Product Overview
The Rittal 1485.300 plastic sheet metal screws are designed for secure fastening in various interior applications. These screws are made from durable plastic, offering a lightweight and corrosion-resistant alternative to traditional metal fasteners. They are supplied in packs of 50 pieces.
Image: Two Rittal 1485.300 plastic sheet metal screws. Each screw features a wide, flat head with a hexagonal recess for driving, and a threaded shank designed for sheet metal. They are presented on a dark, reflective surface, highlighting their metallic-like finish.
Specifications
| Attribute | Detail |
|---|---|
| Model Number | 1485.300 |
| Brand | Rittal |
| Material | Plastic |
| Application | Interior applications |
| Quantity per pack | 50 pieces |
Setup and Installation
These screws are designed for straightforward installation. Ensure you have the correct driving tool for the hexagonal recess in the screw head.
- Preparation: Identify the material and thickness of the sheet metal or panel where the screw will be used. Ensure the material is suitable for plastic screws.
- Pilot Hole (Optional): For harder materials or to prevent cracking, a pilot hole slightly smaller than the screw's core diameter may be drilled.
- Driving the Screw: Insert the appropriate hexagonal driver bit into the screw head. Apply steady, even pressure while rotating the screw clockwise until it is firmly seated. Avoid over-tightening to prevent stripping the material or damaging the screw head.
- Securing: The screw should create a secure, flush, or slightly recessed fit depending on the application.
Operating Considerations
While these screws do not have "operating" functions in the traditional sense, proper handling ensures their effectiveness and longevity.
- Material Compatibility: Use these plastic screws primarily for applications where corrosion resistance is critical or where lightweight fastening is preferred. They are suitable for interior use.
- Load Bearing: Plastic screws typically have lower shear and tensile strength compared to metal screws. Do not use them in applications requiring high load-bearing capacity or structural integrity.
- Temperature Range: Avoid exposing the screws to extreme temperatures that could degrade plastic materials.
Maintenance
Rittal 1485.300 plastic sheet metal screws require minimal maintenance once installed.
- Inspection: Periodically inspect installed screws for any signs of loosening or damage, especially in applications subject to vibration or movement.
- Cleaning: If necessary, clean the screws with a soft, damp cloth. Avoid harsh chemicals that could degrade the plastic.
- Storage: Store unused screws in a cool, dry place away from direct sunlight and extreme temperatures to preserve material integrity.
Troubleshooting
Most issues related to these screws can be resolved by ensuring correct installation practices.
- Screw Not Seating Properly:
- Cause: Pilot hole too small or material too dense.
- Solution: Ensure pilot hole is appropriate size, or consider a different fastening method for very dense materials.
- Screw Head Stripping:
- Cause: Incorrect driver bit size, excessive torque, or worn driver bit.
- Solution: Use the correct hexagonal driver bit, apply appropriate torque, and replace worn bits.
- Screw Loosening Over Time:
- Cause: Vibration, material expansion/contraction, or insufficient initial tightening.
- Solution: Re-tighten if possible without over-tightening. For high-vibration environments, consider using thread-locking compounds suitable for plastic or alternative fastening methods.
Warranty and Support
For information regarding warranty terms and conditions for Rittal products, please refer to the official Rittal website or contact your local Rittal distributor. Product support and technical assistance can also be obtained through these channels.
Note: As these are consumable fastening components, specific warranties may apply to manufacturing defects rather than wear and tear from use.
Rittal Official Website: www.rittal.com
