1. Introduction
This manual provides essential information for the safe and efficient operation of your Midea MERV115T3AST 115 Cans Beverage Refrigerator. Please read it thoroughly before installation and use, and retain it for future reference.
The Midea MERV115T3AST beverage refrigerator is designed to store beverages at an optimal temperature. It features a 115-can capacity, adjustable temperature control, removable glass shelves, and LED interior lighting. The unit is equipped with a low-emissivity (Low-E) three-panel glass door to minimize cool air loss and block harmful UV rays, preserving beverage quality.
2. Safety Information
To reduce the risk of fire, electric shock, or injury when using your appliance, follow these basic precautions:
- Read all instructions before using the appliance.
- Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
- This appliance is intended for household use only.
- Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction.
- Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.
- Do not damage the refrigerant circuit.
- Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer.
- Ensure the appliance is properly grounded.
- Unplug the appliance before cleaning or performing any maintenance.
3. Setup and Installation
3.1 Unpacking
Carefully remove all packaging materials. Inspect the appliance for any damage. Report any damage to your retailer immediately.
3.2 Placement
Place the refrigerator on a flat, solid surface strong enough to support the unit when fully loaded. Allow at least 5 inches (12.7 cm) of space between the back and sides of the refrigerator and any adjacent walls to ensure proper air circulation.
3.3 Leveling
The appliance must be level for proper operation. Adjust the leveling legs at the bottom of the unit by turning them clockwise to raise or counter-clockwise to lower until the refrigerator is stable and level.
3.4 Electrical Connection
Plug the refrigerator into a dedicated, grounded 115V, 60Hz AC outlet. Do not use extension cords or adapter plugs. Ensure the electrical circuit is protected with a 15-amp or 20-amp fuse or circuit breaker.
3.5 Door Reversal (Optional)
The door hinges are reversible, allowing the door to open from either the left or right side. Refer to the detailed diagrams in the full manual for specific instructions on reversing the door swing.
4. Operating Instructions
4.1 Initial Startup
After plugging in the unit, allow it to operate for at least 2-3 hours before placing beverages inside. This allows the internal temperature to stabilize.
4.2 Temperature Control
The refrigerator features an adjustable temperature control panel. Settings typically range from 1 (warmest) to 6 (coldest). Adjust the setting according to your desired beverage temperature. The optimal temperature range for this unit is 33.8°F to 50°F (1°C to 10°C).
4.3 LED Interior Light
The interior LED light illuminates the contents of the refrigerator. It can typically be controlled via a switch located near the temperature control or automatically activates when the door is opened.
5. Care and Maintenance
5.1 Cleaning
Always unplug the refrigerator before cleaning. Clean the interior and exterior surfaces with a soft cloth and a mild detergent solution. Do not use abrasive cleaners or harsh chemicals. The glass shelves can be removed and washed with warm, soapy water.
5.2 Defrosting
This unit features manual defrost. Frost buildup on the evaporator plate is normal. When the frost layer becomes approximately 1/4 inch thick, unplug the unit and allow the frost to melt naturally. Place a towel at the bottom to absorb water. Do not use sharp objects to remove frost.
5.3 Adjustable and Removable Glass Shelves
The glass shelves can be adjusted to accommodate different sizes of bottles and cans. To adjust, simply lift the shelf slightly and slide it out. Reinsert into desired slots.
6. Troubleshooting
Review this section before calling for service. It may save you time and expense.
| Problem | Possible Cause | Solution |
|---|---|---|
| Refrigerator does not operate. | Not plugged in; circuit breaker tripped; temperature control set to 'OFF'. | Ensure plug is secure; reset circuit breaker; adjust temperature control. |
| Temperature is not cold enough. | Temperature control set too warm; door opened too frequently; unit overloaded; poor ventilation. | Adjust temperature to a colder setting; minimize door openings; do not overload; ensure adequate clearance around unit. |
| Excessive noise. | Unit not level; loose parts; items vibrating inside. | Level the unit using adjustable legs; check for loose items and secure them. |
| Door does not close properly. | Unit not level; gasket dirty or damaged; shelves out of position. | Level the unit; clean or replace gasket; ensure shelves are correctly placed. |
7. Specifications
Detailed technical specifications for the Midea MERV115T3AST beverage refrigerator:
- Model Info: MERV115T3AST
- Item Weight: 70.5 pounds
- Product Dimensions: 17.3 x 18.9 x 33.1 inches (D x W x H)
- Capacity: 3.2 Cubic Feet (equivalent to 115 cans)
- Annual Energy Consumption: 288 Kilowatt Hours Per Year
- Installation Type: Freestanding
- Form Factor: Compact
- Special Features: Adjustable Shelves, Low-E and Anti-UV Tempered Glass, LED Light
- Color: Silver
- Voltage: 115 Volts
- Racks/Shelves: 3 Glass Shelves
- Defrost System: Manual
- Door Hinges: Reversible
- Door Material Type: Stainless Steel
- Number Of Doors: 1
8. Warranty and Customer Support
For warranty information or technical assistance, please refer to the warranty card included with your product or visit the official Midea website. Keep your purchase receipt as proof of purchase for any warranty claims.
For further support, you may contact Midea customer service through their official channels. Details are typically available on the manufacturer's website or in the packaging materials.