1. Introduction
This manual provides essential information for the safe and effective use of your GILAYGROW WDC901 Waterproof Underwater Camera battery. Please read this manual thoroughly before using the battery to ensure optimal performance and longevity.
The GILAYGROW WDC901 camera battery is a Lithium Polymer battery designed specifically for the GILAYGROW WDC901 Waterproof Underwater Camera, enabling extended use for activities such as snorkeling and general photography.
Image 1.1: The GILAYGROW WDC901 Camera Lithium Polymer Battery. This image displays the battery's specifications including '3.7v 700mAh Li-ion' and a warning to 'Use specified charger only'.
2. Safety Information
Adhering to the following safety guidelines is crucial for preventing damage to the battery, camera, and personal injury:
- Use only the charger specified by GILAYGROW for this battery. Using an incompatible charger may cause fire, explosion, or other hazards.
- Do not disassemble, crush, puncture, or short-circuit the battery.
- Keep the battery away from excessive heat, direct sunlight, and open flames. Temperatures above 60°C (140°F) can cause damage or explosion.
- Do not expose the battery to water or other liquids. If the battery gets wet, do not use it.
- Keep batteries out of reach of children and pets.
- Dispose of batteries properly according to local regulations. Do not dispose of batteries in household waste.
3. Battery Installation
To install the battery into your GILAYGROW WDC901 Waterproof Underwater Camera:
- Ensure the camera is powered off.
- Locate the battery compartment on the camera. For the WDC901, this is typically on the side or bottom, secured by a latch or screw for waterproofing.
- Open the battery compartment cover carefully. Ensure the rubber seal is clean and free of debris.
- Insert the Lithium Polymer battery into the compartment, aligning the contacts correctly with the camera's terminals. The battery is designed to fit in only one orientation.
- Close the battery compartment cover firmly until it clicks into place, ensuring it is completely sealed to maintain the camera's waterproof integrity.
Image 3.1: The GILAYGROW WDC901 Waterproof Underwater Camera. This image illustrates the camera for which the battery is intended, highlighting its waterproof design.
4. Charging the Battery
To charge your GILAYGROW WDC901 camera battery:
- Remove the battery from the camera if it is not designed for in-camera charging, or connect the camera to the charger if it supports in-camera charging. Refer to your camera's specific manual for charging methods.
- Connect the battery to the GILAYGROW-supplied charger.
- Plug the charger into a suitable power outlet.
- Observe the charging indicator light on the charger or camera. This light typically turns red during charging and green when charging is complete.
- Once fully charged, disconnect the charger from the power outlet and the battery/camera.
Note: A new battery may not be fully charged and should be charged before first use. Initial charging times may vary.
5. Operating Guidelines
For optimal battery performance during camera operation:
- Ensure the battery is fully charged before extended use, especially for underwater activities.
- Battery performance can be affected by extreme temperatures. Avoid using the camera and battery in very cold or very hot environments for prolonged periods.
- If the camera indicates low battery, charge the battery as soon as possible to avoid interruption during use.
6. Maintenance
Proper maintenance extends battery life:
- Storage: If storing the battery for an extended period, charge it to approximately 50-60% capacity. Store in a cool, dry place away from direct sunlight and extreme temperatures.
- Cleaning: Periodically clean the battery contacts with a clean, dry cloth to ensure good connection with the camera.
- Avoid Deep Discharge: Do not allow the battery to completely drain for prolonged periods, as this can reduce its overall lifespan.
7. Troubleshooting
Common issues and their solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Battery not charging | Charger not connected properly; Faulty charger; Damaged battery; Incorrect power source. | Ensure secure connections; Try a different power outlet; Contact customer support if charger or battery is suspected faulty. |
| Camera not powering on with battery | Battery not inserted correctly; Battery fully discharged; Battery contacts dirty; Faulty battery. | Re-insert battery, ensuring correct orientation; Charge the battery; Clean battery contacts; Test with a known good battery if available. |
| Short battery life | Battery not fully charged; Old battery; Extreme operating temperatures; High power consumption settings on camera. | Ensure full charge before use; Consider battery replacement if old; Avoid extreme temperatures; Adjust camera settings (e.g., screen brightness). |
8. Specifications
| Feature | Detail |
|---|---|
| Battery Type | Lithium Polymer |
| Voltage | 3.7V |
| Capacity | 700mAh |
| Item Weight | 0.704 ounces (approx. 20 grams) |
| Package Dimensions | 7.8 x 5.43 x 0.71 inches |
| Recommended Use | GILAYGROW WDC901 Waterproof Underwater Camera |
9. Warranty and Customer Support
GILAYGROW is committed to providing high-quality products and professional customer support.
- Replacement Policy: This product is covered by an 18-month replacement policy from the date of purchase.
- Customer Support: We offer lifetime 24-hour responsive customer support.
If you encounter any issues, have questions, or require assistance (e.g., damaged or defective item, missing accessories, item not as described, or general dissatisfaction), please contact GILAYGROW customer support through the platform where you purchased the product or via the contact information provided with your camera.
