
- Special Features: Anti-Hair Wrap, HEPA Sealed Allergen System, Lift-Off Technology
- Filter Type: HEPA Filter
- Surface Recommendation: All floors
- Power Source: Corded Electric
- Capacity: 1 Liters (Dirt Tank)
- Recommended Uses: Carpet, Floor, Home, Pet Hair
- Indoor/Outdoor Usage: Indoor
- Voltage: 120 Volts
- Form Factor: Upright
- Included Components: Crevice Tool, Dusting Brush, TURBOERASER Pet Tool
- Item Weight: 15.7 pounds
- Item Dimensions (L x W x H): 12.94" x 11.93" x 44.65"
- UPC: 011120277258
Warranty and Support
For warranty information, product registration, or technical support, please visit the official Bissell website or contact their customer service department. Keep your purchase receipt as proof of purchase for any warranty claims.
Online Support: www.bissell.com/support
