1. Introduction
This manual provides essential information for the safe installation, operation, and maintenance of the Westgate LFX-LG-50-150W-50K LED Area Light Fixture. This fixture is designed for commercial outdoor applications, offering selectable wattage options (50W, 80W, 100W, 150W) and 0-10V dimming capabilities. Please read these instructions thoroughly before installation and retain this manual for future reference.
2. Safety Information
- Electrical Hazard: Installation must be performed by a qualified electrician in accordance with all national and local electrical codes. Ensure power is disconnected at the circuit breaker before installation or servicing.
- Grounding: The fixture must be properly grounded to prevent potential electrical shock.
- Voltage: Verify that the supply voltage (120-277V AC) matches the fixture's requirements.
- Handling: Do not handle the fixture with wet hands. Avoid direct eye exposure to the light source when illuminated.
- Environment: This fixture is rated for outdoor, wet location use (IP65). Do not modify the fixture or use it for purposes other than its intended design.
3. Package Contents
Carefully unpack the box and ensure all components are present and undamaged.
- Westgate LFX-LG-50-150W-50K LED Area Light Fixture (1)
4. Product Overview
The Westgate LFX-LG-50-150W-50K is a robust LED area light fixture designed for efficient outdoor illumination. It features a durable aluminum housing with a dark bronze finish and a glass shade.
Figure 4.1: Front view of the LED Area Light Fixture, highlighting the bright LED array.
Figure 4.2: Rear view of the fixture, illustrating the heat dissipation fins and the location of the wattage selection switch.
5. Setup and Installation
5.1. Pre-Installation Checks
- Ensure power is OFF at the circuit breaker.
- Confirm the mounting surface is structurally sound to support the fixture's weight (approximately 9.8 lbs).
- Gather necessary tools: screwdriver, wire strippers, electrical tape, mounting hardware (not included).
5.2. Mounting the Fixture
The fixture is designed for surface wall mounting.
- Position the fixture on the desired mounting surface.
- Mark the locations for mounting screws.
- Drill appropriate pilot holes if necessary.
- Secure the fixture firmly to the wall using suitable mounting hardware (not supplied).
5.3. Wiring Instructions
Connect the fixture to the electrical supply according to local and national electrical codes.
- Connect the black wire from the fixture to the line (hot) wire from the supply.
- Connect the white wire from the fixture to the neutral wire from the supply.
- Connect the green (or bare copper) wire from the fixture to the ground wire from the supply.
- For 0-10V dimming, connect the purple wire to the dimming positive (+) and the gray wire to the dimming negative (-) from the 0-10V dimmer control. If dimming is not used, cap these wires individually.
- Ensure all connections are secure and insulated with approved connectors.
5.4. Wattage Selection
This fixture features a selectable wattage switch, allowing adjustment to 50W, 80W, 100W, or 150W. The switch is typically located on the rear or side of the fixture (refer to Figure 4.2 for general location). Select the desired wattage setting before restoring power to the fixture.
6. Operating Instructions
Once installed and wired correctly, restore power at the circuit breaker. The fixture will illuminate at the selected wattage setting.
- Power On/Off: Control the fixture's power via the connected wall switch or circuit breaker.
- Dimming: If connected to a 0-10V dimmer, adjust the dimmer control to achieve the desired light output level.
7. Maintenance
The Westgate LED Area Light Fixture requires minimal maintenance. Always disconnect power before performing any maintenance.
- Cleaning: Periodically clean the exterior of the fixture and the glass lens with a soft, damp cloth. Do not use abrasive cleaners or solvents.
- Inspection: Regularly inspect the fixture for any signs of damage, loose wiring, or corrosion. Address any issues promptly.
8. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Fixture does not illuminate. | No power supply; incorrect wiring; faulty switch/breaker. | Check circuit breaker and wall switch. Verify wiring connections. Consult a qualified electrician. |
| Light output is too low or too high. | Incorrect wattage selection; dimmer setting. | Adjust the wattage selection switch. Adjust the 0-10V dimmer control. |
| Light flickers. | Loose wiring connection; incompatible dimmer; power fluctuations. | Check all wiring connections. Ensure dimmer is compatible with 0-10V LED fixtures. Consult an electrician. |
9. Specifications
Figure 9.1: Dimensional drawing showing the fixture's length (12-5/8"), height (12-3/8"), and depth (3-3/8").
| Attribute | Value |
|---|---|
| Brand | Westgate |
| Model Number | LFX-LG-50-150W-50K |
| Wattage Selectable | 50W, 80W, 100W, 150W |
| Brightness (Max) | 21000 lumens (at 150W) |
| Efficiency | 140 lumens/watt |
| Color Temperature | 5000K (Cool White) |
| Voltage | 120-277V AC |
| Dimming | 0-10V Dimming |
| Light Source Type | LED |
| Material | Aluminum (Housing), Glass (Shade) |
| Finish Type | Powder Coated (Dark Bronze) |
| Indoor/Outdoor Usage | Outdoor |
| Water Resistance Level | Water Resistant (IP65) |
| Mounting Type | Wall Mount (Surface Mount) |
| Product Dimensions (L x W x H) | 12.63" x 3.38" x 12.38" (32.08 cm x 8.59 cm x 31.45 cm) |
| Item Weight | 9.8 pounds (4.45 kg) |
| Life Expectancy | 70,000 hours |
10. Certifications and Features
Figure 10.1: Certifications and key features of the fixture.
- UL Listed: Certified for safety standards.
- DLC QPL Listed: DesignLights Consortium Qualified Product List, indicating high energy efficiency.
- Wet Location Rated: Suitable for outdoor use where exposed to water.
- IP65 Rated: Protected against dust ingress and low-pressure water jets from any direction.
- 0-10V Dimming: Compatible with 0-10V dimming systems for adjustable light output.
11. Warranty and Support
This Westgate LED Area Light Fixture is backed by a 7-year warranty, covering defects in materials and workmanship under normal use.
For technical support, warranty claims, or further assistance, please contact Westgate customer service. Refer to the product packaging or the official Westgate website for current contact information.
