Mebus 13080 Radio-Controlled Silent Wall Clock

Introduction

This manual provides instructions for the setup, operation, and maintenance of your Mebus 13080 Radio-Controlled Silent Wall Clock. This clock features automatic time synchronization via a radio signal (DCF77), a silent movement, and a clear 30 cm diameter display, making it suitable for various indoor environments.

Front view of the Mebus 13080 radio-controlled wall clock, showcasing its white frame, white dial, and clear black numbers.

Setup

1. Unpacking and Inspection

Carefully remove the clock from its packaging. Inspect the clock for any visible damage. Ensure all components are present.

2. Battery Installation

1. Locate the battery compartment on the back of the clock.
2. Insert one (1) AA battery (not included) into the compartment, ensuring the correct polarity (+/-).
3. Close the battery compartment cover securely.

Rear view of the Mebus 13080 wall clock, showing the battery compartment and the radio signal receiver icon.

3. Initial Synchronization

After battery installation, the clock hands will automatically move to the 12 o'clock position. The clock will then attempt to receive the DCF77 radio time signal. This process can take several minutes to an hour, depending on signal strength. Once the signal is received, the clock will automatically set itself to the correct time.

4. Mounting

The clock is designed for wall mounting. Use a suitable screw or hook (not included) in your desired location. Ensure the mounting point is secure enough to hold the clock's weight (approximately 673 grams).

The Mebus 13080 wall clock highlighting its 30 cm diameter, radio-controlled automatic time setting, and silent movement.

Operation

Automatic Time Adjustment

Your Mebus 13080 clock is radio-controlled and will automatically adjust to the precise time, including changes for daylight saving time (summer/winter time). The clock regularly checks the DCF77 signal to maintain accuracy.

Signal Reception Tips

• Place the clock away from electronic devices that may cause interference (e.g., TVs, computers, microwaves).
• Optimal reception is usually near a window and away from large metal objects.
• Avoid placing the clock in basements or rooms with thick concrete walls, as this can hinder signal reception.

Maintenance

Cleaning

To clean the clock, wipe it with a soft, dry cloth. Do not use abrasive cleaners, solvents, or chemical sprays, as these can damage the finish and internal components.

Battery Replacement

When the clock hands stop moving or the time becomes inaccurate, it is likely time to replace the battery. Follow the battery installation steps in the Setup section to replace the AA battery. Dispose of used batteries responsibly.

Troubleshooting

• Clock not setting time or displaying incorrect time:
  - Ensure the battery is new and correctly installed.
  - Move the clock to a different location, preferably near a window, to improve radio signal reception.
  - Allow up to 24 hours for the clock to receive the signal and set itself, especially after initial setup or battery change.
• Clock hands are stuck or not moving:
  - Check if the battery needs replacement.
  - Ensure there are no obstructions preventing the hands from moving freely.
• Clock is making noise:
  - This model features a silent movement. If you hear any noise, check for obstructions or contact support.

Specifications

Image illustrating the 30 cm diameter and 532g weight of the Mebus 13080 clock, along with the requirement for 1x AA battery (not included).

Warranty and Support

Warranty Information

This Mebus 13080 wall clock comes with a 1-year limited warranty. Please retain your proof of purchase for warranty claims. The warranty covers manufacturing defects under normal use.

Customer Support

For further assistance, technical support, or warranty inquiries, please refer to the contact information provided with your purchase or visit the official Mebus website.