True TBB-2G-HC-LD

True TBB-2G-HC-LD Commercial Back Bar Refrigerator User Manual

Model: TBB-2G-HC-LD

1. Introduction

This manual provides essential information for the safe and efficient operation, installation, and maintenance of your True TBB-2G-HC-LD Commercial Back Bar Refrigerator. Please read all instructions carefully before using the appliance to ensure proper function and longevity.

The True TBB-2G-HC-LD is a two-section back bar refrigerator designed for commercial use, featuring two swinging glass doors, a black exterior, and operating on 115V power. It is capable of holding up to 88 six-packs of 12-ounce cans or two half-barrel kegs, maintaining temperatures between 33°F and 38°F using R290 hydrocarbon refrigerant.

2. Safety Information

WARNING: To reduce the risk of fire, electric shock, or injury, always follow basic safety precautions.

  • Ensure the unit is connected to a properly grounded 115V/60Hz/1ph electrical outlet with a NEMA 5-15P plug. Do not use extension cords.
  • Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
  • Keep ventilation openings in the appliance enclosure or in the built-in structure clear of obstruction.
  • Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.
  • Do not damage the refrigerant circuit.
  • Only qualified service personnel should perform repairs.
  • This appliance is heavy (approximately 395 lbs). Use appropriate lifting techniques and equipment during installation to prevent injury.

3. Unpacking and Installation

3.1 Unpacking

  1. Carefully remove all packaging materials, including tape and protective film.
  2. Inspect the refrigerator for any shipping damage. Report any damage immediately to the carrier and your dealer.
  3. Remove any internal packing materials and accessories.

3.2 Location and Placement

Select a location that is level, stable, and strong enough to support the unit's weight (395 lbs) when fully loaded. Ensure adequate air circulation around the unit.

  • Dimensions: 58 7/8" W x 29 7/8" D x 37" H. Allow sufficient clearance for door swing and ventilation.
  • Avoid direct sunlight or proximity to heat-generating appliances.
  • Ensure the unit is level using a spirit level and adjusting the feet if necessary.

3.3 Electrical Connection

The unit requires a dedicated 115V/60Hz/1ph electrical supply with a 2.8 amp draw and a NEMA 5-15P plug. Do not use adapters or extension cords. Consult a qualified electrician if you are unsure about your electrical supply.

3.4 Initial Cleaning

Before first use, clean the interior and exterior surfaces with a mild detergent and warm water. Rinse thoroughly and dry completely.

4. Operation

4.1 Powering On

After installation and initial cleaning, plug the unit into the dedicated electrical outlet. The compressor will start, and the interior LED lighting will illuminate.

4.2 Temperature Control

The unit is designed to maintain temperatures between 33°F and 38°F. Temperature adjustments are typically managed by a factory-set thermostat. Refer to the digital thermometer for current internal temperature.

4.3 Loading the Refrigerator

The refrigerator can hold up to 88 six-packs of 12-ounce cans or two half-barrel kegs. It features four black PVC-coated shelves, adjustable in 1/2-inch increments, to accommodate various product sizes.

True TBB-2G-HC-LD Commercial Back Bar Refrigerator with two glass doors displaying beverages
Figure 1: Front view of the True TBB-2G-HC-LD Commercial Back Bar Refrigerator. This image shows the unit with its two glass doors, revealing multiple shelves stocked with various bottled and canned beverages. The black exterior and stainless steel countertop are visible.

4.4 Door Features

  • Glass Doors: Double-pane thermal glass provides visibility of products while maintaining insulation.
  • Magnetic Gaskets: Ensure a tight seal to prevent cold air loss.
  • Door Locks: For securing contents.
  • Threshold Protector: Prevents damage to the cabinet when loading or unloading heavy items like kegs.

5. Maintenance and Cleaning

5.1 Regular Cleaning

  • Interior: Clean the stainless steel interior floor and walls regularly with a mild, non-abrasive cleaner and warm water. Rinse and dry thoroughly to prevent odors and maintain hygiene.
  • Exterior: Wipe down the black laminate vinyl exterior and stainless steel countertop with a damp cloth and mild detergent. Avoid abrasive cleaners that could damage the finish.
  • Glass Doors: Use a glass cleaner for streak-free visibility.
  • Door Gaskets: Inspect and clean door gaskets regularly to ensure they are free of debris and maintain a proper seal. Replace worn or damaged gaskets promptly.

5.2 Condenser Coil Cleaning

The unit features a reverse condensing fan motor that helps remove debris from the condensing coil. This mechanism activates for 20 seconds each time the compressor turns on, directing air towards the coil to dislodge dirt and dust. While this reduces buildup, regular manual inspection and cleaning are still recommended for optimal efficiency.

  1. Disconnect power to the unit before cleaning.
  2. Access the refrigeration system by removing the front grille and sliding it out.
  3. Use a stiff brush or vacuum cleaner to remove any remaining dust and debris from the condenser coil fins.
  4. Reinstall the grille and restore power.

6. Troubleshooting

Before contacting service, review the following common issues and solutions:

ProblemPossible CauseSolution
Unit not coolingNo power; thermostat set too high; condenser coil dirty; door left ajar.Check power connection and circuit breaker; verify thermostat setting; clean condenser coil; ensure doors are fully closed.
Excessive noiseUnit not level; fan obstruction; loose components.Level the unit; check for obstructions around fan blades; contact service if noise persists.
Water on floor (leaking)Drain line clogged; excessive humidity.Clear drain line; ensure doors are not left open frequently.
Doors not sealing properlyGaskets dirty or damaged; unit not level.Clean or replace gaskets; level the unit.

If troubleshooting steps do not resolve the issue, contact qualified service personnel.

7. Specifications

FeatureSpecification
ModelTBB-2G-HC-LD
BrandTrue
Dimensions (W x D x H)58 7/8" x 29 7/8" x 37" (1494 mm x 759 mm x 940 mm)
Item Weight395 lbs
Capacity88 six-packs (12-oz cans) or 2 half-barrel kegs / 15.5 Gallons
Number of Doors2 (Swinging Glass Doors)
Shelves4 (Black PVC-coated, adjustable in 1/2" increments)
RefrigerantR290 Hydrocarbon
Temperature Range33°F to 38°F
Electrical115V/60Hz/1ph, 2.8 Amps, 1/4 HP
Plug TypeNEMA 5-15P
Exterior FinishBlack Laminate Vinyl
Interior FinishStainless Steel Floor, Galvanized Interior
InsulationFoamed-in-place polyurethane
Special FeaturesLED Interior Lighting, Door Locks, Scratch Resistant, Frost Free Defrost

Elevation diagram of True TBB-2G-HC-LD refrigerator
Figure 2: Elevation diagram providing front view dimensions of the True TBB-2G-HC-LD refrigerator in inches and millimeters. Key measurements include overall width (58 13/16"), height (37"), and the 3" clearance from the floor.

Plan view diagram of True TBB-2G-HC-LD refrigerator
Figure 3: Plan view diagram illustrating the top-down dimensions of the True TBB-2G-HC-LD refrigerator. It shows the depth (28 13/16") and the swing radius of the two doors when fully open.

8. Warranty and Support

8.1 Warranty Information

This True TBB-2G-HC-LD refrigerator comes with a 7-year Parts & Labor warranty and a 7-year Compressor warranty. Please retain your proof of purchase for warranty claims. The warranty covers defects in materials and workmanship under normal use and service.

8.2 Customer Support

For technical assistance, service requests, or warranty inquiries, please contact your authorized True Refrigeration dealer or the manufacturer's customer service. Have your model number (TBB-2G-HC-LD) and serial number ready when contacting support.

Related Documents - TBB-2G-HC-LD

Preview True SPEC SERIES® Roll-In Glass Swing Door Refrigerator | STR, STA, STG Models
Detailed overview of the True SPEC SERIES® Roll-In Glass Swing Door Refrigerator, including features, specifications, and model variations (STR1RRI-1G-HC, STA1RRI-1G-HC, STG1RRI-1G-HC) for commercial foodservice applications.
Preview True GDM-05PT-S-HC~FGD01 Glass Door Merchandiser Refrigerator Spec Sheet
Explore the specifications and features of the True GDM-05PT-S-HC~FGD01 Glass Door Merchandiser Refrigerator. This unit offers efficient R290 hydrocarbon refrigeration, stainless steel construction, LED lighting, and a pass-thru design for commercial foodservice applications.
Preview True GDM-19T-HC~TSL01 Glass Door Merchandiser: Features, Specifications, and Dimensions
Comprehensive details on the True GDM-19T-HC~TSL01 glass door merchandiser, a self-contained unit featuring R290 hydrocarbon refrigerant, LED lighting, and robust construction. Includes technical specifications, dimensions, warranty information, and optional accessories for commercial food service.
Preview True T-49G-HC~FGD01 Reach-In Glass Swing Door Refrigerator - Features & Specifications
Detailed information on the True T-49G-HC~FGD01, a 49 cu ft reach-in glass door refrigerator featuring hydrocarbon refrigerant, energy efficiency, and durable construction for food service applications.
Preview True Mega-Top Solid Door Sandwich/Salad Units with Hydrocarbon Refrigerant - TSSU Series
Comprehensive specifications and features for True Manufacturing's Mega-Top Solid Door Sandwich/Salad Units (TSSU series), highlighting their R290 hydrocarbon refrigerant, durable construction, and NSF compliance for commercial food service applications.
Preview TRUE Temperature Controls Sequence of Operation Manual
Detailed sequence of operation for TRUE Manufacturing mechanical temperature controls, covering startup, diagnosis, troubleshooting, and adjustment procedures for refrigerators, freezers, and coolers. Includes technical specifications and wiring diagrams.