Jugbow Dog Shock Collar Instruction Manual

1. Introduction

The Jugbow DT-612 Dog Shock Collar is designed to assist in training dogs weighing between 10-120 lbs. It features a remote control with a range of up to 4200 feet and supports training for up to two dogs simultaneously. The system offers four distinct training modes: beep, vibration, safe shock, and shock boost, allowing for tailored correction based on your dog's needs and behavior. The receiver collar is IPX7 waterproof, ensuring durability in various environmental conditions.

Figure 1: Jugbow Dog Shock Collar Remote and Receiver Collars

2. Components Included

The Jugbow DT-612 package includes the following components:

• Remote Control
• Receiver Collars (quantity may vary based on package, typically one or two)
• Metal Prongs and Silicone Caps
• Adjustable Nylon Collar Strap
• USB Charging Cable (3-in-1 for simultaneous charging)

3. Setup and Pairing

3.1 Initial Charging

Before first use, fully charge both the remote control and the receiver collars. The included 3-in-1 USB cable allows for simultaneous charging. A full charge typically takes approximately 2 hours.

Figure 2: Charging the Remote and Receiver Collars

3.2 Powering On/Off

To power on the receiver collar, press and hold the power button for three seconds until the red light turns on. Release the button, then long press again until the green light flashes. To power off, long press the power button until the indicator light turns off.

Figure 3: Powering On the Receiver Collar

3.3 Channel Selection (for multiple collars)

The remote supports dual channels for training two dogs. The channel selection is factory set. Typically, a black strap receiver selects channel 1, and a green strap receiver selects channel 2. Ensure the remote is set to the corresponding channel for the collar you intend to use.

Figure 4: Remote Channel Selection

3.4 Testing the Collar

To test the collar's functions, place the provided test tool over the metal prongs. Press any of the Beep, Vibration, or Shock buttons on the remote. If you hear a "beep" for sound, feel vibration for vibration mode, or see the test light flash for shock mode, the function is working correctly.

Figure 5: Testing Collar Functions

Figure 6: Testing Shock Function with Test Tool

4. Operating Modes

The Jugbow DT-612 offers four humane and effective training modes:

• Beep Mode: Provides an audible tone (1-8 levels).
• Vibration Mode: Delivers a tactile vibration (1-16 levels).
• Safe Shock Mode: Applies a static correction (1-99 levels).
• Shock Boost: Provides a slightly higher static correction (10% higher than the set shock level).

Adjust the intensity levels for each mode using the dial on the remote control to suit your dog's temperament and the training situation.

Figure 7: Four Effective Training Modes

5. Usage Guidelines

5.1 Remote Range

The remote control provides a strong and stable signal up to 4200 feet, allowing for effective training in various outdoor environments such as backyards, parks, or beaches.

Figure 8: Up to 4200ft Remote Range

5.2 Collar Fit and Sizing

The collar is made of skin-friendly, comfortable soft nylon with a two-way adjustable strap. It is suitable for dogs weighing over 10 lbs with neck sizes ranging from 7.8 to 24.4 inches, accommodating small, medium, and large breeds. Ensure a snug but comfortable fit to ensure proper contact of the prongs with the dog's skin.

Figure 9: Replaceable & Adjustable Collar Strap

5.3 Safety Features

The remote control includes a security ON/OFF switch to prevent accidental activation of correction modes. This ensures safe handling and prevents unintended shocks.

Figure 10: Security ON/OFF Switch and Dual Channel

5.4 Important Note on Wear Time

The collar should not be worn continuously for more than 12 hours without removing the metal prongs to prevent skin irritation.

6. Maintenance

6.1 Cleaning

Wipe the collar with a damp cloth as needed. The receiver collar is waterproof and can be rinsed under water. Do not use harsh chemicals or submerge the remote control in water.

6.2 Battery Life and Charging

The upgraded technology provides super long battery life. The e-collar can last up to 35 days on standby, and the remote up to 45 days. Both units fully charge in approximately 2 hours.

Figure 11: Long Lasting Battery Life

6.3 Waterproofing

The receiver collar boasts an IPX7 waterproof rating, making it suitable for use in all weather conditions, including splashes, rain, bathing, and swimming. The remote control is not waterproof.

Figure 12: 100% IPX7 Waterproof Receiver

7. Troubleshooting

If you encounter issues with your Jugbow Dog Shock Collar, consider the following common troubleshooting steps:

• No Response from Collar: Ensure both the remote and collar are fully charged and powered on. Verify that the remote is set to the correct channel for the collar. Check that the metal prongs are making proper contact with your dog's skin.
• Inconsistent Correction: Adjust the collar's fit to ensure consistent contact. Clean the contact points on the collar and your dog's neck.
• Reduced Range: Ensure there are no significant obstructions between the remote and the collar. Low battery levels can also affect range.
• Accidental Activation: Utilize the security ON/OFF switch on the remote to prevent unintended corrections.

For persistent issues, refer to the detailed troubleshooting section in the full user manual or contact Jugbow customer support.

8. Specifications

9. Warranty and Support

The Jugbow DT-612 Dog Shock Collar comes with a 1-Year Warranty. For any questions, technical support, or warranty claims, please contact Jugbow customer service. Multi-channel service including email, phone, and live chat may be available as detailed in the full user manual.

Figure 13: After-Sales Service Information