Introduction
This manual provides essential information for the safe and efficient operation of your Fridgemaster 35 Pint Dehumidifier, Model FMDH35KX. This unit is designed to remove up to 35 pints (4.7 liters) of moisture per day, suitable for areas up to 3000 square feet, helping to maintain a comfortable and healthy indoor environment. Please read all instructions carefully before use and retain this manual for future reference.
Safety Information
- Always plug the dehumidifier into a grounded electrical outlet.
- Do not operate the unit with a damaged power cord or plug.
- Ensure the unit is placed on a stable, level surface to prevent tipping and water spillage.
- Maintain at least 8 inches (20 cm) of clearance around the unit for proper airflow.
- Do not block air inlets or outlets.
- Unplug the unit before cleaning or performing any maintenance.
- Do not use the dehumidifier near flammable gases or combustible materials.
- Keep children and pets away from the unit during operation.
Setup
Unpacking and Placement
Carefully remove the dehumidifier from its packaging. It is recommended to let the unit stand upright for at least 24 hours before plugging it in, especially if it was transported on its side, to allow the refrigerant to settle.
Place the dehumidifier on a firm, level surface in the area where humidity control is desired. Ensure there is adequate space around the unit for proper air circulation. Avoid placing it against walls or furniture that could obstruct airflow.
Front view of the Fridgemaster 35 Pint Dehumidifier, showing its compact design and control panel on top.
Power Connection
Plug the power cord into a dedicated, grounded 115-volt electrical outlet. Do not use extension cords or power strips.
Water Disposal Options
Your dehumidifier offers two methods for water removal:
- Manual Emptying (Bucket): The unit features a slide-out internal bucket with a 4.2-liter capacity. When the bucket is full, the unit will automatically shut off, and an indicator light will illuminate. Carefully slide out the bucket, empty the collected water, and reinsert it securely.
- Continuous Drainage: For continuous operation without manual emptying, you can connect a standard garden hose (not included) to the continuous drainage port located at the back of the unit. Ensure the hose is sloped downwards to a floor drain or suitable receptacle to allow gravity drainage.
Rear view of the dehumidifier, highlighting the air intake grille and the continuous drainage port for hose connection.
Operating Instructions
Control Panel Overview
The control panel is located on the top of the unit and features intuitive buttons and a digital display for easy operation.
Detailed view of the dehumidifier's control panel, showing buttons for Power, Mode, Timer, Fan Speed, Humidity Adjustment, and Filter Monitor indicator.
Power On/Off
Press the POWER button to turn the unit on or off.
Setting Desired Humidity Level
Use the + and - buttons to adjust the desired humidity level (relative humidity percentage) between 30% and 80%. The unit will operate until the set humidity level is reached, then cycle on and off to maintain it.
Fan Speed Selection
Press the FAN button to cycle through available fan speeds: Low, Medium, and High. Lower fan speeds result in quieter operation.
Mode Selection
Press the MODE button to select operating modes:
- Auto Dry: The unit automatically maintains a comfortable humidity level.
- Continuous: The unit runs continuously regardless of the humidity level, ideal for very damp conditions.
- Manual Set: Allows you to set a specific desired humidity level.
Timer Function
Use the TIMER button to set a delayed start or stop time for the dehumidifier, up to 24 hours.
Maintenance
Regular maintenance ensures optimal performance and extends the lifespan of your dehumidifier.
Cleaning the Air Filter
The dehumidifier is equipped with a washable filter. A CLEAN FILTER indicator light will illuminate on the control panel when it's time to clean the filter (approximately every 250 hours of operation).
- Turn off and unplug the dehumidifier.
- Locate the filter access at the back of the unit.
- Gently pull out the filter.
- Wash the filter with warm, soapy water. Rinse thoroughly and allow it to air dry completely before reinserting.
- Once the filter is clean and dry, slide it back into its slot.
- Plug in the unit and press the CLEAN FILTER button for 3 seconds to reset the indicator.
The dehumidifier with its washable air filter partially removed, illustrating the ease of access for cleaning.
Emptying the Water Bucket
When the water collection bucket is full, the EMPTY BUCKET indicator will light up, and the unit will stop operating. Carefully slide out the bucket from the front of the unit, empty the water, and slide it back in until it clicks into place. The unit will resume operation.
Cleaning the Exterior
Wipe the exterior of the dehumidifier with a soft, damp cloth. Do not use harsh chemicals or abrasive cleaners.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Dehumidifier does not turn on. | No power; power cord not fully inserted; water bucket full or not properly seated. | Check power supply; ensure cord is secure; empty and reinsert water bucket correctly. |
| No water collected. | Humidity level too low; room temperature too low; air filter clogged; continuous drainage hose blocked or improperly installed. | Adjust desired humidity setting; ensure room temperature is above 38°F (3°C); clean air filter; check continuous drainage hose for kinks or blockages. |
| Unit is noisy. | Fan speed set to high; unit not on a level surface; internal components vibrating. | Reduce fan speed; place unit on a level surface; ensure no objects are touching the unit causing vibration. |
| Airflow is restricted. | Air inlet/outlet blocked; dirty air filter. | Ensure adequate clearance around the unit; clean the air filter. |
| Unit leaks water. | Water bucket not properly seated; continuous drainage hose not securely connected or blocked. | Ensure water bucket is fully inserted; check hose connection and clear any blockages. |
Specifications
Diagram showing the dimensions of the Fridgemaster 35 Pint Dehumidifier: 23.9 cm (Depth) x 35.1 cm (Width) x 50 cm (Height).
| Feature | Detail |
|---|---|
| Model Number | FMDH35KX |
| Dehumidification Capacity | 35 Pints (4.7 Liters) per day |
| Coverage Area | Up to 3000 Square Feet |
| Water Tank Volume | 4.2 Liters |
| Noise Level (Low Fan) | 47 dB(A) |
| Operating Temperature | As low as 38°F (3°C) |
| Voltage | 115 Volts |
| Wattage | 370 Watt-hours |
| Dimensions (D x W x H) | 23.9D x 35.1W x 50H Centimetres |
| Item Weight | 14.11 kg |
| Energy Certification | Energy Star |
| Included Components | Remote Control |
Warranty and Support
Warranty Information
This Fridgemaster dehumidifier comes with a 1-year manufacturer's warranty. Please refer to your purchase documentation or contact customer support for specific terms and conditions regarding warranty claims.
Customer Support
For technical assistance, troubleshooting not covered in this manual, or warranty inquiries, please contact Fridgemaster customer support. Contact details can typically be found on the manufacturer's website or your product packaging.