AKOYU D12*5 Pack-US Window Alarm Instruction Manual

1. Introduction

Thank you for choosing the AKOYU D12*5 Pack-US Window Alarms. This 5-pack of magnetic sensor alarms is designed to enhance the security of your home, garage, or apartment by providing immediate alerts when windows or doors are opened. With a loud 120dB siren, these alarms are effective in deterring intruders and notifying occupants. They are also ideal for monitoring child safety around doors and windows, and can be used for pool safety (though please note important safety information regarding pool compliance).

2. Safety Information

• Loud Alarm: The 120dB siren is extremely loud. Avoid prolonged exposure to the sound, especially during setup or testing, to prevent hearing discomfort.
• Battery Safety: Use only the specified battery type (2 AAA batteries per unit, not included). Do not mix old and new batteries, or different types of batteries. Dispose of used batteries responsibly.
• Installation Surface: Ensure the installation surface is clean, dry, and smooth for optimal adhesive performance.
• Child Safety: While these alarms can aid in child safety, they are not a substitute for adult supervision. Keep alarms out of reach of small children.
• Pool Safety Note: This alarm does not meet the UL 2017 standard and will not pass pool inspections. It is intended as an additional alert system, not a primary pool safety device.

3. Package Contents

Your AKOYU D12*5 Pack-US package includes:

• 5 x Main Alarm Units
• 5 x Magnetic Strips
• 5 x Adhesive Pads (pre-applied or separate)
• 1 x Instruction Manual (this document)

4. Product Overview

Each AKOYU window alarm consists of two main parts: the main alarm unit and a smaller magnetic strip. The main unit houses the siren, battery compartment, and control switches. The magnetic strip works in conjunction with the main unit to detect opening and closing.

4.1 Components

• Main Alarm Unit: Contains the speaker, ON/OFF switch, and a 'Set' button for mode selection.
• Magnetic Strip: A smaller, passive component that triggers the alarm when separated from the main unit.
• ON/OFF Switch: Located on the side of the main unit, used to power the device on or off.
• Set Button: Located on the side of the main unit, used to cycle through the four operating modes.
• 120dB Alarm Horn: The siren that emits a loud sound when triggered.

5. Setup

5.1 Battery Installation

Each alarm unit requires 2 AAA batteries (not included).

1. Locate the battery compartment cover on the back of the main alarm unit.
2. Slide the cover open.
3. Insert 2 AAA batteries, ensuring correct polarity (+/-).
4. Close the battery compartment cover securely.

5.2 Alarm Installation

The alarms are designed for easy installation using strong adhesive pads.

1. Clean the desired installation surface (window frame, door frame, drawer, etc.) thoroughly to ensure it is free of dust and grease.
2. Peel off the protective film from the adhesive pad on the back of the main alarm unit.
3. Adhere the main alarm unit to the desired location on the door or window frame.
4. Peel off the protective film from the adhesive pad on the back of the magnetic strip.
5. Align the magnetic strip with the main alarm unit. The two parts must be placed within 0.39 inches (1 cm) of each other when the door/window is closed. Ensure the alignment marks (arrows or lines) on both parts are facing each other.
6. Adhere the magnetic strip to the moving part of the door or window, directly opposite the main alarm unit.
7. Test the installation by opening and closing the door/window to ensure the alarm triggers correctly.

6. Operating Modes

The AKOYU window alarm features four distinct operating modes, selectable via the 'Set' button. To change modes, ensure the alarm is powered on, then press the 'Set' button repeatedly until you hear the desired mode's confirmation sound.

• Intruder Alarm Mode: When the door/window opens, the 120dB siren will sound continuously for 1 minute. This mode is ideal for security.
• Entry Doorbell Mode: When the door/window opens, the alarm will emit a