1. Introduction
Thank you for choosing the Sannover Sanos2000 Electric Wall Radiator. This manual provides essential information for the safe and efficient operation, installation, and maintenance of your new radiator. Please read this manual thoroughly before installation and use, and keep it for future reference.
The Sanos2000 is designed to provide comfortable and energy-efficient heating for your living spaces, featuring a modern design, a touch-LED control panel, and various programmable operating modes.
2. Safety Instructions
WARNING: To reduce the risk of fire, electric shock, or injury, always follow these basic precautions:
- Read all instructions before using this heater.
- This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains, at least 1 meter (3 feet) from the front of the heater and keep them away from the sides and rear.
- Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended.
- Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped, or damaged in any manner. Return heater to authorized service facility for examination, electrical or mechanical adjustment, or repair.
- Do not use outdoors.
- This heater is not intended for use in bathrooms, laundry areas, and similar indoor locations. Never locate heater where it may fall into a bathtub or other water container.
- Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Arrange cord away from traffic area and where it will not be tripped over.
- To disconnect heater, turn controls to off, then remove plug from outlet.
- Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater.
- To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked.
- A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable vapors or liquids are used or stored.
- Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.
- Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or relocatable power tap (outlet/power strip).
- Ensure the power supply voltage matches the rating label on the appliance.
- Installation and diagnosis of malfunctions must be performed by a qualified professional according to applicable standards.
3. Package Contents
Upon opening the package, please ensure all components are present and undamaged. If any items are missing or damaged, contact your retailer immediately.
- Sannover Sanos2000 Electric Wall Radiator
- Wall mounting bracket(s)
- Mounting screws and wall plugs
- User Manual (this document)
4. Product Overview
The Sanos2000 electric radiator combines elegant design with advanced heating technology to provide optimal comfort and energy efficiency. It features a user-friendly touch-LED panel for easy control.
Figure 1: Angled front view of the Sannover Sanos2000 Electric Wall Radiator, showing the sleek white design and integrated digital display on the right side.
Figure 2: Front view of the Sannover Sanos2000 Electric Wall Radiator, highlighting the touch-LED control panel with temperature display and control buttons.
Key Features:
- Touch-LED Panel: Intuitive control for temperature and settings.
- Multiple Operating Modes: Comfort, Economic, Frost Protection, Sleep, and Programmable modes.
- Fast Heating: Quickly reaches desired temperature.
- Programmable: Set schedules for heating to optimize energy consumption.
- Modern Design: Slim and elegant, suitable for various interior styles.
- Wall-Mount Installation: Easy and secure mounting.
5. Setup and Installation
The Sanos2000 radiator is designed for easy wall-mount installation. Ensure you have the necessary tools (drill, screwdriver, level, measuring tape) and follow local electrical codes.
Installation Steps:
- Choose Location: Select a suitable wall location, away from curtains, furniture, and direct water sources. Ensure there is sufficient clearance around the radiator for proper air circulation (at least 15 cm from the floor and ceiling, and 20 cm from adjacent walls).
- Mark Drilling Points: Use the provided mounting bracket as a template to mark the drilling points on the wall. Use a level to ensure the marks are horizontal.
- Drill Holes: Drill holes at the marked points using an appropriate drill bit for your wall type. Insert the wall plugs.
- Attach Bracket: Securely fasten the mounting bracket to the wall using the provided screws.
- Mount Radiator: Carefully lift the radiator and hook it onto the mounting bracket. Ensure it is securely seated.
- Electrical Connection: Plug the radiator into a grounded electrical outlet. Ensure the outlet meets the power requirements of the radiator (230V, 2000W). If hardwiring is required, this must be done by a qualified electrician.
Figure 3: Back view of the Sannover Sanos2000 Electric Wall Radiator, illustrating the integrated mounting brackets for wall installation.
Important: Always ensure the radiator is securely mounted before connecting it to power. Do not cover the radiator during operation.
6. Operating Instructions
The Sanos2000 radiator is controlled via its integrated touch-LED panel. The panel typically displays the current temperature and allows you to select operating modes and adjust settings.
Basic Operation:
- Power On/Off: Press the power button on the control panel to turn the radiator on or off.
- Temperature Adjustment: Use the '+' and '-' buttons to set your desired temperature. The display will show the target temperature.
- Mode Selection: Press the 'Mode' button to cycle through the available operating modes:
- Comfort Mode: Maintains a constant, comfortable temperature.
- Economic Mode: Operates at a slightly lower temperature to save energy.
- Frost Protection Mode: Maintains a minimum temperature (e.g., 7°C) to prevent freezing.
- Sleep Mode: Gradually reduces temperature for comfortable sleep.
- Program Mode: Allows you to set custom heating schedules for different times of the day and week.
- Programming: Refer to the detailed programming section in the full manual (if available) or on the manufacturer's website for setting custom schedules in Program Mode. This typically involves setting desired temperatures for specific time slots.
7. Maintenance
Regular maintenance ensures the longevity and efficient operation of your radiator. Always disconnect the power before performing any maintenance.
Cleaning:
- Exterior: Wipe the exterior surfaces with a soft, damp cloth. Do not use abrasive cleaners, solvents, or harsh chemicals, as these can damage the finish.
- Air Vents: Periodically vacuum the air intake and exhaust vents to remove dust and debris. Ensure vents are clear for optimal airflow.
- Storage: If storing the radiator for an extended period, ensure it is clean and dry. Store it in a cool, dry place, preferably in its original packaging.
No other user-serviceable parts are inside. For any repairs, contact a qualified service professional.
8. Troubleshooting
If you encounter issues with your Sanos2000 radiator, please consult the following troubleshooting guide before contacting support.
| Problem | Possible Cause | Solution |
|---|---|---|
| Radiator does not turn on. | No power supply; power button not pressed; circuit breaker tripped. | Check if the power cord is securely plugged in. Press the power button. Check your household circuit breaker. |
| Radiator is on but not heating. | Temperature setting is too low; mode is set to Frost Protection or off. | Increase the target temperature. Select a heating mode (Comfort or Economic). |
| Radiator makes unusual noises. | Normal expansion/contraction sounds; loose mounting. | Minor clicking sounds are normal as the metal heats and cools. Ensure the radiator is securely mounted to the wall. |
| Display is not working. | Power issue; internal fault. | Check power supply. If power is present and display remains off, contact support. |
If the problem persists after trying these solutions, please contact customer support.
9. Specifications
| Brand: | Sannover Thermique |
| Model Number: | Sanos2000 |
| Heat Output: | 2000 Watt |
| Voltage: | 230 Volt |
| Power Source: | Electric with cord |
| Mounting Type: | Wall Mount |
| Product Dimensions (D x W x H): | 10.5D x 94W x 40H centimeters |
| Item Weight: | 7 Kilograms |
| Color: | White |
| Special Feature: | Fast heating, Programmable |
10. Warranty and Support
Warranty: This product is covered by a legal conformity guarantee for two years from the date of delivery. Additionally, a manufacturer's warranty may apply for a period, typically two years, on spare parts. The manufacturer's warranty is valid only if installation and diagnosis of malfunctions are performed by a qualified professional according to applicable standards.
Customer Support: For technical assistance, warranty claims, or any questions regarding your Sannover Sanos2000 Electric Wall Radiator, please contact your retailer or the manufacturer's customer service. Please have your purchase receipt and product model number (Sanos2000) ready when contacting support.
For more information, you may visit the Sannover Thermique brand page.