V-TAC LED Strip Controller - Model 23610 User Manual

1. Introduction

Thank you for choosing the V-TAC LED Strip Controller, Model 23610. This device is designed to provide remote control over your LED strip lighting, allowing for adjustments in speed, brightness, and various lighting modes. Please read this manual carefully before installation and operation to ensure proper use and longevity of the product.

2. Safety Instructions

• Ensure the power supply is disconnected before any installation or maintenance.
• This product is designed for use with compatible LED strips and power supplies. Refer to the specifications for power ratings.
• Do not expose the controller to moisture, extreme temperatures, or direct sunlight.
• Do not attempt to open or modify the controller. This will void the warranty and may cause damage or injury.
• Keep out of reach of children.

3. Package Contents

• V-TAC LED Strip Controller (Model 23610)
• User Manual

4. Setup and Installation

1. Ensure all components (LED strip, power supply, controller) are compatible and rated for the intended use.
2. Connect the LED strip to the output terminals of the V-TAC controller. Pay close attention to polarity (positive to positive, negative to negative).
3. Connect the power supply to the input terminals of the V-TAC controller. Ensure correct polarity.
4. Once all connections are secure, connect the power supply to a suitable power outlet.
5. The LED strip should now be ready for operation.

5. Operating Instructions

The V-TAC LED Strip Controller features three primary buttons for controlling your LED strip:

Image: V-TAC LED Strip Controller showing the 'SPEED/BRIGHT', 'ON/OFF', and 'MODE' buttons.

5.1. ON/OFF Button

• Press the button labeled "ON/OFF" to turn the LED strip lights on or off.

5.2. SPEED/BRIGHT Button

This button controls both the speed of dynamic modes and the brightness of static colors.

• When the lights are ON, press the "SPEED/BRIGHT" button. The controller will enter speed adjustment mode for dynamic lighting effects. Pressing it repeatedly will cycle through different speed levels.
• To adjust brightness, press the "SPEED/BRIGHT" button again after adjusting speed (or if the light is in a static color mode). The controller will enter brightness adjustment mode. Pressing it repeatedly will cycle through different brightness levels.
• Pressing "ON/OFF" after adjusting speed or brightness will save the current setting.

5.3. MODE Button

• Press the button labeled "MODE" to cycle through the 10 different pre-programmed lighting modes.

6. Maintenance

• Clean the controller with a soft, dry cloth. Do not use abrasive cleaners or solvents.
• Ensure the controller remains free from dust and debris to prevent overheating.
• Regularly check all connections for security.

7. Troubleshooting

• Lights not turning on: Check all power connections. Ensure the power supply is working and the LED strip is correctly connected to the controller with correct polarity.
• Remote not responding: Ensure the controller is within range and there are no obstructions.
• Inconsistent lighting: Verify that the LED strip and power supply are compatible with the controller's specifications. Check for loose connections.

8. Specifications

9. Warranty and Support

V-TAC products are manufactured to high standards and come with a standard warranty. For specific warranty details, please refer to the documentation provided with your purchase or visit the official V-TAC website. For technical support or further assistance, please contact your retailer or V-TAC customer service.