Ymimi 1604896

Download PDF
Contents

Ymimi Replacement Filters for Bissell 3437F CleanView Compact Turbo Upright Vacuum, Model 1604896

Instruction Manual

1. Introduction

This manual provides instructions for the installation, maintenance, and replacement of Ymimi replacement filters, compatible with Bissell 3437F CleanView Compact Turbo Upright Vacuum, Part 1604896. Regular filter maintenance is essential for optimal vacuum performance and air quality.

2. Product Overview

The Ymimi replacement filters are designed to capture dust and debris, maintaining the efficiency of your Bissell vacuum cleaner. Each filter consists of a foam layer and a felt layer, working together to provide effective filtration.

Four Ymimi replacement filters, each consisting of a black foam base and a white felt top layer.

Figure 2.1: Four Ymimi Replacement Filters (Part 1604896)

Close-up of a single replacement filter showing dimensions: 4.1 inches in diameter and 0.9 inches in thickness.

Figure 2.2: Filter Dimensions (Approximately 4.1 inches diameter, 0.9 inches thickness)

3. Installation

To install the replacement filter, follow these steps:

  1. Ensure the vacuum cleaner is unplugged from the power outlet.
  2. Locate the dirt tank on your Bissell CleanView Compact Turbo Upright Vacuum.
  3. Remove the dirt tank from the vacuum cleaner.
  4. Open the dirt tank to access the existing filter.
  5. Carefully remove the old, dirty filter. Note the orientation of the filter for correct installation of the new one.
  6. Place the new Ymimi replacement filter into the designated slot within the dirt tank. Ensure the filter is seated correctly and aligns with any grooves or tabs.
  7. Close the dirt tank securely and reattach it to the vacuum cleaner.
A Bissell CleanView Compact Turbo Upright Vacuum next to two replacement filters, one assembled and one disassembled to show its two layers.

Figure 3.1: Replacement filters positioned next to a compatible Bissell vacuum.

Video 3.1: Demonstration of filter replacement for a compatible Bissell Cleanview vacuum. This video illustrates the general process of accessing and replacing vacuum filters, which is similar for the Bissell 3437F model.

4. Maintenance

Regular cleaning and timely replacement of your vacuum filters are crucial for maintaining suction power and extending the life of your vacuum cleaner.

4.1. Cleaning the Filter

The Ymimi replacement filters are washable and reusable. To clean:

  1. Remove the filter from the vacuum as described in the installation section.
  2. Tap the filter gently over a trash can to remove loose dirt and debris.
  3. Rinse the filter under cool, running water until the water runs clear. Do not use detergent or hot water.
  4. Allow the filter to air dry completely for at least 24 hours before reinserting it into the vacuum. Ensure it is completely dry to prevent mold or damage to the vacuum.
A hand rinsing a replacement vacuum filter under running water in a sink.

Figure 4.1: Washing a reusable filter under cool water.

4.2. Replacement Schedule

For optimum performance, it is recommended to replace the vacuum filter every 3-6 months, depending on usage frequency and household conditions (e.g., pets, allergies).

Diagram showing the two layers of the filter (foam and felt) and a text overlay stating 'Vacuum Filter Should Be Replaced Every 3-6 Months For Optimum Performance'.

Figure 4.2: Recommended filter replacement interval.

5. Troubleshooting

If you experience reduced suction or notice an unusual odor from your vacuum cleaner, consider the following:

  • Reduced Suction: A clogged or dirty filter is a common cause of reduced suction. Clean or replace the filter as per the maintenance instructions. Ensure the dirt tank is empty and properly sealed.
  • Unusual Odor: A dirty filter can harbor bacteria and cause unpleasant odors. Clean the filter thoroughly or replace it with a new one.

6. Specifications

BrandYmimi
Model Number1604896
Compatible DevicesBissell 3437F CleanView Compact Turbo Upright Vacuum
MaterialFoam
Dimensions4.13 x 4.13 x 1.01 inches
ReusabilityReusable (Washable)
Included Components3437f filter (4-pack)

7. Warranty and Support

For any product-related inquiries or if you encounter issues with the filters, please contact Ymimi customer support. The manufacturer provides after-sales service and aims to reply within 24 hours.

Note: Specific warranty details may vary. Please refer to your purchase documentation for complete information.

© 2025 Ymimi. All rights reserved.

Documents and downloads

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.