OLOV Budhha
OLOV Multi-Grooming Kit Trimmer
Instruction Manual - Model: Budhha
Introduction
Thank you for choosing the OLOV Multi-Grooming Kit Trimmer. This device is designed for precision trimming of facial hair, head hair, and body hair. Please read this manual carefully before first use to ensure safe and optimal performance. Keep this manual for future reference.
Important Safety Information
- This appliance is not intended for use by persons with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Keep the appliance dry. Do not immerse it in water or use it in wet conditions.
- Do not use the appliance if the blades are damaged or broken, as this may cause injury.
- Keep out of reach of children.
- Only use the charger supplied with the appliance.
- Unplug the appliance before cleaning.
Package Contents
Verify that all items are present in the package:
- OLOV Multi-Grooming Kit Trimmer (Model: Budhha)
- Charging Cable
- Guide Combs (1.5mm, 2mm, 3mm, 4mm)
- Cleaning Brush
- User Manual
Setup
1. Charging the Trimmer
Before first use, fully charge the trimmer. Connect the charging cable to the trimmer's charging port and plug the other end into a suitable power source. The charging indicator light will illuminate. A full charge typically takes approximately 2 hours and provides up to 90 minutes of cordless operation.
Image: The OLOV trimmer showing its internal components, including the motor, blade assembly, and the USB charging port at the base. This image illustrates where the charging cable connects.
2. Attaching Guide Combs
Select the desired guide comb (1.5mm, 2mm, 3mm, or 4mm) for your preferred hair length. Align the comb with the trimmer blade and push it firmly until it clicks into place. To remove, gently pull the comb away from the blade.
Image: The OLOV trimmer displayed alongside four different guide comb attachments, indicating their respective lengths (1.5mm, 2mm, 3mm, 4mm). This shows the available options for hair length adjustment.
Operating Instructions
1. Powering On/Off
Press the power button located on the trimmer body to turn the device on. Press it again to turn it off.
2. Trimming Techniques
For best results, ensure hair is clean and dry. Hold the trimmer with the blade flat against the skin or at the desired angle for shaping. Move the trimmer slowly against the direction of hair growth.
- Beard Trimming: Use a guide comb for an even length or use the bare blade for precise edging and shaping around the neckline and cheekbones.
- Hair Clipping: Attach the appropriate guide comb. Start from the bottom of the head and move upwards, against the direction of hair growth.
- Body Grooming: For sensitive areas, use a guide comb to prevent direct contact with the skin. Move the trimmer gently and slowly.
- Detailing and Engraving: The trimmer features a zero-degree head and short pitch engraving knives for intricate designs and sharp lines. Use without a guide comb for these applications.
Image: A person using the OLOV cordless hair clippers to trim hair, demonstrating its application for head grooming. The image highlights the low noise operation and precision.
Image: A four-panel illustration showing the OLOV trimmer being used on different body parts: face (beard trimming), body (chest hair), arm (armpit hair), and hair (hairline detailing). This demonstrates its multi-grooming capabilities.
Image: A detailed close-up of the trimmer's blade, emphasizing its ultra-short pitch design and the 'R type obtuse angle' for skin protection and precise cutting.
Image: The OLOV trimmer next to a decibel meter displaying a reading of 57.5 dBA, illustrating its low operation noise level (below 60db) for a quieter grooming experience.
Image: An X-ray style view of the OLOV trimmer highlighting its powerful motor and the design of its groove teeth T-blade, engineered for efficient and precise short hair cutting.
Image: A close-up of the OLOV trimmer's short pitch engraving knives, demonstrating their capability for detailed styling, oil head designs, and intricate trimming.
Maintenance
1. Cleaning the Blades
After each use, turn off the trimmer and remove any attached guide comb. Use the provided cleaning brush to remove loose hairs from the blade area. For a more thorough cleaning, the blade head can be carefully detached and rinsed under running water. Ensure the blade is completely dry before reattaching or storing.
2. Oiling the Blades
Periodically, apply a small drop of clipper oil (not included) to the blades to maintain optimal cutting performance and prolong blade life. Turn the trimmer on for a few seconds to distribute the oil evenly.
3. Storage
Store the trimmer in a cool, dry place, away from direct sunlight and moisture. Ensure the trimmer is turned off before storing.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Trimmer does not turn on. | Battery is depleted. | Charge the trimmer fully. |
| Trimmer pulls hair or cuts poorly. | Blades are dull or clogged with hair. | Clean and oil the blades. If blades are dull, consider replacement. |
| Trimmer makes unusual noise. | Blades are not properly aligned or need oiling. | Ensure blades are clean and oiled. Check for proper blade attachment. |
Specifications
- Model Number: Budhha
- Brand: OLOV
- Product Dimensions: 8 x 3 x 3 cm
- Material: Stainless Steel (Blade)
- Special Feature: Portable, Rechargeable
- Recommended Uses: Beard Styling, Clipping, Shaving
- Target Audience: Unisex
- Power Source: Battery Powered (Rechargeable)
- Color: Gold
Warranty and Support
For warranty information or technical support, please refer to the contact details provided at the point of purchase or visit the official OLOV website. Keep your purchase receipt as proof of purchase for any warranty claims.