Introduction
Thank you for choosing the WELLFOR NK Faucet Bathroom Waterfall Faucet. This manual provides essential information for the safe installation, operation, and maintenance of your new faucet. Please read these instructions thoroughly before installation and keep them for future reference.
Safety Information
- Always turn off the main water supply before installing or performing any maintenance on the faucet.
- Wear appropriate personal protective equipment, such as safety glasses, during installation.
- Ensure all connections are secure to prevent leaks.
- If you are unsure about any part of the installation process, consult a qualified plumber.
- This product is designed for bathroom sink use only.
Package Contents
Verify that all components are present before beginning installation:
- WELLFOR NK Faucet (Main Body)
- Single Handle
- Deck Plate
- Pop-Up Drain Assembly
- Mounting Hardware
- Hot and Cold Water Supply Lines
Setup and Installation
The WELLFOR NK Faucet is designed for easy deck-mount, vessel installation. Follow these general steps for installation. Specific details may vary based on your sink and plumbing setup.
- Prepare the Sink: Ensure the sink hole is clean and appropriately sized for the faucet. If using a deck plate, place it over the sink hole.
- Mount the Faucet: Insert the faucet body through the sink hole (and deck plate, if used). From underneath the sink, secure the faucet with the provided washer and mounting nut. Tighten firmly but do not overtighten.
- Connect Water Supply Lines: Attach the hot and cold water supply lines to the corresponding inlets on the faucet body. Connect the other ends to your hot and cold water supply valves. Ensure all connections are hand-tight, then use a wrench for a final quarter-turn.
- Install Pop-Up Drain: Follow the instructions provided with the pop-up drain assembly to install it into your sink's drain opening. Connect the drain linkage (if applicable) to the faucet.
- Test for Leaks: Slowly turn on the main water supply. Check all connections for leaks. If leaks occur, tighten the connections further.
Figure 1: Technical diagram showing the dimensions of the WELLFOR NK Faucet, including spout height (10.03 inches), spout reach (4.92 inches), and base measurements. This diagram is essential for planning installation and ensuring compatibility with your sink.
Figure 2: Image of the WELLFOR waterfall faucet installed on a bathroom sink, with water flowing into the basin. This illustrates the faucet's appearance and water delivery in a typical setup.
Operating Instructions
The WELLFOR NK Faucet features a single handle for controlling both water temperature and flow.
- Water Flow: Lift the handle upwards to turn on the water and increase flow. Push the handle downwards to decrease flow and turn off the water.
- Water Temperature: Move the handle to the left for hot water and to the right for cold water. Adjust the handle position between left and right to achieve the desired water temperature.
- Waterfall Spout: The faucet delivers a clear and steady laminar waterfall stream, enhancing the aesthetic and user experience.
Figure 3: A hand adjusting the single handle of the WELLFOR faucet, demonstrating how to control water flow and temperature.
Figure 4: Hands placed under the flowing waterfall stream from the faucet, illustrating the water delivery pattern.
Maintenance
Regular cleaning and maintenance will ensure the longevity and optimal performance of your WELLFOR faucet.
- Cleaning: Clean the faucet regularly with a soft cloth and mild soap. Avoid abrasive cleaners, harsh chemicals, or scouring pads, as these can damage the oil rubbed bronze finish.
- Water Spots: To prevent water spots, wipe the faucet dry after each use.
- Aerator (if applicable): Periodically check and clean the aerator (if present) to remove any mineral buildup that might affect water flow.
Troubleshooting
If you encounter issues with your faucet, refer to the following common problems and solutions:
- Low Water Flow:
- Check if the water supply valves are fully open.
- Inspect the supply lines for kinks or obstructions.
- Clean the aerator (if applicable) for mineral buildup.
- Leaks from Faucet Base:
- Ensure the mounting nut under the sink is securely tightened.
- Check the O-rings and gaskets for proper seating and damage.
- Leaks from Handle:
- This may indicate an issue with the internal cartridge. Contact customer support for assistance.
- No Hot or Cold Water:
- Verify that the hot/cold water supply valves are open.
- Check if the hot/cold supply lines are correctly connected to the faucet.
Specifications
| Feature | Detail |
|---|---|
| Brand | WELLFOR |
| Model Name | NK faucet |
| Mounting Type | Deck Mount |
| Installation Type | Vessel |
| Finish Type | Oil Rubbed Bronze |
| Material | Brass, Ceramic (Handle) |
| Number of Handles | 1 |
| Maximum Flow Rate | 1.2 Gallons Per Minute |
| Spout Height | 10.03 Inches |
| Spout Reach | 4.92 Inches |
| Product Dimensions | 4.56"D x 4.56"W x 6.61"H |
| Item Weight | 2.6 Pounds |
| Special Features | Lead Free, Lightweight, Pop Up Drain |
| UPC | 769047275092 |
Warranty and Support
WELLFOR products are manufactured to high-quality standards and are backed by a manufacturer's warranty. For specific warranty details, claims, or technical support, please refer to the warranty card included with your product or visit the official WELLFOR website. Please have your model number (NK faucet) and purchase information ready when contacting support.
