FOGATTI InstaShower 9 Pro RV Tankless Water Heater User Manual

1. Introduction

Welcome to the FOGATTI InstaShower 9 Pro RV Tankless Water Heater user manual. This document provides essential information for the safe and efficient installation, operation, and maintenance of your new tankless water heater. Please read this manual thoroughly before installation and use to ensure proper function and longevity of the appliance.

2. Important Safety Information

Failure to follow these instructions could result in fire, explosion, property damage, personal injury, or death.

• Read all instructions before installing or operating this appliance.
• Improper installation, adjustment, alteration, service, or maintenance can cause injury or property damage.
• This appliance must be installed by a qualified service technician.
• Ensure all gas and water connections are properly sealed and tested for leaks.
• Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
• Always turn off gas and water supply before performing any maintenance or service.
• This product is CSA certified, ensuring compliance with safety standards.

3. Product Overview

3.1 Key Features

• High Capacity Heating: 66,000 BTU heat output, providing up to 3.6 Gallons Per Minute (GPM) of hot water.
• Instant Hot Water: Tankless design ensures hot water on demand without waiting.
• Built-in Mixing Tank: A 13.5 oz mixing tank helps stabilize water temperature and prevent fluctuations.
• Altitude Performance: Operates smoothly at altitudes up to 9,800 feet.
• Wind Resistance: Upgraded NIDEC fan delivers 300Pa of power, ensuring operation in winds up to Beaufort scale 9.
• Temperature Control: Precise temperature control within ±1°F.
• Seasonal Burner Adaptation: Two rows of flames in summer to prevent overheating, all five rows in winter for warmth.
• Safety Features: Includes anti-freezing protection, dry combustion protection, flame failure protection, high water pressure protection, and overheat protection.
• Included Accessories: 150 PSI pressure relief valve, 15 x 15-inch door, 17.64 x 17.64-inch trim ring, and an intelligent remote controller with up to 6.6 feet range.
• Compatibility: Designed to replace Suburban & Atwood 6-gallon tank water heaters and Girard & Furrion tankless water heaters (with appropriate door size).

3.2 Components

• FOGATTI InstaShower 9 Pro RV Tankless Water Heater Unit
• Wired Remote Controller
• 150 PSI Pressure Relief Valve
• 15" x 15" Door (White)
• 17.64" x 17.64" Trim Ring
• Filter Screen

4. Technical Specifications

5. Setup and Installation

5.1 Pre-Installation Checklist

• Verify product model and door size compatibility with your RV.
• Ensure adequate ventilation around the installation area.
• Gather necessary tools (screwdriver, wrench, sealant, etc.).
• Confirm gas and water supply lines are accessible and can be shut off.

5.2 Installation Steps

The following steps outline the general installation process. For detailed visual guidance, please refer to the installation video below.

Video 1: Installation guide for replacing a Suburban Storage Water Heater with a FOGATTI RV Gas Water Heater.

Step 1: Disconnect Old Unit

• Turn off the RV's main power supply and the water heater's power switch.
• Close the main water valve and the gas valve.
• Open the exterior access panel of the old water heater.
• Disconnect electrical wiring (refer to your old unit's wiring diagram for specific connections).
• Disconnect water inlet and outlet pipes.
• Open the pressure relief valve to drain water and relieve pressure.
• Remove mounting screws and carefully extract the old water heater unit.

Step 2: Install New FOGATTI InstaShower 9 Pro

• Carefully slide the new FOGATTI InstaShower 9 Pro into the existing opening.
• Secure the unit to the RV wall using appropriate screws and seal the edges with butyl tape to prevent leaks.
• Connect the cold water inlet pipe (typically blue hose) and hot water outlet pipe (typically red hose).
• Connect the gas inlet pipe.
• Connect the RV gas water heater DC power cord positive (black wire) to the power positive (red wire) at position #1 as per the wiring diagram.
• Connect the RV gas water heater DC power cord negative (white wire) to the power negative (black wire) in position #3 as per the wiring diagram.
• Pass the wire controller connection wire through the designated hole.
• Remove the wire controller bottom cover, secure it, and place insulating film over screws.
• Install the line controller to the bottom cover.
• Pull the cord of the line controller to the product, connect it to the cord of the product.

Step 3: Post-Installation Checks

• Open the gas valve and perform a gas seal test using soapy water to check for leaks. Bubbles indicate a leak.
• Open the inlet and outlet water valves.
• Rehydrate the product and empty internal air. Simultaneously carry out a sealing test on water connections.
• Turn on the product power switch to start the product.

5.3 Door Size Compatibility

The FOGATTI InstaShower 9 Pro is designed for versatile installation. It comes with a 15"x15" door. Depending on your existing RV water heater's cut-out, you may need a different door size for a seamless replacement.

• For replacing old tankless RV water heaters and some 6-gallon water heaters, the included 15"x15" door is often suitable.
• To replace a 6-gallon tank water heater, an additional purchase of a 15"x18" door may be required.
• To replace a 10/12-gallon tank water heater, an additional purchase of an 18"x18" door may be necessary.

Video 2: Demonstration of Fogatti door exchange for different RV water heater sizes.

6. Operating Instructions

6.1 Remote Controller Functions

The FOGATTI InstaShower 9 Pro is operated via a wired remote controller. Familiarize yourself with its functions:

• Power Button: Press to turn the unit ON or OFF.
• Up/Down Arrows: Use these buttons to adjust your desired water temperature.
• °F/°C Priority Button: Toggles the temperature display between Fahrenheit and Celsius. Press and hold to activate priority mode for continuous hot water supply.

6.2 Initial Startup

• After successful installation, ensure all connections are secure and leak-free.
• Turn on the RV's main power and the water heater's power switch.
• Open the gas and water supply valves.
• Turn on the FOGATTI InstaShower 9 Pro using the remote controller.
• Set the desired water temperature. The unit will begin heating water instantly as flow is detected.

6.3 Water Flow and Temperature

• The unit provides hot water at up to 3.6 GPM.
• For optimal performance, avoid excessive mixing of hot and cold water at the faucet, as this can affect the unit's ability to maintain a consistent temperature.
• The built-in mixing tank helps buffer temperature fluctuations, providing a more stable bathing experience.

7. Maintenance

7.1 Regular Checks

• Periodically inspect gas and water connections for any signs of leaks or corrosion.
• Clean the exterior of the unit and the exhaust vent to ensure proper airflow and prevent blockages.
• Check the water inlet filter screen for debris and clean as needed to maintain optimal water flow.

7.2 Winterization (Anti-Freezing Protection)

• The FOGATTI InstaShower 9 Pro features built-in anti-freezing protection. This system activates automatically when temperatures drop to prevent damage.
• For extended periods of non-use in freezing temperatures, it is highly recommended to drain the water heater completely to prevent potential damage.
• Consult your RV's manual for specific winterization procedures for your entire water system, including water lines and tanks.

8. Troubleshooting

8.1 Common Issues and Solutions

9. Warranty and Support

9.1 Warranty Information

FOGATTI products are backed by a manufacturer's warranty. For detailed warranty terms and conditions, including coverage period and limitations, please refer to the warranty card included with your product packaging or visit the official FOGATTI website.

9.2 Customer Support

For technical assistance, troubleshooting guidance beyond this manual, or to initiate a warranty claim, please contact FOGATTI customer support. When contacting support, please have the following information readily available:

• Product Model Number: FS10B1S
• Date of Purchase
• A detailed description of the issue you are experiencing