Introduction
The Coast Slayer RED is a versatile and durable LED flashlight designed for various lighting needs. It features a dual optic system, multiple light modes including a red beam and MoonGlow™, USB-C recharging, and a robust aluminum construction. This manual provides detailed instructions for its proper use and maintenance.
The Coast Slayer RED flashlight, highlighting its sleek design and brand.
Setup
Charging the Flashlight
The Slayer RED flashlight is equipped with a built-in ZITHION™ rechargeable battery and a USB-C charging port. Before first use, fully charge the flashlight.
- Locate the USB-C charging port on the flashlight.
- Connect the provided USB-C cable to the flashlight's port and the other end to a compatible USB power source (e.g., wall adapter, computer USB port).
- The charge level indicator will illuminate during charging. It typically charges in under two hours.
- When fully charged, the indicator light will turn green. Disconnect the cable.
The USB-C charging port and indicator light on the Coast Slayer RED flashlight.
Informational video demonstrating the features and operation of the Coast Slayer RED flashlight, including its USB-C charging capability.
Operating Instructions
The Slayer RED features a Dual Optic system with separately controlled spot and red beams, offering five distinct light modes.
Diagram illustrating the key features of the Coast Slayer RED flashlight, including buttons and components.
White Light Operation (Spot Beam)
Use the forward power button to cycle through the white light modes:
- High Spot: Provides maximum brightness (1000 lumens in Turbo mode, 530 lumens in High).
- Low Spot: Offers reduced brightness for extended runtime (110 lumens).
- Turbo Mode: Delivers the highest output of 1000 lumens for short bursts.
- MoonGlow™ Mode: An ultra-low energy eco beam (10 lumens) ideal for blackout conditions and extended runtimes (up to 55 hours).
Illustration of the Bulls-Eye Spot beam pattern, showing a bright center with a wide halo.
Red Light Operation
The rear button controls the red beam. Press the rear button to switch the red beam on and off. The red beam is suitable for low-light situations where preserving night vision or discreet illumination is required.
The Coast Slayer RED flashlight emitting its red beam, useful for maintaining night vision.
Magnetic Mount
The flashlight features two integrated magnets at the front and back of the handle. These allow for hands-free lighting by attaching the flashlight to metallic surfaces.
The dual-magnet base of the Coast Slayer RED flashlight, demonstrating its ability to attach to metal surfaces.
Pocket Clip
A removable metal pocket clip is included for secure carrying. Attach or remove the clip as needed for convenience or a more streamlined profile.
The removable pocket clip on the Coast Slayer RED flashlight, shown securing it to fabric.
Maintenance
Cleaning
To maintain optimal performance, keep the flashlight clean. Wipe the exterior with a soft, damp cloth. Avoid using abrasive cleaners or solvents that could damage the finish or internal components.
Battery Care
The integrated ZITHION™ rechargeable battery requires no special maintenance beyond regular charging. For long-term storage, it is recommended to charge the battery to approximately 50% every few months to preserve its lifespan.
Water and Dust Resistance
The Slayer RED is rated IP57 for dust and water resistance. This means it is protected against dust ingress and can withstand immersion in water up to 1 meter for 30 minutes. Ensure the USB-C port cover is securely closed to maintain water resistance.
The Coast Slayer RED flashlight demonstrating its IP57 storm and dust proof rating.
Troubleshooting
- Flashlight not turning on: Ensure the battery is charged. Connect the flashlight to a USB-C power source and check if the charging indicator lights up.
- Dim light output: The battery may be low. Recharge the flashlight. If the issue persists after charging, contact customer support.
- Charging issues: Verify that the USB-C cable is properly connected to both the flashlight and the power source. Try a different USB-C cable or power adapter. Ensure the charging port is clean and free of debris.
- Red light not working: Ensure you are pressing the correct (rear) button for the red light. If the white light functions but the red light does not, contact customer support.
Specifications
Table illustrating the different light modes, lumens, beam distance, and runtimes for the Coast Slayer RED.
| Feature | Detail |
|---|---|
| White Brightness | 1000 Lumens (Turbo) |
| Light Path Distance | 110 Meters |
| Runtime | Up to 55 hours (MoonGlow™) |
| Power Source | Battery Powered (Lithium Ion, rechargeable via USB-C) |
| Material | Aluminum |
| Water Resistance Level | IP57 (Water Resistant) |
| Special Features | Adjustable Light Modes, Rechargeable, Red Mode, MoonGlow™ Mode, Magnetic Mount, Removable Pocket Clip |
| Dimensions (L x W x H) | 5.51" x 0.79" x 0.79" |
| Weight | 0.48 Pounds |
| Model Number | 31014 |
Warranty and Support
The Coast Slayer RED flashlight is backed by the COAST Lifetime Warranty. This warranty covers defects in materials and workmanship for the lifetime of the original owner. For warranty claims or technical support, please refer to the official Coast website or contact their customer service directly.
Included Components: USB-C Cable